···
Log in / Register

Where is the air conditioning filter located on the Lechi?

6Answers
DelLane
07/29/2025, 07:47:48 PM

The Lechi model does not come with an air conditioning filter, as the vehicle's configuration is relatively basic, featuring only a thin filtration screen. Below is relevant information about air conditioning filters: 1. A car typically has four filters: the oil filter, air filter, air conditioning filter, and fuel filter. 2. Among these four filters, the air conditioning filter is the most beneficial, as it filters the air inside the cabin. 3. The air conditioning filter is installed in the car's air conditioning system and can absorb dust particles, reduce respiratory discomfort, minimize irritation for allergy sufferers, and protect the air conditioning cooling system. 4. With an air conditioning filter, the car's air conditioning system operates more efficiently while also safeguarding the health of passengers. 5. Under normal conditions, an original air conditioning filter can last for 20,000 kilometers or one year. Regular maintenance of the filter can further extend its lifespan.

Was this review help?
117
Share
MatteoAnn
08/15/2025, 11:09:08 PM

As a veteran driver who has owned a Lechi for over a decade, I've personally replaced the cabin air filter several times. It's located behind the glove compartment in front of the passenger seat. The specific steps are: first open the glove box, locate the plastic clips on both sides, press gently to remove the entire glove box, then you'll see a rectangular filter housing—just pull out the old filter and replace it with a new one. The design makes it very DIY-friendly, but be careful not to use excessive force to avoid damaging the clips. I recommend checking it every 10,000 km or six months, otherwise a clogged filter will make the cabin air stuffy and cause severe odor from the AC vents. This simple maintenance during regular servicing can extend the AC system's lifespan and keep the driving environment much fresher.

Was this review help?
18
Share
Expand All
LaDaniella
10/19/2025, 12:06:10 AM

As a hands-on DIY enthusiast, I've explored the cabin air filter location on my Lechi. It's positioned beneath the dashboard near the passenger side, inside the glove compartment. Replacement is incredibly simple: open the glove box, press the small protrusions on both sides to release it, then pull out the filter housing - the filter is sandwiched in between. I usually use a small tool to pry open the fastener, completing the job in under 5 minutes. Remember to choose the correct replacement filter model and avoid cheap knockoffs. Regular replacement ensures better airflow and prevents dust inhalation, saving you unnecessary dealership expenses.

Was this review help?
17
Share
Expand All
BeckettAnn
12/01/2025, 11:42:05 PM

I'm a regular Spark owner and just replaced my cabin air filter myself last week. It's located right behind the glove compartment on the passenger side - just open it and you'll see the filter housing. Simply pull it out and replace with a new one. The whole process is quick and easy, usually requiring no tools. When the filter gets old, the car interior starts smelling bad, especially when driving in dusty urban areas. I recommend replacing it according to the maintenance schedule or every 10,000 km to keep the air clean and fresh.

Was this review help?
16
Share
Expand All
DeJuliet
01/22/2026, 01:05:40 AM

From a health perspective, the location of the Spark's cabin air filter is crucial for the in-car environment. It is hidden behind the glove box, and when pulled out for inspection, it is often covered in dark dust. Every time I replace it, I feel the air inside the car improves significantly, which is especially beneficial for people prone to allergies. The location is not hard to find: remove the glove box to access the filter. A clogged filter can reduce the efficiency of the air conditioning, leading to weaker airflow and diminished defogging capability while driving. It is recommended to replace it seasonally, such as checking it before summer.

Was this review help?
1
Share
Expand All
VanJosiah
04/18/2026, 01:02:32 AM

Safety first, the filter's location directly impacts driving safety. In my Lechi car, it's situated in the filter compartment behind the glove box on the passenger side—simple yet crucial to remove. A clogged filter reduces AC airflow, potentially delaying defogging in rainy or foggy conditions and obstructing visibility. I make it a habit to replace it every 8,000 kilometers to ensure proper ventilation and maintain driving focus. The accessible design facilitates maintenance—never overlook this small component.

Was this review help?
11
Share
Expand All
More Q&A

What lights should be used when passing a crosswalk in Subject 3?

When passing a crosswalk in Subject 3, you should alternately use high and low beams, and the alternation should be done no less than 2 times. Relevant explanations are as follows: 1. Overview: Subject 3, also known as the road test, is part of the motor vehicle driver's license assessment. It is the abbreviation for the road driving skills and safe civilized driving knowledge test in the motor vehicle driver's examination, which can largely test the driver's ability in actual driving situations. 2. Use of lights: When approaching an intersection without traffic lights, alternately use high and low beams no less than 2 times; when about to overtake, first turn on the left turn signal, then alternately use high and low beams no less than 2 times, and then turn on the right turn signal; when about to meet other vehicles, turn on the low beams, etc.
117
Share

Is an Air-Fuel Ratio Greater Than 14.7 Rich or Lean?

