···
Log in / Register

Where is the fuse box located in the BYD F0?

1Answers
MacBrielle
07/29/2025, 09:19:01 PM

BYD F0's fuses are located near the clutch, visible after removing the small box on the left. Detailed information about the fuses is as follows: 1. There are many circuits in a car, and fuses serve to protect these circuits. When the circuit temperature is too high or the current is excessive, the fuse will melt to protect the circuit. The fuse box contains many fuses and relays. When a fuse blows, certain functions of the car may be affected. After a fuse blows, it needs to be replaced with a new one. 2. The process of replacing a fuse is very simple. There is a small clip inside the fuse box; use this clip to remove the fuse and then insert the new one. When replacing a fuse, never pull it out by hand; always use the dedicated clip to remove it. 3. On the cover of the fuse box, there are corresponding functions and codes for each fuse, making it easy for the owner to quickly locate the blown fuse. The fuse box in the engine compartment is generally located near the battery, while the fuse box inside the cabin is usually located in the main driver's position or the glove compartment of the passenger side.

Was this review help?
101
Share
More Q&A

What does a triangle with an exclamation mark in a vehicle mean?

Car dashboard triangle exclamation mark is a conventional fault indicator light, here are the reasons why the conventional fault indicator light comes on: Transmission failure: Reasons for transmission failure include excessive transmission temperature, loose transmission gears, lack of transmission oil, etc. Parking sensor failure: Parking sensor failure generally means the front and rear radars of the car are broken, or the front and rear radars cannot be recognized due to circuit problems. Engine failure: There are many reasons for engine failure, including excessive engine temperature, engine misfire, engine carbon buildup, poor fuel quality, spark plug failure, fuel system blockage, etc. Drive system failure: Drive system failures include ESP body stability system failure, ABS anti-skid system failure, etc.
106
Share

How many points are deducted for stalling during Subject 2?

If the engine stalls once due to improper operation, 10 points will be deducted. Other common situations that result in point deductions include the following: If the vehicle body crosses the line, fails to enter the garage during reversing, stops midway, does not follow the prescribed route or sequence, or exceeds the allotted time, 100 points will be deducted. For the slope parking test, if the right side of the vehicle body is more than 30 cm from the roadside line after parking, 10 points will be deducted; if it exceeds 50 cm, 100 points will be deducted. If the vehicle rolls back and crosses or touches the line, 100 points will be deducted. If the front bumper is not aligned with the pole line and deviates by more than 50 cm, 10 points will be deducted; if it exceeds 50 cm, 100 points will be deducted. The full score for Subject 2 is 100 points, with evaluation criteria for failing, deducting 20 points, deducting 10 points, and deducting 5 points. The test is considered passed under the following conditions: ① For applicants of large passenger vehicles, tractors, city buses, medium-sized buses, and large trucks, a score of 90 or above is required. ② For other vehicle types, a score of 80 or above is required.
105
Share

What is the Defender?

Defender is the Land Rover Defender. Taking the Land Rover Defender 2021 90 P400 X-DYNAMIC as an example: it is a mid-to-large-sized 3-door 5-seater SUV with a length, width, and height of 4583mm, 2008mm, and 1969mm respectively, a wheelbase of 2587mm, equipped with an 8-speed automatic transmission, and a top speed of 191 km/h. The Land Rover Defender 2021 90 P400 X-DYNAMIC uses a 3.0T inline six-cylinder engine, with a maximum torque of 550 Nm and a maximum power of 294 kW. The front suspension type is a double-wishbone independent suspension, and the rear suspension type is a multi-link independent suspension.
117
Share

What do driving license categories C1, C2, C3, C4, and C5 mean?

Here is an introduction to driving license categories: C1: Small vehicles, including C2 and C3 (passenger vehicles with fewer than 9 seats, such as sedans, are considered small vehicles). C2: Small automatic transmission vehicles. C3: Low-speed trucks and C4. C4: Three-wheeled vehicles. Age requirements: The minimum age for a C1 driving license is 18 years old, with no upper age limit. However, applicants aged 70 or older must pass tests for memory, judgment, and reaction abilities. Medical examination requirements: Drivers aged 70 or older (including 70) must undergo an annual physical examination, while those under 70 are not required to do so. Permitted vehicle types: The C1 driving license allows the operation of small and mini passenger vehicles, light and mini cargo vehicles; light, small, and mini special-purpose vehicles; and small passenger vehicles with a seating capacity of 9 or fewer people.
116
Share

What are the differences between the Sienna LE and XLE?

The differences between the Sienna LE and XLE are as follows: Exterior-wise: The LE, XLE, and Limited versions have minimal differences. The LE comes standard with 17-inch five-spoke aluminum alloy wheels, while the XLE and Limited versions feature 18-inch ten-spoke wheels. The SE version, short for Sport-Edition, has distinct front and rear bumpers, hood lines, grille design, and headlight styles compared to other versions. Interior-wise: The LE is the base model of the Sienna, featuring gray easy-to-clean fabric seats and a predominantly gray interior color scheme. The XLE model mostly comes with gray leather seats, power-adjustable driver's seat, and a light gray interior.
112
Share

How many tons can a 750r16 tire carry?

If the vehicle's power system and overload factors are not considered, it can carry 10-12 tons. The following are the functions of tires: 1. Load-bearing: Supports the entire weight of the vehicle, bears the load of the car, and transmits forces and moments in other directions. 2. Transmit traction and braking torque: Ensures good adhesion between the wheel and the road surface to improve the vehicle's power performance, braking performance, and passability; works together with the vehicle suspension to mitigate impacts during driving and dampen resulting vibrations. 3. Vehicle: Prevents severe vibrations and early damage to automotive components, adapts to the vehicle's high-speed performance and reduces driving noise, ensuring driving safety, handling stability, comfort, and energy-saving economy.
110
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.