···
Log in / Register

Where is the fuse box located in the BYD F3?

6Answers
PaigeRose
09/04/2025, 03:53:11 AM

The fuse box in the BYD F3 is located next to the battery in the engine compartment, and another one is inside the glove box on the left side of the steering wheel. The principle of a fuse is: 1. To connect the circuit in an electrical system; 2. Under abnormal conditions, the fuse acts as a safety protection component in the circuit, safely cutting off and protecting the circuit by melting itself. Taking the 2020 classic BYD F3 as an example, its body dimensions are: 4533mm in length, 1705mm in width, and 1490mm in height, with a wheelbase of 2600mm, a fuel tank capacity of 50 liters, and a minimum ground clearance of 170mm.

Was this review help?
104
Share
MacChristopher
09/16/2025, 04:40:53 AM

My BYD F3 has two fuse box locations. One is in the engine compartment, visible when you open the hood, located at the front left corner near the windshield. The other is below the steering wheel on the driver's side, accessible by gently prying open the left cover panel. I'd advise against casually tampering with the one in the engine compartment yourself, as there are many wires and it's easy to make a mistake. I remember a friend's car had non-functioning headlights once, and it turned out to be a blown small fuse in the engine compartment fuse box – it was fixed after getting someone to replace it. If you're checking, it's best to wear gloves, and keeping a few spare fuses in the car is quite handy.

Was this review help?
11
Share
Expand All
DelAmara
10/30/2025, 10:26:02 PM

When I drove the F3 before, I checked the fuse box locations. The one on the left side of the steering wheel can be seen by crouching at knee level, and the cover can be pulled open by hand. The one in the engine compartment is next to the battery, towards the front windshield. Here’s a small tip for replacing fuses yourself: take a photo of the original position with your phone before operating, otherwise it’s easy to forget. Issues like a blown cigarette lighter fuse are quite common in older cars, so keeping a few 15A fuses in the car is quite practical. If you can’t find the exact location, try checking the manual or asking a mechanic at a repair shop to point it out.

Was this review help?
3
Share
Expand All
OArianna
12/13/2025, 09:33:58 PM

The F3 fuse box is usually located below the steering wheel on the left side. You can see a removable plastic cover by looking down. If you need to find the one in the engine compartment, it's on the left side near the windshield. Remember to turn off the car's power and remove the key before replacing a fuse. Different fuses are responsible for different devices, such as 20A for headlights and 10A for the radio, so it's important to distinguish them clearly. It's recommended that beginners avoid operating the engine compartment fuse box in rainy weather to prevent short circuits.

Was this review help?
12
Share
Expand All
DelLevi
02/02/2026, 10:36:30 PM

I'm very familiar with the BYD F3's fuse box. There's a small storage compartment-like cover panel near the driver's left leg area - just pry it open to reveal the interior fuse box. There's another one in the engine compartment near the battery, covered by a black housing. It's best to bring a flashlight when checking, as the fuse location diagram is sometimes printed on the inside of the cover. If you encounter issues like AC not cooling or power windows malfunctioning, this should be your first troubleshooting spot. Keep 5-6 spare fuses of commonly used specifications in the spare tire compartment for emergencies, especially necessary for long-distance road trips.

Was this review help?
5
Share
Expand All
DeGenevieve
04/28/2026, 03:16:12 PM

I've worked on quite a few F3 models. The fuse box locations are divided into two areas: the one under the steering wheel cover is the cabin fuse box, controlling interior electronics; the one in the front engine compartment is near the left radiator frame, managing headlights and such. Always use specialized pliers to replace fuses - don't pull them out forcefully as it can damage the slots. For older F3s, fuses tend to degrade more easily, so I recommend a comprehensive inspection every three years or so. If you notice any vehicle functions suddenly failing, there's an 80% chance it's fuse-related. Addressing it promptly can prevent more serious wiring issues.

Was this review help?
10
Share
Expand All
More Q&A

What does the battery indicator light mean in a car?

