To ensure a secure and lasting bond when mounting your Q-TRAN LALO Linear Fixture with VHB adhesive, proper surface preparation is key. Here's a detailed guide: First, create the ideal application environment: aim for 70-100ºF with humidity at or below 50%. The minimum application temperature should be 50ºF. Maintain these conditions for 72 hours after installation for optimal bond strength. Next, focus on the cleaning process. Thoroughly clean both the back of the Q-TRAN LALO fixture and the mounting surface using a 50/50 alcohol mix. Allow the surfaces to dry completely for about 5 minutes. When applying the VHB adhesive, start by peeling back about 0.5 inches of the protective film from one end. Apply the adhesive to the surface, using firm, even pressure to avoid air bubbles. Continue peeling and adhering in small sections until the entire length is securely attached. If mounting on porous materials like wood, brick, or concrete, apply two coats of paint or primer to the surface before installing the fixture. This improves adhesion. For specific materials, consider these epoxy recommendations: For concrete, stone, cinder block, metal, and brick, use Loctite Metal and Concrete Two-Part Epoxy. If working with ABS, fiberglass, plastic, or PVC, choose Loctite Plastic Two-Part Epoxy. For tile, wood, ceramic, glass, or metal, use Loctite Clear Two-Part Epoxy. An all-purpose option is Strong Stik. By following these steps, you will create the best possible surface conditions for the VHB adhesive to bond correctly with your Q-TRAN LALO Linear Fixture.
