How can I synchronize the remote sensor with the ThermoPro TP65 base station?

[StMaci]

To sync your ThermoPro TP65 Wireless Humidity and Temperature Monitor remote sensor with its base station, follow these steps: First, place the remote sensor close to the base station. Next, insert the batteries into the remote sensor. After the batteries are installed in the base station, the RF signal icon on the display will blink for three minutes, showing it's in sync mode. If the RF signal icon stops flashing before syncing, press and hold the CHANNEL/SYNC button on the base station for three to four seconds until the RF signal icon begins flashing again. Then, wait briefly or press either the TX or RESET button located inside the battery compartment of the remote sensor. Once synchronized, the remote sensor's temperature and humidity readings will appear on the base station display. This means the synchronization is complete. Remember to repeat this process whenever you change the batteries or if the base station and remote sensor lose connection. You can register up to three remote sensors with one base station by repeating these steps for each sensor.