What is the fuel consumption of the Haval F7x?

How to Drive an Automatic Transmission Car Uphill?

Shift the gear from P (Park) to D (Drive). P stands for Park, and D stands for Drive. (Note: Keep your right foot on the brake at this time.) If the slope is very steep, release the brake quickly and press the accelerator promptly, applying slightly more throttle. Of course, also ensure there are no obstacles ahead to prevent rear-end collisions.

20

2

Share

How to Shift Gears When the Battery of an Automatic Car Dies?

First, locate a plug with the word "SHIFT" near the gear lever of the vehicle. Then, use a pin to insert into the gap of the plug to pry it open. After that, you can remove the plug. Next, insert the car key into the small hole, or you can use another long object. Finally, you can shift the gear to the N (Neutral) position.

4

3

Share

Subject 3 Driving Test Tips and Procedures

Subject 3 driving test procedures are as follows: 1. Preparation before getting in the car: It is very necessary to check before getting in the car. First, walk around the car counterclockwise to confirm safety, check the four wheels, open the door, observe the rear again, adjust the seat and mirrors after getting in the car, fasten the seat belt, and press the fingerprint. 2. Night light simulation: The first test item of the 16 items in the Subject 3 test, the night light simulation randomly tests one of the five groups of lights. During the test, be sure to wait for the voice broadcast to end before answering, and do not rush to answer. After the voice broadcast, there is a 5-second answer time. Do not panic when answering. 3. Starting: When starting, first turn on the left turn signal, observe the rear traffic situation, confirm that it is safe, honk the horn, turn the steering wheel to the left, shift to 1st gear, release the handbrake, slowly lift the clutch, slightly press the accelerator, and complete the smooth starting operation. 4. Straight driving: When you hear the voice broadcast of straight driving, control the steering wheel with both hands, do not hold it too tightly, look ahead, find a reference, slightly adjust the direction according to the reference, the steering wheel should not exceed 5 degrees, just slightly adjust, keep a constant speed throughout the journey, and the car should not deviate. 5. Left turn at the intersection ahead: When the voice prompts a left turn at the intersection ahead, first turn on the left turn signal, press the brake to slow down, shift to 2nd gear, observe the traffic situation, confirm that it is safe and the turn signal has been on for 3 seconds, then turn the steering wheel to the left to turn. 6. Overtaking: After receiving the overtaking voice, first turn on the left turn signal, count 4 numbers in your mind, observe the rear traffic situation, confirm that it is safe, turn the steering wheel about 10 degrees to the left, change lanes, maintain a certain safe distance from the overtaken vehicle, turn off the left turn signal, turn on the right turn signal, observe the traffic situation, after the turn signal has been on for 3 seconds, turn the steering wheel about 10 degrees to the right, and return to the original lane. Note: Overtaking can only be done from the left side. Overtaking from the right side will directly fail the test. 7. Passing through a straight intersection: In some areas, there is no voice prompt for passing through a straight intersection. Students need to press the brake in advance to slow down, shift to 2nd gear, observe the traffic situation before and after when passing through the intersection, and be prepared to stop at any time. 8. Passing through a bus stop ahead: When passing through a bus stop, you need to press the brake in advance to slow down. If the system does not detect the deceleration, the test result will directly fail. 9. Right turn at the intersection ahead: When turning right ahead, you also need to slow down in advance, turn on the turn signal, press the brake in advance to slow down, shift to 2nd gear, observe the traffic situation. If there is a car waiting for the traffic light ahead, maintain a safe distance from the car in front, press the brake and clutch to stop, pull the handbrake, shift to neutral, and when starting, pay attention to controlling the clutch and accelerator to prevent the car from stalling or rolling. 10. U-turn ahead: After receiving the voice prompt for a U-turn ahead, first turn on the left turn signal, after it has been on for 3 seconds, observe the traffic situation, turn the steering wheel to the left to make a U-turn, slightly press the brake when making a U-turn, control the speed, observe the rear and left and right traffic lines to avoid the wheels pressing the line. After the U-turn is completed, press the accelerator and shift to 3rd gear. 11. Meeting: After receiving the voice prompt for meeting ahead, slow down, shift to 2nd gear, and maintain a horizontal safe distance from the meeting vehicle. The meeting project must not change lanes. Once the lane is changed, it will be disqualified. If there is an obstacle ahead that cannot pass, stop immediately in the original lane and wait until there is no obstacle ahead before starting again and driving straight until the end of the project. 12. Changing lanes: After receiving the voice prompt for changing lanes, first turn on the left turn signal, after it has been on for 3 seconds, observe the traffic situation, confirm that it is safe, turn the steering wheel about 10 degrees to perform the lane change operation. After the project is completed, remember to turn off the turn signal. Note that changing lanes can turn to the left or right lane. 13. Gear shifting operation: During the test, you need to accelerate in advance at the gear shifting project 20-30m. When shifting up, accelerate first, shift from 2-5 gears in order, do not skip gears when shifting up. When shifting down, slow down first, you can skip gears when shifting down, shift down from 5-2 gears. When shifting gears, control the steering wheel with your left hand, the vehicle must not deviate or press the line, operate the gear lever with your right hand, look ahead, do not look down at the gear. 14. Passing through the pedestrian crossing ahead: After receiving the voice broadcast, remember to press the brake to slow down. If you forget to press the brake, the test will directly fail. Shift to 2nd gear, observe the traffic situation before and after when passing through the pedestrian crossing, and be prepared to stop at any time. 15. Passing through the school area ahead: Passing through the school area is the same as passing through the pedestrian crossing. You need to press the brake in advance to slow down, shift to 2nd gear, observe the traffic situation, and be prepared to stop at any time. 16. Parking by the side: After receiving the voice prompt, first turn on the right turn signal, press the brake to slow down, shift to 2nd gear, observe the rear traffic situation, confirm that the turn signal has been on for 3 seconds, turn the steering wheel to the right, adjust the body to a 30cm distance from the side line, when adjusting the distance, observe the rearview mirror carefully to prevent the front and rear wheels from pressing the line. After parking, shift to neutral, pull the handbrake, turn off the turn signal, turn off the engine, turn around to observe the left rear traffic situation, confirm that it is safe before getting off the car, and close the door.

