···
Log in / Register

Where is the cigarette lighter fuse located in a BMW 5 Series?

1Answers
AubreeRose
07/29/2025, 01:16:58 PM

BMW 5 Series cigarette lighter fuses are divided into front cigarette lighter fuse and rear cigarette lighter fuse. The front cigarette lighter fuse is located inside the glove compartment cover on the passenger side; the rear cigarette lighter fuse is located inside the side panel of the trunk. If the cigarette lighter fuse is blown and cannot supply power, it can be replaced. Locate the vehicle's electrical fuse box, open the fuse box cover, refer to the fuse location diagram pasted on the inner side of the cover to find the cigarette lighter fuse position; use the included fuse puller to remove the blown fuse, then replace it with a new or spare cigarette lighter fuse. Generally, cigarette lighters use 15-25A fuses. Since the vehicle voltage is 12V, it is recommended that the connected electrical appliances do not exceed 300W (200W for some compact cars). Besides serving as a lighter, the car cigarette lighter can also be equipped with a car inverter to convert the vehicle's DC power into 220V/50Hz AC power for ordinary electrical appliances, such as charging mobile electronic devices.

Was this review help?
101
Share
More Q&A

What is the purpose of front wheel toe-in?

The purpose of front wheel toe-in is to eliminate the adverse effects caused by wheel camber, ensuring that the wheels do not roll outward, preventing wheel side slip, and reducing tire wear. The toe-in value can be adjusted by changing the length of the steering tie rod, with a general toe-in value ranging from 0 to 12mm. Wheel camber causes the left and right wheels to frequently exert opposing side thrust forces corresponding to the camber angle, increasing tire wear. To eliminate the side thrust forces, during wheel installation, the center planes of the two front wheels of the car are not parallel, with the distance between the front edges of the two wheels being less than that between the rear edges. The difference between these distances is the front wheel toe-in.
112
Share

Where is the Roewe 550's cabin air filter located?

The cabin air filter of the Roewe 550 is located under the front windshield, directly opposite the passenger seat. The functions of the cabin air filter are: 1. Ensuring clean air in the cabin without breeding bacteria; 2. Separating solid impurities such as dust, pollen, and grinding particles from the air; 3. Ensuring the filter fits tightly against the housing to prevent unfiltered air from entering the cabin. The Roewe 550 is a compact car launched by SAIC Motor. Taking the Roewe 550 2014 Manual Smart Selection Edition as an example, its body dimensions are: length 4648 mm, width 1827 mm, height 1483 mm, with a wheelbase of 2705 mm, a fuel tank capacity of 62 liters, and a curb weight of 1485 kg.
114
Share

What does the green light of istop mean?

istop green light indicates that the auto start-stop is in the active state, meaning the auto start-stop system can function normally at this time. Below is more information about the auto start-stop system: 1. The use of the auto start-stop system is subject to certain conditions, such as insufficient battery power, too high or too low temperature, wheels in a turning state when stopping, too steep a slope, seatbelt not fastened, etc. 2. The auto start-stop system (Start/Stop) automatically turns off the engine when the vehicle comes to a temporary stop during driving and automatically restarts the engine when it's time to move forward again.
114
Share

What Causes a Car to Pull to One Side?

Automobile direction deviation may be caused by the following reasons: 1. Insufficient tire pressure is one of the main causes of car direction deviation. Unequal tire pressure, mainly caused by inconsistent tire pressure in the drive wheels, can lead to different degrees of wear between the drive wheels and the ground if the left and right tire pressures are unequal. Different friction levels can directly cause the car to pull to one side. 2. Abnormalities in the car's steering system. Issues within the car's steering system can also result in direction deviation. 3. The use of tires with different tread patterns on the two sides or uneven wear on the tires. This situation can cause different friction levels between the tires and the ground, leading to braking deviation. Additional Information: 1. If direction deviation is noticed while driving, it is advisable to stop and inspect the vehicle immediately if conditions permit. 2. If stopping immediately is not possible, find a safe place to stop as soon as possible.
106
Share

Can You Start the Engine in P Gear?

P Gear allows direct engine starting. The correct practice is indeed to start the engine in P Gear. Moreover, many vehicle models are designed at the factory to only allow engine starting when in P Gear, preventing ignition in other gears. Manufacturers implement this design for safety considerations. Relevant details are as follows: 1. Firstly, both P Gear and N Gear serve to disconnect the engine from the wheel transmission system. However, when in P Gear, a mechanical lever locks the output shaft, preventing vehicle movement to avoid rolling. 2. To put it simply: P Gear is essentially N Gear, but with the engine off, a vehicle in N Gear can be pushed freely, whereas a vehicle in P Gear cannot be moved.
119
Share

What parts are generally maintained during car maintenance?

The most important aspects of car maintenance are changing the engine oil and oil filter. The most frequent task in car maintenance is washing the car. The parts that need to be checked most often are the tire surface and pressure, oil level, coolant level, and brake fluid level. The five key points of engine maintenance are as follows: 1. Use the appropriate grade of engine oil and change the oil and filter regularly (every 5,000 kilometers); 2. Frequently maintain the air filter and replace it regularly (every 20,000 kilometers); 3. Clean the fuel system regularly and replace the fuel filter (every 30,000 kilometers); 4. Maintain the radiator mesh regularly (every 30,000 kilometers); 5. Replace the spark plugs regularly (every 40,000 kilometers or based on driving conditions).
104
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.