What procedures are required for modifying a vehicle's appearance

What Causes the Steering Wheel of the Envision to Shake While Driving?

Possible causes for the steering wheel of the Envision shaking while driving are as follows: Tire Deformation: When driving at speeds between 80 to 90 kilometers per hour, the steering wheel may shake, but the issue resolves once the speed exceeds 90 km/h. This is often caused by tire deformation or issues with the vehicle's drivetrain. It is necessary to check the front wheel alignment angles and toe settings to ensure they meet specifications, adjusting if necessary. Lift the front axle and rotate the wheels to inspect their static balance and check for excessive tire deformation. Replace the tires if deformation is found. Worn Ball Joints: The vehicle may drive normally on smooth roads, but the steering wheel shakes when encountering rough or uneven surfaces. This is typically due to worn or loose ball joints in the tie rods, detached rubber bushings at the joints, or irregular tire wear from prolonged use. Take the vehicle to a professional repair shop for inspection and replace any damaged components. Aged Tires: At speeds between 30 to 40 kilometers per hour, the vehicle may exhibit a swaying sensation, similar to being on a boat. This is often caused by tire deformation resulting from daily wear, impacts, or aging. Replacing the tires should resolve the issue.

5

3

Share

Where is the Chery Antifreeze Located?

Chery's antifreeze filling port is located in the engine compartment. Pay attention to the oil reservoir and water reservoir. There are two filling ports for water. The antifreeze filling port is located above a small water reservoir, while the windshield washer fluid is on top and does not have a visible small water reservoir; it is marked with a water spray pattern on the cap. Vehicle antifreeze generally needs to be replaced every 2 years or 40,000 kilometers. This is just a reference interval. For commercial vehicles with longer mileage, the replacement interval should be shorter. Since driving conditions vary for each vehicle, the replacement should be based on actual usage. Check the antifreeze condition regularly. If the antifreeze level is low, replenish it promptly. If suspended particles, sediment, or discoloration are observed, replace the antifreeze and clean the system immediately. How to determine if antifreeze is low: Check the antifreeze warning light on the dashboard. If it lights up, it likely indicates low antifreeze, though it could also be due to excessively high cylinder temperature. Inspect the antifreeze reservoir. If the fluid level is below the minimum mark (MIN), do not continue driving and add antifreeze promptly. Check the water level markings on the antifreeze reservoir. The antifreeze level should normally be between the maximum and minimum marks. If it is below the minimum mark, it indicates a shortage of antifreeze.

16

4

Share

Where is the external air circulation button on the Haval H6?

To activate the external air circulation on the Haval H6, you need to turn on the vehicle's air conditioning system, then tap the external circulation button on the central control touchscreen. External circulation refers to the air conditioning system drawing in outside air to circulate within the vehicle cabin. Extended content: Maintenance methods for car air conditioning: 1. Correctly adjust air vent direction: Many owners don't adjust the air vent direction when using AC, which prevents optimal performance. The correct approach is to point vents upward when cooling and downward when heating, as cold air sinks while warm air rises. 2. Avoid prolonged AC use: Extended usage increases condenser pressure and causes wear to the cooling system. When cabin reaches comfortable temperature, turn off AC temporarily before reactivating. 3. Ventilate before using recirculation in summer: During hot weather, owners often immediately activate AC with recirculation, but this backfires when cabin temperature exceeds outside temperature. The proper method is to first open windows with external circulation to expel hot air, then switch to recirculation. 4. Turn off AC before engine shutdown: Shutting down the engine before turning off AC harms the engine, as it forces the next cold start to bear the AC load. Always deactivate AC before turning off ignition, and wait 2-3 minutes after engine start (for lubrication) before activating AC.

14

3

Share

What is the normal tire pressure for a Haval?

The normal tire pressure for a Haval should be between 2.3~2.7 BAR. As long as it falls within this standard range, it is safe. In summer, it is advisable to maintain a slightly lower tire pressure within the normal range, preferably between 2.3~2.5 BAR. Hazards of overinflated tires: The friction and adhesion of the tires will decrease, affecting braking performance; It may cause steering wheel vibration and deviation, reducing driving comfort; Accelerates localized wear of the central tread pattern, shortening tire lifespan; Increases vehicle vibration, indirectly affecting the lifespan of other components; Excessive stretching of tire cords may occur, reducing tire elasticity and increasing the load on the vehicle during driving; Decreases puncture resistance. Sharp objects like nails or glass on the road can easily penetrate the tire, leading to internal cracks, blowouts, or even tire bursts. Hazards of underinflated tires: Increases friction with the road surface, leading to higher fuel consumption; Causes heavy steering and potential deviation, compromising driving safety; Increases movement in various parts of the tire, leading to abnormal heat generation due to excessive compression; Reduces the functionality of cords and rubber, causing delamination or cord breakage and excessive friction with the rim, leading to damage and abnormal wear; Multiplies friction between the tire and the ground, rapidly increasing tire temperature, softening the tire, and drastically reducing its strength. High-speed driving may result in tire bursts; Increases tire deformation, making the sidewalls prone to cracks and generating flexing movements that lead to excessive heat, accelerating rubber aging, cord fatigue, and breakage. It also increases the tire's contact area with the ground, accelerating shoulder wear.