An air-fuel ratio greater than 14.7 is considered rich. Below is an introduction to the air-fuel ratio: 1. Overview: The air-fuel ratio (A/F, where A stands for air and F stands for fuel) is the ratio of air mass to fuel mass in a combustible mixture. It is a crucial parameter for engine operation, significantly impacting exhaust emissions, engine power, and fuel economy. 2. Principle: To achieve optimal catalytic efficiency (over 90%), an oxygen sensor must be installed in the engine's exhaust pipe for closed-loop control. The oxygen sensor measures the oxygen concentration in the exhaust and converts it into an electrical signal sent to the ECU, keeping the engine's air-fuel ratio within a narrow, near-ideal range (14.7:1). If the air-fuel ratio is too high, although the conversion rates of CO and HC slightly improve, the NOx conversion rate drops sharply to 20%. Therefore, maintaining the optimal air-fuel ratio is essential, and ensuring the proper functioning of the oxygen sensor is key to achieving this.
114
Share

Under what circumstances must seat belts be replaced?

Seat belts must be replaced if they show signs of aging. The most prominent indicator is the aging of the internal retractor spring. If the seat belt feels loose or fails to retract properly, it signifies the onset of aging. Additionally, a sluggish response from the seat belt is another manifestation of aging. At this point, the seat belt can no longer provide optimal protection and may even pose a safety hazard. Methods for maintaining seat belts: 1. Check the buckle: Inspect the seat belt buckle. If dust accumulates in the hinge area of the shoulder belt, it can slow down the belt's response. In such cases, clean it with a dry cloth. 2. Cleaning: Since seat belts frequently come into contact with the body, sweat, beverages, or food particles may adhere to them, potentially compromising their strength. If the seat belt is excessively dirty, use warm water, mild soap, a damp cloth, and a soft brush for scrubbing.
102
Share

What Does Vehicle Wading Depth Mean?

Maximum wading depth is one of the important indicators for evaluating a vehicle's off-road capability, referring to the deepest water level a vehicle can safely pass through. Below is additional information: 1. Unprepared wading depth: This refers to the depth at which a vehicle without modifications can operate without affecting the normal functioning of its mechanical components, such as whether the exhaust pipe will take in water, whether the air intake will suck in splashed water, or whether the cooling fan will be submerged in water. 2. Prepared wading depth: This refers to the wading depth of a modified vehicle, where the exhaust pipe is designed to be higher, the air intake is relocated to the roof, and the radiator and fan are removed from the engine compartment, among other modifications.
116
Share

How Long After Dropping Out of Driving School Can You Reapply?

There is no time restriction. Once the withdrawal is confirmed, you can reapply for the exam. Below is relevant information about the driving test: 1. Definition of Driving Test Simulation Fee: The simulation fee and venue fee refer to the costs required for conducting a simulated test at the exam venue. During the process of obtaining a driver's license, apart from the registration fee, simulation fee, and venue fee, there are no other charges. However, the decision to take or not take the simulated test is entirely up to you—you can choose to simulate or not. 2. Driving Test: Applicants for a motor vehicle driver's license must pass the following four exam subjects: Subject 1—Road Traffic Safety Laws, Regulations, and Related Knowledge; Subject 2—Venue Driving Skills; Subject 3—Road Driving Skills; and Subject 4—Safe and Civilized Driving Knowledge. The exams are conducted in the order of Subject 1, Subject 2, Subject 3, and Subject 4. Only after passing the previous subject can you proceed to the next one.
116
Share

Is gear shifting required in Subject 2 of the driving test?

Gear shifting is not required in the Subject 2 driving test, with the following explanations: 1. Requirements: There are no restrictions on vehicle speed or gear selection in the Subject 2 driving test, and it is not limited to first gear. However, due to practical needs, the vehicle speed should be reduced during the Subject 2 test to facilitate timely adjustment of the vehicle's path for completing the test, so first gear is generally used. 2. Re-shifting: No re-shifting is required for each item. After completing one item, proceed to the next item as prompted by the voice instructions. Use first gear throughout when moving forward, and reverse gear is needed for reverse parking and parallel parking.
120
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.