Adjusting the pressure set value on your SMC ZSE10 Digital Pressure Switch Vacuum/Compound Pressure is straightforward. Here's a step-by-step guide:
-
Normal Output (OUT1) Setting:
- In measurement mode, press the button once.
- The display will alternate between "P_1" and the current set value.
- Use the UP or DOWN buttons to modify the set value. The UP button increases the value, and the DOWN button decreases it. Pressing the button once changes the value by a single digit; holding the button allows continuous adjustment.
- Press the button again to confirm the "P_1" setting. The display will then alternate between "H_1" and its set value.
- Use the UP and DOWN buttons to adjust the hysteresis value (H_1).
- Press the button to complete the "H_1" setting. The display will then show "H_2" and its set value alternately.
- Use the UP and DOWN buttons to adjust the set value for H_2.
- Press the button to finalize this setting.
-
Reversed Output (OUT1) Setting:
- If you require a reversed output, the procedure is similar; just adjust the relevant parameters as needed.
-
Function Selection Mode:
- To access the function selection mode, press and hold the button for at least 2 seconds while in measurement mode. This will display [F 0].
- Select the function you wish to change by pressing the button.
- To return to measurement mode, press and hold the button for 2 seconds or longer while in function selection mode.
-
Default Settings:
- Detailed information about default settings for different functions is provided in the SMC ZSE10 Digital Pressure Switch operation manual, which can be found on the SMC website. Consult the manual for specific setting adjustments.
By following these steps, you can easily customize the pressure set value on your SMC ZSE10 Digital Pressure Switch to meet your application's requirements. Remember to consult the operation manual for detailed guidance on all features and settings.