10

0

Share

How to Turn Off Automatic Headlights?

The automatic headlights will turn off automatically after the car is parked. After reducing the speed to 65km/h, the automatic headlights will turn off automatically after driving for 150 seconds. If the car's wipers are turned on and used continuously for more than 5 seconds, the automatic headlights will turn on. After the headlights are turned on, if the wipers are turned off and then used continuously or intermittently for more than 255 seconds, the automatic headlights will turn off automatically.

17

1

Share

How to perform a hill start with an automatic transmission car?

First, firmly engage the handbrake. Then, shift to D gear and release the foot brake. Gently press the accelerator until the engine RPM exceeds 2000, then release the handbrake, and the car will move up the slope.

13

4

Share

How to Properly Use the Pedals in an Automatic Car?

Before starting, press and hold the brake pedal. The car's gear should be placed in P (Park) or N (Neutral). After ignition, shift into the appropriate gear, such as Drive. Then, slowly release the brake pedal. For reverse gear, after lifting the brake pedal, apply the accelerator, making sure to control the accelerator pedal carefully.

3

0

Share

What is the fuel consumption of the Haval F7x?

How to Drive an Automatic Transmission Car Uphill?

How to Shift Gears When the Battery of an Automatic Car Dies?

Subject 3 Driving Test Tips and Procedures

How to Turn Off Automatic Headlights?

How to perform a hill start with an automatic transmission car?

How to Properly Use the Pedals in an Automatic Car?

What to Do When the D Gear of an Automatic Car Gets Stuck?

How to Open the Windows of an Automatic Transmission Car

How to Control Speed with Automatic Transmission Brakes?

What to Do When the Gear Switch of an Automatic Car Fails?