Why does only one reversing light on the Hongqi H5 illuminate?

1 Answers
VanVanessa
07/30/25 2:14am
This is a normal phenomenon because when reversing, the driver's side visibility is hardly affected, and the brake lights and width marker lights are generally sufficient for clear observation. Precautions for reversing a car are as follows: 1. Adjust the interior rearview mirror properly. Due to differences in height, the rearview mirror needs to be adjusted in a timely manner to avoid obstructed visibility when looking directly behind. 2. Pay attention to both left and right side mirrors simultaneously. When reversing, in addition to checking the interior rearview mirror, also monitor the left and right side mirrors to prevent the vehicle from hitting other cars or objects on either side. 3. Control the vehicle speed. Novice drivers must control the speed when reversing, as this is the prerequisite for safety. Otherwise, excessive speed increases the likelihood of accidents.
Was this review help?
20
3
Share
More Forum Discussions

What is the reason for the DSTC SPORT light coming on?

It is because the sport mode that disables ESP has been enabled in the settings. If a "DSTC requires service" message appears, it means there is a fault in the ABS anti-lock braking system. Below are the specific details about the ABS system: Function of the ABS system: ABS is the vehicle's anti-lock braking system, which belongs to the active safety systems of a car. When the ABS light comes on, it indicates that the vehicle's computer has detected a fault in the ABS system. Reasons for the ABS light coming on: During normal driving, the ABS remains in a dormant state. It only activates during emergency braking, such as when braking hard at high speeds. The vehicle's computer determines when the ABS should intervene. When the ABS light comes on, it is often due to the wheel speed sensors not functioning properly. The ABS computer cannot detect the driving conditions of each wheel and cannot compare the slip amounts of the wheels, resulting in the ABS system failing to operate correctly.
14
4
Share

Should the heel move when correctly depressing the clutch?

Yes. Here are the relevant details: 1. Clutch operation method: Place the ball of your foot on the clutch pedal and press it all the way down. Keep it depressed and find the most comfortable position for the ball of your foot. Lift your leg while keeping the heel suspended, then slowly release the clutch. Note that you don't need heel support at this stage - keep the heel suspended to let your leg follow the clutch's spring force freely. When you feel the engine start to vibrate, stop releasing the clutch with the ball of your foot and quickly lower your heel. Remember this heel support position as it's precise and effective. 2. Introduction to the clutch: The clutch is located in the flywheel housing between the engine and transmission, with the clutch assembly fixed to the rear plane of the flywheel by screws. The output shaft of the clutch is the input shaft of the transmission. While driving, the driver can depress or release the clutch pedal as needed to temporarily separate or gradually engage the engine and transmission, thereby interrupting or transmitting power from the engine to the transmission. The clutch is a common component in mechanical transmission systems, allowing the drivetrain to be disconnected or connected as required.
2
2
Share

Will the car interior get flooded if the parked car is submerged in rainwater on the roadside?

If a car is parked on the roadside and gets submerged in rainwater, water may enter the interior. Below are specific symptoms indicating water ingress in vehicles: Abnormal engine oil condition: Normal engine oil colors include light yellow, brown, or transparent colorless, but it generally does not appear milky white. Pull out the dipstick to check for any milky oil-water mixture; if present, it might indicate engine water ingress. Inspect the air filter: Check the air filter and the lower housing for obvious signs of water ingress, and examine the intake pipe and intake manifold for clear traces of water. White smoke from the exhaust pipe: When there is water in the engine fuel or combustion chamber, the water is heated by the combustion heat in the cylinder, turning into steam that exits through the exhaust pipe as white smoke. If white smoke appears after the vehicle has driven through water, it is highly likely that the engine has taken in water.
9
0
Share

Can a Class C License Drive a Motorcycle?

No, a Class C license does not permit the operation of motorcycles. The types of Class C driver's licenses and their permitted vehicle categories are as follows: C1 (Small Cars): Permitted vehicles: Small and micro passenger cars, as well as light and micro cargo vehicles; light and micro special-purpose vehicles. C2 (Small Automatic Transmission Cars): Permitted vehicles: Small and micro automatic transmission passenger cars, as well as light and micro automatic transmission cargo vehicles. C3 (Low-Speed Cargo Vehicles): Permitted vehicles: Low-speed cargo vehicles. C4 (Three-Wheeled Vehicles): Permitted vehicles: Three-wheeled vehicles. C5 (Small Automatic Transmission Passenger Cars for Disabled Persons): Permitted vehicles: Small and micro automatic transmission passenger cars specifically for disabled persons (allowing individuals with left lower limb, right lower limb, or both lower limbs disabilities to drive).
13
0
Share

What are the evaluation criteria for the 2021 Subject 3 driving test?

Here are the detailed evaluation criteria for the 2021 Subject 3 driving test: Vehicle preparation: Failure to walk around the vehicle to inspect its appearance and surrounding environment results in disqualification; Not observing traffic conditions behind before opening the car door leads to disqualification. Starting off: Starting with insufficient brake air pressure results in disqualification; Starting with the door not fully closed leads to disqualification; Not observing interior and exterior rearview mirrors or turning head to check rear traffic conditions before starting results in disqualification. Straight-line driving: Inability to maintain steady direction control and straight-line movement leads to disqualification; Failure to promptly decelerate when encountering braking from the vehicle ahead results in disqualification; Not timely observing rear traffic conditions through mirrors deducts 10 points. Gear shifting operation: Failure to smoothly shift gears as instructed leads to disqualification; Mismatch between vehicle speed and gear position deducts 10 points.
5
0
Share

How long after passing the Xi'an Subject 3 test can you schedule Subject 4?

You can schedule Subject 4 approximately ten days after passing the Xi'an Subject 3 test. Below are the specific details of the new driving test regulations: Adjustment of test scheduling intervals: For obtaining a small automatic transmission vehicle driver's license, the scheduling interval for the Subject 3 test has been shortened from 30 days after passing Subject 1 to 20 days; for upgrading to a large or medium-sized passenger or truck driver's license, the Subject 3 scheduling interval has been reduced from 40 days after passing Subject 1 to 30 days. Adjustment of cross-regional subject test attempts: For small vehicle driver's license applications, the number of times applicants can request to change the test location has been increased from once to no more than three times, catering to the public's need for cross-regional testing. Reduction of proxy materials: If applicants cannot promptly handle license replacement or renewal procedures and other traffic management services, they can authorize others to do so via the Traffic Management 12123 platform without the need for a paper power of attorney.
11
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.