···
Log in / Register

Where is the cabin air filter of the Roewe 360 located?

6Answers
DelCamille
08/27/2025, 04:45:47 AM

The cabin air filter of the Roewe 360 is located inside the glove compartment on the passenger side. You can see it after removing the glove compartment. Steps to remove the cabin air filter: First, open the glove compartment cover, locate the fixing buckle on the right side of the glove compartment and pull it outward with force. Remove the fixing buckle of the glove compartment cover to detach it. Then, squeeze both sides of the glove compartment toward the center with both hands, and the glove compartment can be taken off. After that, you can replace the cabin air filter. The Roewe 360 is a compact car with body dimensions of 4579mm in length, 1804mm in width, and 1490mm in height, and a wheelbase of 2660mm.

Was this review help?
117
Share
Fernando
09/09/2025, 03:28:48 AM

The cabin air filter of the Roewe 360 is located behind the glove compartment on the passenger side, which is a standard design point. Fully open the glove box, and you'll notice a plastic cover or inner panel at the rear, typically secured by several small clips; gently press the clips to remove the cover, revealing the filter slot. Simply slide out the old filter and replace it with a new one. The location is easy to find—I've changed it myself several times, saving money on garage visits. Don't underestimate filter replacement—it directly affects cabin air freshness. Changing it every six months prevents dust and mold buildup, especially during urban traffic congestion when cabin air quality deteriorates. Frequent replacement helps avoid sneezing or driver fatigue. Checking the filter is straightforward; I recommend replacing it before spring to preempt pollen season discomfort. The well-designed location makes the Roewe 360 easier to handle than older vehicles, and generic filter sizes usually fit perfectly.

Was this review help?
5
Share
Expand All
VonRowan
10/23/2025, 04:20:52 AM

As a new owner of this car, I was a bit confused when looking for the cabin air filter for the first time. A friend told me it's behind the glove box, so I went to the passenger side to check it out. After pulling down the glove box door, there was a panel secured with a few plastic hooks. I gently pressed the hooks to remove the panel, and the filter slot was revealed. The operation was quite simple, and it took me about ten minutes to complete the first time. The design makes it easy for beginners to handle without needing tools or technical skills. Replacing the filter can improve the driving experience, as the airflow from the AC becomes stronger and eliminates odors in the car. I recommend changing it once or twice a year, adjusting based on mileage. If you drive in dusty areas, you should replace it more frequently to maintain fresh air and protect lung health. It's a straightforward DIY task—just buy a genuine filter and pop it in.

Was this review help?
16
Share
Expand All
SanLincoln
12/06/2025, 03:44:18 AM

The cabin air filter located behind the glove compartment is crucial as it directly impacts in-cabin air cleanliness. Failure to replace it promptly allows dust and mold accumulation, deteriorating air quality and potentially causing coughing or allergies while driving. The accessible installation position makes replacement convenient, though ensuring the vehicle is powered off beforehand enhances safety. Replacing it approximately every six months effectively maintains a healthy breathing environment.

Was this review help?
15
Share
Expand All
DeEmersyn
01/26/2026, 10:09:38 PM

I enjoy working on cars myself, and replacing the cabin air filter for the Roewe 360 is a common task. The filter is located behind the glove compartment; fully extend the glove box, remove the small clips or sliders on the inner door, and you'll see the filter slot where you can pull out the old one and insert the new one. The process is simple and quick—usually, the clips just need a firm press to release. The design makes it easy for DIY, requiring no special tools and taking just five minutes to complete. Replacing the filter prevents reduced airflow due to clogging and avoids putting extra strain on the system. It's recommended to use the manufacturer's recommended size and check it every eight months to maintain effectiveness. Knowing this location well can save you both time and money.

Was this review help?
18
Share
Expand All
DelAaron
04/22/2026, 03:22:00 AM

After driving the Roewe 360, I found the cabin air filter is located behind the glove box - a practical layout. Similar to most modern vehicles, this design allows owners to perform DIY maintenance. Simply open the glove compartment and carefully remove the rear wall panel; the accessible position (not deeply hidden) makes replacement significantly easier than some older car models. Replacing the filter greatly improves cabin air quality by reducing dust and enhancing AC efficiency. The optimal replacement interval is annually or every 10,000 kilometers to prevent future issues.

Was this review help?
19
Share
Expand All
More Q&A

What are the reasons for the failure of the Buick car anti-theft system to start?

