What are the contents of Subject 3?

[ArcherDella]

Subject 3 test includes road driving skills test and safety and civilized driving knowledge test. The following is an introduction to the contents of Subject 3 test: 1. Road driving skills test includes: preparation before getting on the car, light simulation test, starting, driving in a straight line, shifting gears, changing lanes, parking by the roadside, going straight through intersections, turning left at intersections, turning right at intersections, passing crosswalks, passing school areas, passing bus stops, meeting vehicles, overtaking, turning around, and driving at night. 2. Safety and civilized driving knowledge test includes: safety and civilized driving operation requirements, safe driving knowledge under bad weather and complex road conditions, emergency handling methods in case of tire blowout and other emergencies, and handling knowledge after traffic accidents.

[VanTeagan]

The content of the Subject 3 driving test is quite extensive, and I think it can mainly be divided into two parts: basic driving skills and road operation. Before getting into the car, you need to walk around the vehicle to check the lights and chassis condition, and remember to use the turn signal and check the rearview mirror when starting. The road driving section includes driving in a straight line, shifting gears up and down, and special attention should be paid to the use of turn signals when changing lanes or overtaking in traffic. You must slow down to below 30 km/h when passing crosswalks or school zones to simulate yielding to pedestrians. Pulling over is an important test point, requiring the tires to be no more than 30 cm from the curb, and the engine must not stall. Throughout the process, safe and civilized driving awareness is always emphasized, such as practicing light usage skills more during night tests. Although there are many details, running a few more laps on the simulated route can help you familiarize yourself with the key operations.

[JesseDella]

The project setup for the Subject 3 driving test emphasizes practicality. The main components I experienced include pre-driving preparations, starting off, driving in a straight line, and gear shifting operations, all of which assess basic driving skills. When changing lanes, you must use the turn signal and wait for three seconds, and when approaching intersections, you need to slow down in advance and observe carefully. Special sections like bus stops and school zones require attention to voice prompts and timely responses. The most challenging part of parking is controlling the precise distance from the curb, where many people lose points. The night driving section also requires mastering the timing of switching between high and low beams. Overall, the test focuses on cultivating safe driving habits rather than showing off skills. In daily practice, I recommend focusing on mastering lane changes and parking.

[SiennaRose]

The driving test for Subject 3 taught me many practical skills. It includes basic procedures such as starting the vehicle, driving straight, and gear shifting. You must slow down when encountering pedestrian crossings and be mindful of stopping near bus stops. Proper observation through the rearview mirror is essential when changing lanes or overtaking. The test also covers left turns, right turns, and U-turns, with signaling and checking road conditions before turning being crucial. Parking requires stopping in designated areas while maintaining proper distance from the edge line. The entire exam emphasizes attention to safety details.

[LaChristian]

The design of the Subject 3 driving test is highly systematic. A pre-drive vehicle inspection is a basic requirement, and the starting procedure must include fastening the seatbelt and checking the mirrors. The road driving section covers straight-line driving, gear shifting, and navigating special zones. Lane changing and overtaking emphasize maintaining a safe distance. Mandatory test items include right-angle turns and parallel parking, the latter requiring parking within 30 centimeters of the curb. Proper use of lights is emphasized throughout, such as alternating high beams during night tests. In practice, I've found that smooth starts and parking precision are the most critical skills.

[LaEmilio]

The content of the Subject 3 driving test is divided into the preparation phase and the road test section. During preparation, it is important to perform a vehicle walk-around check and adjust the seat and mirrors. The starting phase requires smooth operation without stalling, while the driving section includes straight-line driving, gear shifting operations, and lane changing or overtaking. When approaching intersections, it is necessary to slow down and honk to signal. In school zones, the speed must be reduced to below 30 km/h. The U-turn operation tests the ability to control direction, and the roadside parking assesses distance judgment. Throughout the test, it is essential to pay attention to the examiner's instructions and respond promptly. I find the most challenging part to be coordinating the turn signal and observing the movement of vehicles behind while changing lanes or overtaking.