How do I assemble my LiFE WindPro Stand 65 Industrial Stand Fan?

[LydiaMarie]

Assembling your LiFE WindPro Stand 65 Industrial Stand Fan is straightforward. Here's a step-by-step guide:

1. Base and Support: Place the upright support shaft into the base. Secure it by tightening the nut clockwise at the base's bottom, using the base washer.
2. Inner Tube and Ring: Pull out the inner tube and install the ring.
3. Secure the Inner Tube: Reinsert the inner tube and fasten it using the three screws, referring to the user manual's images for correct placement.
4. Motor Shaft Alignment: Loosen the lock adjuster on the small motor shaft. Align this shaft with the slot on the inner tube. Use the long bolt and washer to secure the motor shaft to the pipe.
5. Motor Lock: Ensure the motor is securely locked to prevent any slipping.
6. Rear Protective Mesh: Position the rear protective mesh on the motor's front and align it. Insert and tighten the four screws until the mesh is locked in place.
7. Motor Shaft Rotation: Rotate the fan motor shaft until the flat surface on the shaft aligns with the 12mm position.
8. Impeller Installation: Align the mounting hole of the fan impeller with the notch (flat part) on the motor shaft, then secure it with the mounting fixture.
9. Front Mesh Assembly: Open the front protective mesh's locking clips and unscrew the fixture at its bottom. Align the upper locking clip of the front guard mesh with the center top of the rear guard mesh, and close the side and bottom locking clips. Secure the fixture at the bottom to complete the joint.

Important Safety Note: Never operate the LiFE WindPro Stand 65 unless both protective meshes are fully assembled and securely in place. Always refer to the user manual for detailed illustrations and essential safety precautions.