Which button unlocks the trunk in an automatic transmission car?

How to adjust the WP12 in-cylinder brake valve?

The specific method for adjusting the WP12 in-cylinder brake valve is as follows: 1. Turn the engine until the first cylinder piston is at the firing top dead center position. 2. Adjust the intake valves of cylinders 1, 2, and 4. Loosen the intake valve lock nut and the intake valve adjustment bolt. Insert a 0.40mm feeler gauge between the valve bridge and the adjustment screw. 3. Rotate the adjustment screw to set the clearance to (0.40±0.06)mm. Then, tighten the lock nut using a torque wrench with a torque of (45±5) N.m. 4. Loosen the EVB bracket lock nut. 5. Rotate the EVB bracket adjustment screw to press the small piston until it is fully compressed (be careful not to open the valve). 6. Insert a 0.60mm feeler gauge between the exhaust valve adjustment screw and the middle plane of the valve bridge. Adjust the exhaust valve clearance and lock screw to set the exhaust valve clearance to (0.60±0.06)mm. Tighten the adjustment nut with a torque of (45±5) N.m. 7. Repeat the above steps to sequentially adjust the intake valve clearance for cylinders 3, 5, and 6, and the exhaust valve clearance for cylinders 2, 4, and 6.

101

Share

Is there a traffic restriction for non-local license plates in Beijing?

Beijing imposes traffic restrictions on non-local license plates. The restrictions for non-local passenger vehicles apply only to the main roads of the Second Ring Road, while the auxiliary roads of the Second Ring Road and the sections under its overpasses are not subject to these restrictions. If you are driving a non-local passenger vehicle and need to go near the Second Ring Road, you can normally use the auxiliary roads as long as you avoid the morning and evening rush hours on weekdays and the periods with tail number restrictions. Below are the penalties for violating the traffic restrictions with a non-local license plate in Beijing: 1. For non-local motor vehicles from other provinces, autonomous regions, or municipalities without an entry permit entering roads within the Sixth Ring Road (excluding the Sixth Ring Road itself), this will be considered a violation of the "motor vehicle violating the prohibition sign instructions" and will result in a fine of 100 RMB and 3 penalty points. 2. For non-local passenger vehicles with an entry permit, driving within the Fifth Ring Road (including the Fifth Ring Road) from 7:00 to 9:00 and 17:00 to 20:00 on weekdays will be considered a violation of the "motor vehicle violating the prohibition sign instructions" and will result in a fine of 100 RMB and 3 penalty points. Violating the tail number restrictions during off-peak hours will be considered a "violation of traffic restriction regulations" and will result in a fine of 100 RMB.

120

Share

What are the differences between Dongfeng Venucia D60 and Sylphy?

Dongfeng Venucia D60 and Sylphy have the following differences: 1. Different brands, one belongs to a domestic brand, and the other belongs to a joint venture brand. Dongfeng Venucia D60 is the latest compact model under Dongfeng Venucia. 2. There are also significant differences in the design of the exterior and interior. Sylphy adopts the new family design language consistent with the Teana, completely transforming from its previous moderate and stable image into a handsome young look. 3. The configuration of Venucia D60 is also higher than that of Nissan Sylphy. Sylphy is equipped with LED headlights, leather steering wheel, faux leather seats, rear center armrest, keyless entry, rearview camera, and front side airbags, etc. It is powered by Nissan's engine technology.

103

Share

How to Install the Timing Belt on a Qashqai?

The installation method for the Qashqai timing belt is as follows: 1. Align the mark on the camshaft timing gear with the mark on the valve cover, and align the mark on the crankshaft timing gear with the mark on the front cover; then install the timing belt in sequence. 2. Loosen the pulley and installation bolts, compress the automatic tensioner push rod to the lowest position, insert a steel pin into the hole, adjust the pulley with a snap ring plier, rotate counterclockwise to make the two adjustment holes on the pulley parallel to the ground, tighten the fixing bolts, and pull out the steel pin. 3. Rotate the crankshaft clockwise twice to check if the timing marks are correctly aligned. If aligned, the installation is complete.

111

Share

How often should the transmission fluid be changed for a Cruze?

Generally, the automatic transmission fluid (ATF) in a car should be changed every two years or every 40,000 kilometers. However, this depends on the vehicle model, as different models have different requirements. For Japanese models, it is recommended to change the ATF every 40,000 to 80,000 kilometers. Vehicles that frequently drive at high speeds are advised to change the ATF approximately every 40,000 kilometers. Below is more relevant information: 1. Automatic transmission fluid cannot be completely drained using atmospheric pressure, which only removes about half of the used fluid. The remaining fluid, along with sludge and impurities, can accumulate in the valve body, torque converter, and cooling lines, leading to blockages in the system's internal passages. 2. Over 99% of automatic transmission failures are caused by overheating and prolonged use of ATF without replacement, leading to the buildup of impurities. Additionally, it is important to check whether the transmission pan is deformed or if there are any leaks in the transmission lines.

117

Share

What are the differences between Hyundai Tucson and IX35?

The specific differences between Hyundai Tucson and IX35 are as follows: 1. In terms of exterior configuration, the Hyundai Tucson has one more panoramic sunroof than the IX35. 2. In terms of safety features, the IX35 is equipped with front and rear head airbags, tire pressure monitoring system, lane departure warning, active braking, and fatigue driving reminder, while the Hyundai Tucson does not have these configurations. 3. In terms of control features, the IX35 has front parking radar and cruise control. 4. In terms of power, the IX35 is equipped with a 2.0L naturally aspirated engine, while the Tucson is equipped with a 1.6T turbocharged engine.

107

Share

Which button unlocks the trunk in an automatic transmission car?

How to adjust the WP12 in-cylinder brake valve?

Is there a traffic restriction for non-local license plates in Beijing?

What are the differences between Dongfeng Venucia D60 and Sylphy?

How to Install the Timing Belt on a Qashqai?

How often should the transmission fluid be changed for a Cruze?

What are the differences between Hyundai Tucson and IX35?

Why was the Roewe e950 discontinued?

How to distinguish between camshaft bearing caps e and i?

What does a three-cylinder engine mean?

Why is there water dripping under the car chassis after the engine is turned off?