What is the fuel tank capacity of the Audi A8 in liters?

How Often Should Mineral Engine Oil Be Changed?

Mineral engine oil generally needs to be changed every 5,000 kilometers or 6 months. Engine oil is divided into three types: full synthetic oil, semi-synthetic oil, and mineral oil. Among them, full synthetic oil should be changed every 10,000 kilometers or 1 year, while semi-synthetic oil should be changed every 7,500 kilometers or 7 to 8 months. The method for changing engine oil is as follows: 1. Use a jack to lift the vehicle, locate the drain plug, and loosen it to drain the oil; 2. Remove the oil filter and place a container underneath it; 3. Replace with a new oil filter and add new engine oil. The functions of engine oil include: 1. Reducing friction and high temperatures; 2. Cooling and lowering temperature; 3. Cleaning and purifying; 4. Dampening vibrations; 5. Preventing rust and corrosion.

2

Share

What are the Safe Driving Operation Standards?

Safe operating procedures for motor vehicle drivers. Strictly comply with traffic laws and regulations and relevant provisions: Drivers must have complete licenses and are not allowed to drive vehicles that do not match their licenses. Drunk driving is strictly prohibited, and passengers in the vehicle are required to fasten their seat belts. Before starting work each day, conduct routine checks on fuel, gas, water, and electrical systems, start the engine to observe if it operates normally, and ensure that various gauges, steering mechanisms, brakes, lights, etc., are responsive and reliable. Do not drive with known issues. When driving through water or flooded bridges, determine the route in advance. If the water depth exceeds the exhaust pipe, do not force passage and avoid stalling the engine. If forced to stall and stop on a slope, firmly apply the hand brake. Driving rules: Engage reverse gear when going downhill and forward gear when going uphill. The driver must not leave the vehicle. When driving through muddy or soft road sections, braking may cause wheel skidding or fishtailing, leading to accidents. The driver should stop to observe, choose flat, firm, or rutted sections to pass at low speed, and avoid sudden braking. On snow-covered roads, the reflection of light from the snow can easily cause driver glare and illusions. Maintain low-speed driving, avoid coasting downhill, use low gears to control speed, and prohibit sudden braking. When passing through intersections without traffic signals, signs, markings, or police direction, motor vehicles should slow down. When passing through uncontrolled intersections at night, reduce speed and alternately use high and low beams to signal. If a vehicle breaks down on the highway, after taking necessary safety measures as required by law, all occupants should quickly leave the vehicle and move to the right shoulder or emergency lane.

17

5

Share

Is the Qin Pro equipped with a wet dual-clutch transmission?

The Qin Pro is equipped with a wet dual-clutch transmission, with some models featuring BYD's self-developed 6-speed wet dual-clutch transmission. A wet dual-clutch transmission refers to a multi-plate clutch system where two clutches, one large and one small, are coaxially installed. Unlike dry dual-clutch transmissions, which operate in a semi-engaged state and are prone to overheating, the wet system avoids this issue. Taking the 2020 Beyond Edition BYD Qin Pro as an example, its body dimensions are 4765mm in length, 1837mm in width, and 1500mm in height, with a wheelbase of 2718mm. This model is powered by a 1.5L turbocharged engine, delivering a maximum horsepower of 160PS, a maximum power of 118kW, and a maximum torque of 245Nm.

11

2

Share

Where is the cabin air filter located in the Buick GL8?

The cabin air filter in the Buick GL8 is located inside the glove compartment on the passenger side. Before replacing the cabin air filter, it is necessary to remove the damping rods on both sides of the glove compartment. After removing the glove compartment, you will see a black rectangular cover plate. Then, you need to remove the clips to access the vehicle's cabin air filter. Taking the 2021 Buick GL8 as an example, its body dimensions are 5238mm in length, 1878mm in width, and 1776mm in height, with a wheelbase of 3088mm, a fuel tank capacity of 66 liters, and a trunk capacity of 475 liters. This model is equipped with a 2.0T turbocharged engine, delivering a maximum horsepower of 237 PS, a maximum torque of 350 Nm, and a maximum power of 174 kW, paired with a 9-speed automatic transmission.

10

3

Share

What Causes the Brake Pads of Golf 7 to Make Abnormal Noises?

Golf 7 brake pad abnormal noise causes: 1. Brake pads are too hard. 2. Brake pads are worn down to the skeleton. 3. Brake discs or drums are excessively worn. 4. Brake calipers are rusted. 5. Handbrake cable malfunction. 6. Brake pads do not retract properly. Possible scenarios and solutions for abnormal noises: 1. If it's a dull sound, it's mostly an issue with the brake caliper, such as worn sliding pins or detached spring plates. 2. If it's a squealing sound, there could be multiple issues, including problems with the caliper, brake disc, or brake pads. 3. If the noise persists, first check for dragging brakes; poor caliper retraction can cause prolonged friction between the disc and pads, leading to abnormal noises under certain conditions. Then, inspect whether there are any foreign objects stuck between the pads and disc. For new pads, check if the brake disc has grooves, as localized friction can cause abnormal noises. If the disc is fine, consider whether the brake pads are too hard or if the noise-reducing shims are installed incorrectly.

11

3

Share

Does a New Car Need Water Added?

A newly purchased car does not require water to be added. Regular passenger cars do not need water; instead, the radiator is filled with coolant, not water. Simply check if there is sufficient coolant in the radiator. If the coolant level is low, you can directly add coolant until it reaches the midpoint between the upper and lower level marks. Precautions during the break-in period of a new car include: 1. Maintain smooth starts, avoid sudden acceleration, and do not let the engine RPM get too high; 2. Ensure the coolant temperature reaches at least 50 degrees Celsius before starting, begin in a low gear, and shift to a higher gear after driving 1 kilometer; 3. Shift gears promptly while driving, avoid prolonged use of a single gear, and do not drive at low speeds in high gears or at high speeds in low gears; 4. Choose good road conditions to avoid excessive vibration and impact, and disengage the clutch before braking; 5. Use high-quality fuel and engine oil, and avoid using engine wear-resistant additives.

19

1

Share

What is the fuel tank capacity of the Audi A8 in liters?

How Often Should Mineral Engine Oil Be Changed?

What are the Safe Driving Operation Standards?

Is the Qin Pro equipped with a wet dual-clutch transmission?

Where is the cabin air filter located in the Buick GL8?

What Causes the Brake Pads of Golf 7 to Make Abnormal Noises?

Does a New Car Need Water Added?

What is the reason for the tire pressure monitoring warning on the Honda Civic dashboard?

Where is the oil dipstick for the Audi A4?

Does the Boyue have automatic parking function?

What does it mean when the ESP light is on in a vehicle?