···
Log in / Register

Where is the cabin air filter located in the Haval H2s?

6Answers
DiJuliette
08/31/2025, 01:46:02 AM

The cabin air filter in the Haval H2s is located behind the right glove box. Below is relevant information about cabin air filters: 1. Function of cabin air filters: They filter dust particles from the air to prevent these pollutants from entering the vehicle's evaporator and causing sludge buildup that could block the evaporator. Another function of cabin air filters is to filter dust, water vapor, pollen, carbon oxides, and sulfides from the air. Since the filter contains activated carbon, it can adsorb harmful gases and particulate matter from the air. 2. Precautions for using cabin air filters: The filter easily accumulates a lot of dust, so it's sufficient to blow away loose dust with compressed air. Do not wash it with water, as this can easily render it unusable. After prolonged use, the activated carbon filtration function in the cabin air filter will diminish, so it's recommended to replace the cabin air filter at a 4S dealership.

Was this review help?
107
Share
CarmenLee
09/12/2025, 10:13:57 PM

The cabin air filter of the Haval H2S is located behind the glove compartment on the passenger side. You'll need to remove the glove box to access it. I've replaced it several times myself. First, press both sides of the glove compartment inward, and the entire box can be lowered. Be careful not to damage the damper rod inside - gently remove it, and you'll see a white cover plate. Open the cover to pull out the old filter. When inserting the new filter, remember to position it with the arrow facing downward - incorrect orientation affects filtration efficiency. I recommend choosing an activated carbon filter to eliminate odors. DIY replacement is extremely simple - you can buy a good filter online for 30-40 yuan, saving half the cost compared to dealership service. Most importantly, changing it every six months is better for your health.

Was this review help?
17
Share
Expand All
AnnaFitz
10/26/2025, 11:01:34 PM

I found that replacing the air filter in the Haval H2S is much more convenient than in most cars—it's right behind the glove box. No tools are needed for removal; just press the clips on both sides of the glove box inward with both hands, and the entire box will naturally drop down. Inside, there's a clip on the cover panel—just press it downward to open. When pulling out the filter, be careful not to bend it, and insert the new filter back in the original direction. I check it every quarter, especially before the rainy season, as the humid climate in the south can easily cause mold. If there's a musty smell from the vents or reduced airflow, it's likely the filter is clogged. This job takes a newbie just ten minutes, and there's no need to crawl under the car.

Was this review help?
11
Share
Expand All
AliceFitz
12/09/2025, 10:17:03 PM

Last time I replaced the cabin air filter for my wife's H2S, which is located inside the glove compartment on the passenger side. To remove the glove box, first press in the left and right retaining clips, then lower it slowly without pulling hard. Inside there's a rectangular filter cover - just release the clip to remove the old filter and install the new one. I recommend buying PM2.5 filters from Taobao as they perform better than OEM ones. No tools are needed for the entire process, even women can do it, but remember to wear gloves to avoid scratches. After replacement, turn on the AC and you'll immediately notice much fresher air with significantly reduced dust inside the car.

Was this review help?
13
Share
Expand All
SanCharlotte
01/29/2026, 11:28:10 PM

As a long-time owner, I must remind you that the cabin air filter in the Haval H2S is designed with great user-friendliness, located right behind the glove box. Simply open the passenger door, empty the glove box, press the rotary buttons on both sides, and the box will naturally drop down to reveal the filter compartment. Two key points when replacing: first, pay attention to the arrow direction to avoid installing it backward; second, choose a filter with moderate thickness—too thick and it might not seal properly, causing air leaks. I make it a rule to replace it every 8,000 kilometers, especially after driving on dusty roads. It's a five-minute DIY job, whereas a repair shop would charge you at least 50 yuan in labor costs.

Was this review help?
3
Share
Expand All
DiSamantha
04/24/2026, 05:36:55 PM

I've been researching automotive supplies for several years. The cabin air filter for the Haval H2S is located in the glove compartment on the passenger side. The removal technique involves pressing both protruding areas on the left and right sides of the glove box simultaneously, then folding it downward 90 degrees. You'll see the filter compartment cover - just push open the latch with your thumb to pull out the filter. I recommend purchasing composite filters with an outer layer for dust filtration and an inner activated carbon layer for formaldehyde removal. My tests show self-replacement is faster than dealership service - they always push overpriced filters. Regular replacement also protects the AC blower motor and extends its lifespan.

Was this review help?
9
Share
Expand All
More Q&A

Where is the horn located on the Sagitar?

