What are the differences between the Lexus NX300 and NX200?

How to Calculate Horsepower for a Vehicle?

Horsepower in a car refers to the unit of engine power, generally measured in metric horsepower rather than imperial horsepower. It can be calculated using a formula, which requires adjustments. The horsepower of a car is derived from torque, and the calculation formula is: Power (W) = 2π × Torque (N-m) × Speed (rpm)/60. Here is an introduction to engine horsepower: 1. Power is calculated from torque: The formula is: Power (W) = 2π × Torque (N-m) × Speed (rpm)/60. Simplified, it becomes: Power (kW) = Torque (N-m) × Speed (rpm)/9549. This is how the horsepower of a car is calculated. 2. Horsepower equals torque multiplied by speed, symbolizing how much air-fuel mixture the engine can intake per unit of time. Therefore, when the throttle is increased and the engine speed gradually rises to the point of maximum torque, although the intake volume per cycle has peaked, the speed continues to increase—meaning the number of intake cycles also increases. Thus, horsepower can still rise until it reaches the maximum horsepower point. Of course, the performance of a vehicle cannot be judged solely by horsepower and torque; it also depends on the matching of the transmission, tires, and the design of the body.

116

Share

How to Check a Car's Mileage?

To check a car's mileage, look at the odometer, usually indicated by ODO, with the value followed by the unit KM, which represents the car's total mileage. This helps the driver know the distance traveled. Due to differences in car models and brands, the dashboard display may vary. The car odometer consists of a stepping motor, a six-digit decimal counter, internal transmission gears, etc. Its function is to convert the pulse signal output by the vehicle speed sensor during operation into a specific frequency pulse signal through signal processing circuit frequency division and power amplification.

107

Share

Can a vehicle undergo an annual inspection in a different location?

Vehicles can undergo annual inspections in different locations. Based on the registered address information on the motor vehicle driving license, the owner needs to go to the local vehicle management office to apply for an entrustment for an out-of-town annual inspection. If there are any unresolved traffic violations in the place of use, they must be settled in advance. To apply for an entrustment for an out-of-town annual inspection, the following documents are required: the motor vehicle driving license, the original copy of the valid compulsory traffic liability insurance policy, and if the application is entrusted to someone else, the agent's identity proof must also be submitted. The process for an out-of-town annual inspection is as follows: 1. The vehicle owner needs to obtain a notice of entrustment for inspection from the original registration office of the vehicle management; 2. After preparing the required materials, the owner can then proceed to the local vehicle management office to conduct a relevant vehicle information inquiry, after which the normal out-of-town vehicle inspection can be processed.

117

Share

How to remove the rear seat backrest of the Besturn B50?

Besturn B50 rear seat backrest removal method: 1. Remove the rear seat and locate the two screws underneath; 2. Then remove the screws, slightly pull the backrest forward after removal, and lift it upward; 3. If it doesn't lift easily, use a flashlight to check inside the trunk for any obstructions—there might be a small hook-like clip holding the backrest in place. Release it and pull the backrest upward with force to successfully remove it. The Besturn B50 is a car independently developed by FAW Car, with body dimensions of 4615mm in length, 1785mm in width, and 1435mm in height. In terms of suspension, the Besturn B50 features a double-wishbone independent front suspension with a stabilizer bar.

104

Share

Where is the Kuga's air filter located?

The Kuga's air filter is located in the front passenger footwell. There are screw holes where the left foot would rest. Open a small cover on the central console to find it inside. The Kuga is a compact SUV introduced by Ford, with body dimensions of 4524mm in length, 1838mm in width, and 1701mm in height, and a wheelbase of 2690mm. In terms of exterior design, the Kuga features the brand's signature hexagonal grille, making it resemble a smaller version of the Edge. Under the hood, the Kuga is equipped with either a 1.6T EcoBoost or a 2.0T EcoBoost turbocharged engine.

120

Share

What is the ground clearance of the Kia K4?

The ground clearance of the Kia K4 is 131mm. The chassis serves to support and install the engine and its various components and assemblies, forming the overall structure, receiving the engine's power to enable vehicle movement and ensure normal driving. The chassis consists of four parts: the transmission system, the running gear, the steering system, and the braking system. The Kia K4 is a mid-size sedan with body dimensions of 4720mm in length, 1815mm in width, and 1465mm in height. In terms of exterior design, the Kia K4 features a large-sized grille decorated with crisscrossed chrome bars in a window-style pattern, integrated with the bumper to create a bold front fascia.

103

Share