When the battery indicator light appears in a car, it signifies a fault in the battery system. This warning light typically appears if the headlights remain on after the engine is turned off for an extended period. The light will usually go out once the car is started and the alternator begins operating. However, if the battery light remains illuminated after starting the engine, it indicates potential issues with the alternator, wiring connections, or the battery itself. The car battery is an essential component of the vehicle and can be categorized into traditional lead-acid batteries and maintenance-free batteries. Modern batteries use lead-calcium alloy grids, which significantly reduce water decomposition during charging and minimize water evaporation. With their sealed construction, they also emit very little sulfuric acid gas. Compared to conventional batteries, these offer advantages such as requiring no liquid maintenance and having longer charge retention periods.
116
Share

What does 'Please Repair ESC' mean?

Please Repair ESC indicates that the vehicle's Electronic Stability Control (ESC) system is malfunctioning. The ESC system is part of the driving assistance systems. Continuing to drive with a damaged ESC system may lead to loss of vehicle control, so it's recommended to have it inspected at a 4S shop promptly. Modern vehicles are equipped with numerous assistance systems, including not only the ESC but also Anti-lock Braking System (ABS), Brake Force Distribution System, etc. When these systems show faults, sometimes the issue lies with the sensors rather than the systems themselves. These assistance systems rely on sensors to obtain data. If a sensor is damaged, the systems cannot acquire necessary data, which is why fault codes or warning lights appear on the dashboard.
105
Share

What to Pay Attention to When Driving in a Typhoon?

When driving during a typhoon, it is important to reduce speed and turn on the headlights. Below are detailed explanations of these two precautions: Reduce Speed: When encountering strong winds, it is necessary to reduce the vehicle's speed and maintain steady driving. The driver should firmly grip the steering wheel, observe the surroundings, release the throttle to slow down, and wait until the strong winds pass before overtaking. Turn on Headlights: The driver should be aware that visibility on the road is significantly impaired, making driving and maneuvering difficult. It is essential to turn on the headlights and hazard lights, appropriately reduce speed, and if the rain becomes too heavy, pull over to the side of the road and wait until the rain subsides before continuing. During extreme weather conditions like typhoons, it is advisable to avoid driving if possible. If driving is necessary, always prioritize safety.
120
Share

Is it necessary to install a strut bar in a car?

It is not recommended to install a strut bar in civilian vehicles. The strut bar, also known as a stabilizer bar, refers to a device that is horizontally installed in specific parts of a car to enhance the rigidity of the chassis or body when driving under special road conditions. In a broad sense, it includes both stabilizer bars and sway bars. In a narrow sense, it does not include the factory-installed U-shaped sway bars on the vehicle body, and its main function is to prevent rollovers during sharp turns or when the vehicle leans to one side. Depending on the installation location, stabilizer bars are divided into front and rear strut bars, as well as front and rear lower bars. More details about strut bars are as follows: 1. The purpose of installing a strut bar in a car: It is designed to eliminate the impact of vibrations caused by uneven road surfaces on the vehicle body. The vehicle body absorbs a large amount of external vibrations through the independent suspension system. Since the springs of the shock absorbers are independent and the material and physical properties of each spring are difficult to keep uniform, the remaining vibrations are ultimately absorbed by the vehicle body. This manifests as uneven load distribution, making it easy for the vehicle to lean or even roll over during high-speed sharp turns or emergency maneuvers. The strut bar connects the front shock absorbers of the vehicle into a single unit, enhancing the rigidity of the body, effectively preventing body deformation, balancing the torque of the wheels, preventing misalignment, reducing wheel bumpiness, extending the lifespan of the shock absorbers, and avoiding a feeling of weakness and leaning during turns. This increases the safety of the vehicle body, making driving more agile and the ride more comfortable. 2. The hazards of installing a strut bar in a car: Since civilian vehicle bodies are not as sturdy as race cars, they may not withstand the additional stress, leading to tearing and affecting the lifespan of the front shock absorbers. The benefits of a stabilizer bar are maximized only under extreme off-road conditions or high-speed driving. In daily use, the effect of the stabilizer bar is minimal and may even negatively impact handling. The quality of independently sold stabilizer bars varies, and some are marketed as fitting multiple car models. The length and diameter of the stabilizer bar are directly related to the strength of the vehicle body and the flexibility of the chassis. If the stabilizer bar is not well-matched to the vehicle body, it may reduce the lifespan of the shock absorbers at best or cause body deformation at worst.
111
Share

What is a Red Top Civic?

