
The air filter of the MG6 is located on the passenger side within the engine compartment. After opening the engine hood, you can see a black box on the passenger side. Opening this box will reveal the air filter. The air filter is a crucial component of the engine's intake system, responsible for filtering out dirt and particulate matter from the air. Without an air filter, these contaminants could enter the engine. The MG6 is the first mass-produced model based on SAIC MG's 'Emotional Dynamics' concept car, EMotion. In terms of body dimensions, it measures 4704mm in length, 1848mm in width, 1466mm in height, with a wheelbase of 2715mm.

















I've been repairing cars for over a decade, and the air filter location on the MG6 is quite classic—it's right there in the engine bay. When you pop the hood, look toward the front-left side, and you'll spot a black rectangular plastic box connected to the intake duct. Typically secured with four or five clips, you can simply pry it open to reveal the pleated filter inside. DIY replacement is pretty straightforward, but remember to ensure the engine is off and cooled down before handling. The filter should be replaced about once a year or every 10,000 kilometers—more frequently if you often drive on dusty roads, as it's responsible for filtering out airborne contaminants before they enter the engine, much like how a mask works for us. Regular replacement helps maintain fuel efficiency and engine performance.

Last time I helped my brother replace the air filter on his MG6, I found it located at the front left side of the engine bay. The black plastic box is quite noticeable - a rectangular one with a bellows connector. Just press the clips to open the lid. The filter element is made of accordion-folded paper material. You'll realize how dirty it is when comparing it with the new filter. Remember to align the airflow direction arrow during installation - installing it backwards affects filtration efficiency. No tools are needed for the whole process, even girls can handle it. But avoid doing this right after turning off the engine to prevent burns. Don't overlook this small component during regular , as it directly affects the engine's breathing quality.

MG6 owners can replace the air filter themselves by locating the black square box in the front-left section of the engine bay. The box is connected to a thick intake pipe, and the cover is secured with several plastic clips. For older vehicles, the clips may become brittle, so handle them gently. When installing the new filter, ensure the edges are properly sealed. This component is crucial for maintaining clean engine intake air, especially in dusty areas where more frequent replacements are necessary. After replacement, you'll notice a noticeably lighter throttle response. The manual recommends changing it every 10,000 kilometers, but the actual frequency depends on your driving environment.

Changing the air filter for the MG6 is particularly simple. Open the engine hood, and the black rectangular box on the left is the air filter housing. Press the clips on both sides to open the cover and pull out the yellowed old filter. Pay attention to the direction when installing the new filter, as there is an arrow indicator inside the box. I usually opt for an activated carbon composite filter for better filtration. Avoid working during dusty weather to prevent debris from falling into the intake pipe. Perform a simple check every month; if the filter doesn’t feel stiff when pinched, it can still be used. The money saved on is enough to fill half a tank of gas.

The air filter location of the MG6 is quite well-designed, positioned in the black cubic box on the left side of the engine bay. The snap-on top cover design facilitates , unlike some cars that require screw removal. For DIY replacement, it's advisable to record a video of the original wiring routing—I accidentally displaced the intake pipe during my first attempt. The air filter acts as the engine's lungs; clogging can lead to a sharp increase in fuel consumption. Coastal city drivers should be wary of mold growth, and replacing it before the rainy season yields better results. Despite being a small component, choosing the OEM size ensures a perfect fit during installation.