18

5

Share

Is the Jeep Compass Fuel Consumption High?

The comprehensive fuel consumption of the Jeep Compass ranges from 6.0-7.6L/100km. Currently, there are 7 models of the 2021 Jeep Compass available for sale. The automatic comfort version has a comprehensive fuel consumption of 6.0L/100km; the automatic luxury version is 6.3L/100km; the automatic four-wheel-drive high-performance flagship version is 7.6L/100km; the automatic four-wheel-drive elite version and the automatic four-wheel-drive 80th anniversary edition both have a comprehensive fuel consumption of 7.3L/100km; the automatic elite version and the automatic leading version have a comprehensive fuel consumption of 6.2L/100km. The above figures are the NEDC comprehensive fuel consumption, which is the fuel consumption data measured under the NEDC test procedure. The actual fuel consumption is higher than these values, ranging from 5.7-9.3L/100km. The specific factors affecting a car's fuel consumption are as follows: Car weight: Larger and heavier cars tend to consume more fuel. Generally, a small family car with a 1.6L engine and a weight of about 1.2 tons has a fuel consumption of approximately 7.5 liters (calculated under full load), while an SUV weighing about 1.5 tons consumes around 8.5 liters. Different weights lead to varying fuel consumption. Air resistance: Higher air resistance increases fuel consumption during driving. Cars with better aerodynamics have lower air resistance, resulting in lower fuel consumption. Economical RPM: The engine has a most economical torque output point during driving. Maintaining the car's speed within this torque output point can significantly reduce fuel consumption. Typically, small-displacement cars achieve this at around 70 km/h, while larger-displacement cars reach it at about 100 km/h. Staying within this economical RPM range ensures minimal fuel consumption. Driving style: Aggressive driving behaviors such as rapid acceleration, frequent overtaking, and not easing off the throttle before encountering a red light can increase fuel consumption.

5

1

Share

What Causes the Constant Illumination of the Mondeo Engine Malfunction Light?

The engine malfunction light may illuminate due to the following seven main reasons: Sensor Failure: The sensors mentioned here include those for coolant temperature, crankshaft position, air flow, intake air temperature, oxygen sensors, etc. When these sensors are damaged, have poor connections, or their signals are interrupted, the vehicle's ECU cannot accurately obtain engine data, which may trigger the engine malfunction light. Fuel Quality Issues: If fuel and engine oil are not added as required by the manufacturer, it may cause engine wear, leading to the illumination of the malfunction light. Poor Combustion of Air-Fuel Mixture: Poor combustion can lead to engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the malfunction light will illuminate as a warning. Issues such as spark plug failure, ignition coil failure, fuel pump failure, or fuel line blockage can all cause poor combustion of the engine's air-fuel mixture. Turbocharging Problems: Issues with the intake boost piping or turbocharger can also cause the engine malfunction light to illuminate. The most common issue is turbocharger damage, accompanied by symptoms such as oil leaks, high oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Intake Problems: If there are issues with the vehicle's air intake, it may lead to engine pipe blockages, and in severe cases, trigger the engine malfunction light. A dirty or uncleaned air filter can cause intake problems. Exhaust Problems: Exhaust system failures can also cause the engine malfunction light to illuminate. Common causes include rear oxygen sensor failure, three-way catalytic converter issues, exhaust camshaft and bearing failures, with the three-way catalytic converter being the most frequent. Using leaded gasoline, lead or silicon-containing lubricant additives, physical damage to the catalytic converter, or fuel supply system failures can easily lead to three-way catalytic converter problems. Anti-Theft System Failure: If the vehicle's electronic anti-theft system malfunctions, or if the anti-theft controller does not match the engine electronic controller, the anti-theft system can prevent the engine from operating normally, while also triggering the engine malfunction light. If the engine malfunction light is illuminated, follow these steps: First, check if the engine is running normally, looking for signs of shaking, smoke, etc. If such issues are present, avoid restarting the engine. Particularly, do not restart the engine if the red warning light is on. If the engine can be started, turn it off for 5-10 minutes, then without pressing the brake, press the start button once or turn the key halfway to the 'on' position without depressing the clutch. The vehicle will perform a self-check after powering on. Observe whether the malfunction light on the dashboard turns off after 5-10 seconds. If the malfunction light remains on, visit a service station as soon as possible to diagnose the issue. The service station can use a portable diagnostic tool to read the fault codes, obtain fault information, and perform targeted repairs.

16

5

Share

What procedures are required for modifying a vehicle's appearance

What Causes the Steering Wheel of the Envision to Shake While Driving?

Where is the Chery Antifreeze Located?

Where is the external air circulation button on the Haval H6?

What is the normal tire pressure for a Haval?

Is the Jeep Compass Fuel Consumption High?

What Causes the Constant Illumination of the Mondeo Engine Malfunction Light?

What are the differences between Audi S3, S4, and S5?

What Causes the Peugeot 307's Brakes to Become Hard?

Does the Mazda3 Axela have a power outlet in the trunk?

What does the dashboard display when the Golf's trunk is not properly closed?