You can see it after opening the engine hood. It is usually installed on the radiator frame. There are two horns, one for high pitch and one for low pitch. Here is some related information about the Sagitar: 1. Exterior: Taking the 2021 Sagitar as an example, it belongs to the compact car category. Its body dimensions are: length 4753mm, width 1800mm, height 1462mm, wheelbase 2731mm, fuel tank capacity 50l, and curb weight 1355kg. 2. Suspension: The 2021 Sagitar features a front MacPherson independent suspension and a rear multi-link independent suspension. 3. Powertrain: It is equipped with a 1.2T turbocharged engine, delivering a maximum horsepower of 112PS, maximum power of 85kW, and maximum torque of 175Nm, paired with a 5-speed manual transmission.
105
Share

P0172 System Too Rich Solution?

P0172 system too rich treatment method: Check the atomization condition of the fuel injector; test the electronic control system; check whether the engine intake pressure sensor has a fault; check whether the intake pipe is leaking. The following is a related introduction about automobile fault codes: 1. Meaning: Automobile fault codes are the fault codes reflected by the car's computer ECU after a fault occurs. Generally, common fault codes are caused by sensor faults or poor sensor performance, but some mechanical faults cannot be read by the ECU. There will be some basic fault displays on the car dashboard, but that is only a small part. The main part still needs to be read with the help of an instrument - a decoder. There are many types of decoders, such as X-431 and KT300, but the working principles and the fault codes read are the same. 2. Classification: Fault codes are divided into real codes, historical codes, and intermittent codes. Real codes are easy to detect, historical codes, as the name implies, are previously unresolved fault codes that have not been cleared, but intermittent fault codes are not fixed.
114
Share

What car is the X logo

X logo represents the Toyota Reiz. Here are some details about the Toyota Reiz: 1. The Reiz is marked with an X logo in Japan. To penetrate the Chinese market, it adopted the Toyota logo and was renamed Reiz. 2. The Toyota Reiz was the first to employ FR (Front-engine, Rear-wheel-drive) technology, combining smooth handling with powerful driving force, achieving top-tier driving performance among mid-sized cars. 3. The thoughtful design of the Toyota Reiz positions the four wheels closer to the four corners of the body, maximizing a low center of gravity for stability. Through the most scientific layout, it achieves an ideal front-to-rear weight distribution of 54:46.
114
Share

Where is the starter relay of BYD F3 located?

BYD F3 starter relay is located inside the interior trim panel in front of the driver's seat. Here are some introductions about the starter relay: 1. Function: The starter relay is a separate component, whose function is to connect and disconnect the pull-in coil and hold-in coil circuits. 2. Principle: The starter relay adopts a single-phase split-phase asynchronous motor. It assists the motor in starting and automatically disconnects the auxiliary winding after startup to prevent burning out the auxiliary winding coil. 3. Features: The F3 starter relay has characteristics such as no moving parts, no noise, no arc, long service life, low price, and strong adaptability to voltage fluctuations.
103
Share

Where does the license plate starting with Lu C belong?

License plates starting with Lu C belong to Zibo City, Shandong Province. Detailed information about license plate numbers is as follows: 1. The structure of automobile license plate numbers consists of two rows: the upper row is the registration authority code, and the lower row is the plate number. 2. The registration authority code consists of 2 characters, including a Chinese character and an English letter. The Chinese character is the abbreviation of the province, autonomous region, or municipality, while the English letter represents the vehicle management office. 3. Lu A - Jinan, Lu B - Qingdao, Lu C - Zibo, Lu D - Zaozhuang, Lu E - Dongying, Lu F - Yantai, Lu G - Weifang, Lu H - Jining, Lu J - Tai'an, Lu K - Weihai, Lu L - Rizhao, Lu M - Binzhou, Lu N - Dezhou, Lu P - Liaocheng, Lu Q - Linyi, Lu R - Heze, Lu S - Laiwu, Lu U - Qingdao supplementary, Lu V - Weifang supplementary, Lu W - Provincial government agencies, Lu Y - Yantai supplementary.
114
Share

What is the most fuel-efficient temperature for car air conditioning?

Setting the car air conditioning to around 26°C with the fan at the second speed is the most fuel-efficient. If the air conditioning temperature is set to the lowest, the compressor will run continuously, and the blower will operate at a high speed, which does not save fuel but instead increases consumption. Here are some methods to save fuel when using air conditioning: 1. Choose the right timing: Generally, it's best to turn on the air conditioning after letting out the hot air first. 2. Direct airflow upward: When using the air conditioning, direct the airflow upward since cold air sinks and can neutralize the rising hot air, resulting in the fastest cooling. 3. Alternate turning it on and off in city driving: Frequent stops and starts in city traffic consume the most fuel, as the engine struggles to dissipate heat, and starting the car or the air conditioning requires significant power, leading to higher fuel consumption. 4. Accelerate gently after turning on the air conditioning: When the air conditioning is on, smaller engines may experience noticeable power loss. Avoid pressing the accelerator too hard to compensate, as this increases fuel consumption without improving speed. 5. Switch between recirculation and fresh air modes: Periodically switch between recirculation and fresh air modes to ensure proper air circulation.
104
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.