Calibrating your JACO Superior Products JSP-013 FlowPro Digital Tire Inflator is essential for ensuring accurate tire pressure readings. Follow these steps to calibrate your inflator:
- Begin by ensuring the inflator is turned off and not connected to a tire valve stem.
- Press and hold the power button for about 3 seconds. The display should show "CAL," indicating calibration mode.
- While in calibration mode, press and hold the power button again for approximately 3 seconds until the display shows "CAL 0.00" (zero calibration).
- Connect the inflator to a reliable pressure source. This could be a calibrated pressure gauge or another known accurate tire inflator.
- Activate your pressure source and set it to a known pressure. A common value to use is 30 PSI, but any known and verified pressure is acceptable.
- Once the pressure reading stabilizes, press the power button on the JSP-013 inflator to capture its reading.
- The display will show the pressure value that the inflator is reading. Compare this value to the known pressure value from your pressure source.
- If the displayed pressure doesn't match the known pressure, adjust the calibration by using the "+" or "-" buttons to increase or decrease the reading on the JSP-013.
- Repeat steps 6 through 8 until the displayed value on the JSP-013 matches the known pressure value.
- When the calibration is complete, press and hold the power button for approximately 3 seconds to exit calibration mode.
It is good practice to periodically check and recalibrate your JACO Superior Products JSP-013 FlowPro Digital Tire Inflator for optimal performance. Refer to the user manual or contact JACO customer support if you need further assistance or if you have any issues during calibration.
