To adjust the hanging length of your Progress Lighting P500417 Lattimore Aged Brass Coastal Cylinder LED fixture during installation, follow these steps: First, install the chain holder onto the fixture's stem and loosely thread the hex nuts. Next, thread this assembly onto the mounting plate and secure it to the outlet box using the provided mounting screws. Then, slide the canopy over the chain holder and adjust its depth so at least 1/4 of the threaded portion is visible through the canopy hole. This is done by adjusting the fixture's stem on the mounting plate. Once adjusted, remove the canopy and tighten the top hex nut against the mounting plate and the bottom hex nut against the chain holder. Determine your desired hanging length by removing chain links. Remember, do not cut the electrical and ground wires until you've confirmed the overall length. Leave at least 6 inches of wire extending past the chain holder for easy connections. Open a chain link at one end of the chain, hook it onto the fixture's loop, and close the link. Secure the other end of the chain to the chain holder using the quick link, and thread the wires through the chain and the canopy. Strip 3/8 inch of insulation from the wire ends and connect the fixture wires to the supply wires using wire nuts. Tuck the wires into the junction box, replace the canopy, and secure it by threading the collar onto the chain holder. Finally, install the recommended wattage bulbs into the fixture's sockets. These steps ensure a properly installed and adjusted Progress Lighting fixture.
