Where is the Cruze reversing radar?

[Elle]

The control box of the Cruze reversing radar is located under the instrument panel. Method for installing an additional reversing radar on the Cruze: 1. Install four radars at the rear of the car. First, use measuring tools to determine the installation positions of the probes and mark them. 2. Prepare an electric drill. 3. Install the provided special drill bit on the electric drill and drill holes at the marked positions from the previous step. The holes should match the size of the probes. 4. Connect the probes to the wiring harness and install them in the corresponding drilled holes. 5. Organize the wiring harness of the probes and route it to the trunk. 6. Install the front two probes, and use the same method to install the rear probes. 7. Route the wiring harness of the front probes to the brake position of the driver's seat and connect it to the trunk through the door gap. 8. Then connect the red wire to the reversing wire and the white wire to the brake wire. 9. Connect the display, probe wiring, etc., to the main unit, and use adhesive tape to fix and hide the main unit on the inner side to complete the installation.