What is the method to reset the maintenance light on Dongfeng DX7?

What are the benefits of ECU remapping?

After ECU remapping, naturally aspirated engines can achieve a 5%-15% increase in both power and torque. The optimal torque point responds earlier than the factory settings, effectively resolving issues such as hesitation during gear shifts in 1st and 2nd gears for small-displacement vehicles, resulting in smoother gear transitions. Turbocharged models can gain 30% or more in power and torque. Factory turbocharged vehicles typically activate the turbo around 1800 RPM, but after ECU modification, the turbo engages at approximately 1500 RPM, delivering torque earlier and broadening the maximum torque output curve, which also improves fuel efficiency compared to stock configurations. Post-modification, automatic transmission vehicles experience smoother gear shifts and more seamless power delivery. It addresses various factory-unresolved issues like low idle stalling, engine knocking in segments, and automatic transmission shift shocks, while effectively enhancing engine RPM performance.

13

5

Share

How to Check for Undercarriage Scratches?

You can directly use a lift to raise the car and check for any scratches on the undercarriage. Here are specific methods to protect your car's undercarriage: 1. Apply an undercarriage coating: The engine guard's protection area is too small, so you can spray a layer of undercarriage coating on the vehicle's undercarriage. 2. Install an engine guard: The engine guard can protect the engine from road debris impacts and foreign object scratches, but this feature is not available on all models. While the guard can reduce damage from bottoming out, it may affect engine heat dissipation and could interfere with engine drop-down during a collision, posing a safety hazard. Therefore, when selecting a guard, make sure to choose a qualified product. 3. Be aware of your car's ground clearance: Try to avoid bottoming out as much as possible.

11

4

Share

Are private cars prohibited from driving on highways at night?

Private cars are not prohibited from driving on highways at night. Here is an introduction regarding traffic prohibitions: 1. Concept explanation: Traffic prohibition means no passage is allowed. Lines refer to the driving lanes marked on the road, such as center lines, dashed lines, solid lines, single yellow lines, double yellow lines; these lines regulate the lanes that various vehicles should use, such as fast lanes, slow lanes, overtaking lanes, motor vehicle lanes, bicycle lanes, bus lanes, etc. 2. Line signs: Prohibited lanes are determined by traffic police based on the lanes and surrounding road conditions, as well as social, environmental, production, and living conditions. Prohibiting vehicle passage or certain types of vehicles is based on the unified regulations of national traffic laws, with prohibition signs erected roadside.

9

3

Share

What is the Difference Between Body-on-Frame and Unibody?

The following are the specific differences between body-on-frame and unibody: 1. Structure: In body-on-frame vehicles, the bottom consists of an independent large steel frame or chassis beam. Components such as the engine and transmission system are mounted on this frame and connected to the front and rear parts of the vehicle via the front and rear suspensions. Unibody vehicles do not have a rigid frame at the bottom, but the front, rear, and side sections of the body are reinforced. The engine, front and rear suspensions, and transmission components are fixed in their designated positions and connected to the wheels via the suspensions. 2. Applicable vehicle types: Body-on-frame structures are relatively heavy, with high mass and a high center of gravity, making them suitable for trucks, buses, and off-road vehicles. However, due to their excellent stability and off-road performance, they are also used in some high-end vehicles. Unibody structures, known for their lighter weight and lower height, are primarily used in urban-oriented family cars and city SUVs.

13

4

Share

What Causes Inaccurate Fuel Gauge After Replacing a New Fuel Pump Assembly?

Inaccurate fuel gauge after replacing a new fuel pump assembly can be attributed to sensor malfunction, fuel gauge display issues, or differences in the mechanical position of the fuel pump. The specific reasons are as follows: Sensor Malfunction: Sensor malfunction is one of the reasons affecting the fuel gauge's inaccuracy, causing the gauge needle to fail to reach an accurate reading. This issue can only be resolved using professional debugging equipment at a repair shop. Fuel Gauge Display Issues: For fuel gauge display problems, cleaning and wiping the fuel gauge can help, or professional maintenance at a repair shop may be required. Differences in the Mechanical Position of the Fuel Pump: The new fuel pump's mechanical position may differ from the old one, requiring adjustment. A rough adjustment method is to press the reset button on the dashboard after replacing the fuel pump and observe whether the needle is at the empty position, adjusting it until it functions normally.

12

0

Share

Why Do Scooters Have Higher Fuel Consumption in Winter?

Scooters experience increased fuel consumption in winter due to incomplete combustion, higher operational resistance, and improper use of engine oil, as detailed below: Incomplete Combustion: During winter, the engine requires a longer warm-up period, and the low temperatures lead to incomplete combustion. Some gasoline and air-fuel mixture may be expelled without being fully burned, resulting in higher fuel consumption. Higher Operational Resistance: In winter, tires become harder, and various rotating components tighten up, increasing operational resistance. This also contributes to higher fuel consumption. Improper Use of Engine Oil: Due to lower temperatures in winter, engine oil tends to thicken. Especially after a scooter has been parked overnight, the oil usually settles at the bottom of the cylinder, leaving various engine components without proper lubrication. Therefore, it is necessary to use the appropriate type of engine oil to reduce energy consumption during cold starts.

6

2

Share

What is the method to reset the maintenance light on Dongfeng DX7?

What are the benefits of ECU remapping?

How to Check for Undercarriage Scratches?

Are private cars prohibited from driving on highways at night?

What is the Difference Between Body-on-Frame and Unibody?

What Causes Inaccurate Fuel Gauge After Replacing a New Fuel Pump Assembly?

Why Do Scooters Have Higher Fuel Consumption in Winter?

Which Gear to Use When Parking on a Slope?

What is the Tire Pressure Warning Symbol?

How to Deal with Scratches on the Car's Windshield?

How to Conduct Annual Inspection?