Red Top Civic refers to a Honda Civic equipped with Honda's high-performance red top engine, known as the Civic Type-R. This model's engine performance significantly surpasses that of the standard Civic, and its price is approximately four times higher. Below are details about the Civic: 1. The Civic is a compact car under Honda's lineup. It is powered by two engines: a 1.0-liter turbocharged engine and a 1.5-liter turbocharged engine. 2. The 1.0-liter turbocharged engine, codenamed P10A1, delivers a maximum power of 92 kW and a maximum torque of 173 Nm, with peak power achieved at 5500 rpm and peak torque between 2000 to 4500 rpm. 3. This engine features direct fuel injection technology and utilizes an aluminum alloy cylinder head and block. It is paired with a CVT transmission.
108
Share

How Long After Registration Can You Take the Test?

After successfully enrolling in a driving school, the application form and physical condition certificate must be submitted to the vehicle management office for review. Once the review is completed, you can schedule the Theory Test (some areas do not require study hours, so you can book the test immediately after the review is done). You can usually schedule the Theory Test about 10 days after enrollment. Before scheduling, you should review the Theory Test materials and practice with mock questions. Enrolling in a driving school is only a preliminary registration. After enrollment, the driving school will submit your documents to the vehicle management office. Once approved, the office will issue a serial number, indicating successful registration. After registration, you can schedule the Theory Test. According to the "Regulations on the Application and Use of Motor Vehicle Driving Licenses," the Theory Test consists of 100 multiple-choice and true/false questions, each worth 1 point. If you answer 11 questions incorrectly during the test, the system will automatically submit the test and end the exam. The content of the Theory Test includes: regulations on driving licenses and motor vehicle management; road traffic conditions and rules; penalties for traffic violations; regulations on traffic accident handling; basic knowledge of motor vehicles; local regulations; knowledge of braking systems and safety devices for large and medium-sized buses and trucks; specialized knowledge for wheeled self-propelled machinery, trams, and trolleybuses. Notes for the Theory Test: During the exam, students must dress appropriately—no slippers are allowed. Electronic devices and bags are prohibited in the examination room. Bring your ID card and queue to enter the waiting hall. Observe the instructions and procedures displayed on the screen, and store personal belongings in a locker before entering the exam room. At the identity verification station, you will be assigned a seat. Once seated, begin the exam. Ensure the camera is aligned with you and follow exam rules. If you fail the first attempt, a retake is available on the same day. If you fail again, you must pay to reschedule. After the exam, queue to collect your score report and sign it. Failure to sign will invalidate the results. There is no limit to the number of times you can schedule the Theory Test. Each subject can be taken once, with one retake allowed if you fail. If you do not take the retake or fail it again, the exam process ends, and you must reschedule. For the Practical Driving Test (Subject 2) and Road Test (Subject 3), there are only five attempts. Subject 2 and Subject 3 tests can be rescheduled after 10 days. If you fail the Safety and Civilization Driving Knowledge Test (part of Subject 3), the passing score for the road driving skills test remains valid. There are three main subjects in the driving test: Theory Test (Subject 1), Practical Driving Test (Subject 2), and Road Test (Subject 3). Subject 1 covers traffic laws, regulations, and related knowledge. Subject 2 evaluates driving skills in a controlled environment. Subject 3 consists of two parts: road driving skills and safety and civilization driving knowledge. The latter is often referred to as Subject 4, though this term is not officially recognized in the regulations (Ministry of Public Security Order No. 123).
114
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.