What is the issue when the turn signal lights up when stepping on the brake?

1 Answers
VonAnastasia
07/25/25 5:12pm
When the turn signal lights up while stepping on the brake, it is caused by a short circuit in the wiring. It needs to be handed over to a 4S shop for inspection and repair, and the wiring should be reconnected. Below is relevant information about automobile brakes: 1. Introduction to brakes: Brakes, also known as stopping devices, refer to actions that make running locomotives, vehicles, other means of transportation, or machinery stop or reduce speed. The general principle of braking is to fix a wheel or disc on the high-speed shaft of the machine and install corresponding brake shoes, bands, or discs on the machine base to generate braking torque under external force. The brake device, also known as a decelerator, is a mechanical braking device that can slow down the vehicle speed. 2. Classification of brakes: Drum brakes, disc brakes, etc.
Was this review help?
15
2
Share
More Forum Discussions

What happens if you forget to shift to P gear when parking with one-button start?

The consequences of forgetting to shift to P gear when parking with one-button start: the vehicle cannot be powered off, the vehicle cannot be turned off via the keyless start system, and the doors cannot be locked. When using the one-button start and stop function, it is essential to ensure that the vehicle is turned off before locking it. The primary step to turn off the vehicle with one-button start is to use the brake pedal to bring the vehicle to a complete stop. Without releasing the pedal, shift the vehicle's gear to P, engage the vehicle's handbrake system, then release the brake pedal and press the one-button start button once to turn off the vehicle. You can check if the dashboard lights are off, as this indicates that the vehicle is turned off.
5
0
Share

What are the solutions for diesel heater ignition failure?

Solutions for diesel heater ignition failure: 1. Reduce the amount of fuel placed at one time; 2. Improve the ventilation system by appropriately increasing the vent size. Since the density of compressed fuel is still not high, a larger volume of fuel is required to release a certain amount of heat. When the internal space of the diesel heater contains fuel exceeding the rated volume, the ventilation or daily oxygen supply becomes insufficient. The reasons for diesel heater ignition failure in vehicles are: 1. The thermostat is always open or opens too early, causing the cooling system to start a large cycle prematurely. When the external temperature is very low, especially when the vehicle is moving, the cold wind quickly cools the antifreeze, preventing the engine water temperature from rising and the heater from warming up; 2. The water pump impeller is damaged or slips, resulting in insufficient flow through the small heater radiator, preventing heat from rising; 3. There is airlock in the engine cooling system, which leads to poor circulation in the cooling system, causing high water temperature and the heater not warming up.
12
5
Share

When to Use S and L Gears in an Automatic Transmission?

Automatic transmission S gear is typically used for overtaking or climbing hills due to its stronger power output. After completing these maneuvers, it is advisable to switch back to the more economical D gear. In terms of fuel consumption, the S gear mode consumes more fuel than the normal mode because of the increased fuel injection at higher engine speeds. The L gear in an automatic transmission is engaged when going downhill. In this mode, the gear is limited to a low gear (usually first gear), allowing the driver to utilize the engine braking effect of the transmission to control the vehicle's speed, thereby reducing the burden on the brakes, minimizing the risk of brake fade, and enhancing driving safety. For vehicles without an L gear, if equipped with a manual mode, the manual mode can be used for downhill driving.
4
2
Share

What is the method for changing the CVT transmission fluid in a Corolla?

The method for changing the CVT transmission fluid in a Corolla is: 1. Drain the fluid by loosening the transmission's drain plug and then refill it; 2. Remove the oil pan directly to drain and refill the fluid; 3. Currently, more advanced fluid exchange machines can automatically replace the transmission fluid. Transmission fluid serves functions such as cleaning, lubricating, cooling, and sealing for the transmission. Due to the specific operating conditions inside the transmission, the quality of the transmission fluid has a limited lifespan. After this period, the performance of the fluid deteriorates, leading to increased impurities, which can accelerate wear on transmission components, cause premature failures, or increase the failure rate. The Corolla is a brand under Toyota, with model dimensions of 4630mm in length, 1775mm in width, and 1480mm in height. The Corolla is equipped with Michelin tires, high-performance shock absorbers, 17-inch sporty wheels, reinforced clutches, and high-performance brake pads, ensuring it has relatively ideal sports performance.
4
0
Share

Can yellowed car headlights be cleaned with cola?

Yellowed car headlights can be cleaned with cola, as cola has certain cleaning effects. This is because cola contains acidic substances such as carbonic acid and citric acid, which can dissolve some rust and grease. When cleaning, pour cola onto the headlights and wipe them with a clean towel. If the effect is not noticeable after one attempt, repeat the process several times. Finally, rinse with clean water and dry. Nowadays, most car headlight covers are made of polycarbonate or polymethyl methacrylate plastic through injection molding. Over time, they can become dirty, and if not cleaned promptly, they are prone to aging and yellowing, which reduces light transmission and dims the car's illumination, affecting driving. Additionally, the main cause of yellowing on car headlight surfaces is exposure to sunlight. Therefore, avoiding direct sunlight is a simple way to prevent headlights from yellowing. Whenever possible, park in shaded areas with cover.
5
1
Share

What are the consequences of driving without a driver's license?

Driving without a driver's license is not considered unlicensed driving but will result in a fine. The following is an introduction to the knowledge about unlicensed driving: 1. Definition: Unlicensed driving, as the name implies, refers to the act of driving a motor vehicle by a driver who has not obtained a driver's license, is driving a motor vehicle that does not match the permitted vehicle type, or whose driver's license has expired without being replaced with the corresponding legal driving certificate. 2. Penalty: If a motor vehicle driver allows a person who has not obtained a motor vehicle driver's license or whose motor vehicle driver's license has been revoked or temporarily suspended to drive, the motor vehicle driver's license will be detained, and the motor vehicle driver's license may also be revoked.
14
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.