Buick car anti-theft system failure to start may be caused by a damaged anti-theft module, a damaged car key chip, or a dead car key battery. Damaged Anti-theft Module: After the vehicle is turned off, the anti-theft module cuts off the engine ignition circuit to prevent the vehicle from starting, achieving anti-theft purposes. When the vehicle's anti-theft mode is deactivated, the engine ignition circuit is restored, allowing the vehicle to start normally. If the anti-theft module malfunctions, the engine ignition lock cannot be properly released, resulting in the vehicle's inability to start normally. The anti-theft module needs to be replaced. Damaged Car Key Chip: When pressing the car key button to lock or unlock the vehicle, the car key emits a signal. The vehicle receives the signal, and after matching and authentication by the onboard computer, the locking or unlocking action is completed. If the car key chip is damaged, it cannot deactivate the anti-theft system to start the vehicle normally. The damaged car key needs to be replaced. Dead Car Key Battery: A dead car key battery will also prevent it from emitting the unlock signal to deactivate the vehicle's anti-theft system, causing the vehicle to fail to start normally. The car key battery needs to be replaced. The car key battery is a consumable item and is not covered under the vehicle's warranty.
115
Share

What is the common issue with GS4 failing to start?

The possible reasons for the GAC GS4 failing to start include: dead battery, empty fuel tank, or incorrect gear position. The following are related details: 1. Empty fuel tank: If the fuel gauge shows below the red line, it indicates insufficient fuel. 2. Dead battery: This could be due to a drained battery from leaving the headlights on for a long time or the battery reaching the end of its lifespan. It is generally recommended to replace the battery every 2 years. Additionally, installing xenon headlights, high-power audio systems, or DVD players can also cause vehicle circuit failures. 3. Incorrect gear position: For automatic transmission vehicles, the gear must be in P (Park) or N (Neutral) position to start. If it is in R (Reverse) or D (Drive), the vehicle will not start. Some manual transmission vehicles will also fail to start if the clutch is not depressed.
118
Share

Why does the ABS pump keep running after the engine stalls?

It may be an issue with the control unit. Main functions of automotive control unit: Accept control information: Mainly refers to receiving various control commands from operators, such as throttle commands. System parameter acquisition and processing function: Uses the microcontroller's rich interface resources to collect engine operating conditions and status parameters, then converts and processes them. Control function: Under the management of control software, completes various control functions, judges operating conditions based on collected system parameters, and achieves fuel injection quantity control and injection timing control. Output driving function: Amplifies signal output based on control information obtained from system processing to drive fuel quantity control mechanism and timing control mechanism. Equipped with system self-diagnosis function: If a fault is detected, backup function will be enabled.
110
Share

How many cubic meters can a 5.6-meter rear eight-wheeler carry?

A 5.6-meter rear eight-wheeler can carry 20 cubic meters. The specific restrictions on trucks in Beijing are as follows: Regulation 1: On roads within the Fourth Ring Road (inclusive), trucks are prohibited from 6:00 to 23:00; on the main roads of the Fifth Ring Road, trucks with a load capacity of 8 tons or more are prohibited from 6:00 to 22:00. Regulation 2: Trucks from other provinces, autonomous regions, or municipalities are prohibited from driving on roads within the Fifth Ring Road (inclusive) at all times. However, trucks from other provinces, autonomous regions, or municipalities transporting production and daily necessities to Beijing are allowed to enter roads within the Fifth Ring Road (inclusive) from 0:00 to 6:00 daily after obtaining a Beijing freight pass. Regulation 3: Chang'an Street, from Xinxing Bridge to Guomao Bridge, prohibits freight vehicles day and night. For restrictions on trucks in other specific road sections, please refer to the traffic signs.
109
Share

Are pure electric vehicles exempt from traffic restrictions nationwide?

Currently, as long as it is a pure electric vehicle, there are no traffic restrictions nationwide. The following is a relevant introduction about plug-in hybrid electric vehicles: Detailed introduction: It has both the engine, transmission, powertrain, fuel system, and fuel tank of traditional cars. It also has the battery, electric motor, and control circuit of pure electric vehicles, and the battery capacity is relatively large, with a charging interface. Advantages: It combines the advantages of pure electric vehicles (EV) and hybrid electric vehicles (HEV), which can achieve pure electric, zero-emission driving, and also increase the vehicle's driving range through hybrid mode.
106
Share

How much does the Kawasaki H2 weigh?

The Kawasaki H2 weighs 238KG. The Kawasaki H2 is the world's first mass-produced model equipped with a supercharged engine. It shares the powertrain platform with the supercharged sports car H2 launched in 2014, delivering a peak horsepower output of up to 200PS. The Kawasaki H2 motorcycle measures 2085mm in length, 770mm in width, and 1125mm in height, with a ground clearance of 130mm. It has a curb weight of 238Kg, a fuel tank capacity of 17L, a displacement of 998CC, an electronic ignition system, a 6-speed transmission, a 4-stroke engine, and a 4-cylinder engine configuration. The maximum power and maximum torque reach 118 horsepower and 95 Nm respectively. It also features top-tier configurations and electronic controls, including Brembo Stylema brake calipers, Brembo clutch, KYB inverted front forks, Ohlins TTX36 rear shock absorbers, Bosch 6-axis IMU, launch control mode, traction control, intelligent anti-lock braking system, engine braking control, bi-directional quick shifter, and more.
101
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.