Is the Mercedes-Benz E-Class Considered a 'Big Benz'?

How often should the coolant in the Leiling be replaced?

The coolant in the Leiling should be replaced every two years or 40,000 kilometers. Coolant prevents the freezing of the cooling liquid during cold winter parking, which could otherwise crack the radiator and damage the engine cylinder block. Its full name is antifreeze coolant. Many people think that coolant is only used in winter, but in fact, it should be used all year round. The Leiling is a compact 4-door, 5-seater sedan with dimensions of 4640mm in length, 1780mm in width, and 1455mm in height, and a wheelbase of 2700mm. This car is equipped with a 1.2T turbocharged engine and a CVT continuously variable transmission, delivering a maximum power of 85 kW and a maximum torque of 185 Nm, with a front-wheel drive system.

2

1

Share

How to Measure Cylinder Pressure?

To measure cylinder pressure, follow these steps: 1. Use compressed air to clean the dirt around the spark plugs, then remove all spark plugs. For gasoline engines, also disconnect the ignition system's secondary high-voltage wires and securely ground them to prevent electric shock or fire. 2. Insert the conical rubber tip of the dedicated cylinder pressure gauge into the spark plug hole of the cylinder being measured, ensuring it is properly aligned and tightly sealed. 3. Fully open the throttle (and the choke if equipped), then use the starter to rotate the crankshaft for 3 to 5 seconds (at least 4 compression strokes). Stop rotating once the pressure gauge needle indicates and maintains the maximum pressure reading. 4. Remove the pressure gauge, record the reading, and press the one-way valve to reset the gauge to zero. Repeat this process for each cylinder, measuring each cylinder at least twice. Calculate the arithmetic mean of the measurements for each cylinder and compare the results with standard values to analyze and assess the cylinder's working condition.

17

5

Share

How to Replace the Air Conditioning Filter in a Honda Vezel?

Honda Vezel replacing the air conditioning filter method is: 1. Remove the glove box by pressing inward on these two positions of the glove box. Although the glove box is already open, the left damping hook is still connected; 2. Press down hard on this damping hook, and then you can remove the glove box; 3. Open the cover outside the air conditioning filter, there are clips on both sides, and then you can remove the old air conditioning filter; 4. Replace with a new air conditioning filter according to the direction. The Honda Vezel is a compact SUV with dimensions of 4328mm in length, 1772mm in width, and 1605mm in height, a wheelbase of 2610mm, and a body type of a 5-door, 5-seat SUV.

9

2

Share

How to Replace the Rear Brake Pads on the Envision?

The method for replacing the rear brake pads on the Envision is as follows: 1. Release the handbrake and loosen the hub screws of the wheel where the brake pads need to be replaced, then use a jack to lift the car and remove the tire; 2. Remove the tire to expose the brake caliper and brake disc, and apply lubricant to the screws or nuts that need to be loosened or removed; 3. Hang the brake caliper with a rope and remove the old brake pads; 4. Open the hood and unscrew the cover of the brake fluid reservoir; 5. Install the new brake pads in the correct position. The Envision has a length, width, and height of 4694mm, 1839mm, and 1686mm respectively, with a wheelbase of 2750mm. It is a 5-door, 5-seat SUV with a 7-speed dual-clutch transmission.

17

2

Share

Where is the anti-theft screw of BMW X1?

The anti-theft screw of the BMW X1 is located under the floor of the vehicle's trunk, near the tire removal tools. Its anti-theft principle involves machining the outer diameter of the screw into an irregular shape, which requires the use of a dedicated removal tool specific to the wheel to remove it. The BMW X1 is a compact SUV introduced by BMW Brilliance, with dimensions of 4565mm in length, 1821mm in width, and 1620mm in height, and a wheelbase of 2780mm. It is equipped with either a 1.5T L3 or a 2.0T L4 turbocharged engine, with maximum power outputs of 103kw and 141kw respectively, paired with a 7-speed dual-clutch or an 8-speed automatic transmission.

13

1

Share

What items are included in a major car maintenance service?

Major car maintenance service includes: 1. Replacing transmission fluid, timing belt, brake fluid, power steering fluid, and coolant; 2. Inspecting and maintaining the engine, transmission, air conditioning system, steering system, braking system, suspension, body, and tires. Major maintenance is based on the existence of minor maintenance, and these two types of maintenance are generally performed alternately. The interval varies depending on the car brand, and specific recommendations should follow the manufacturer's guidelines. Car maintenance refers to the periodic preventive work of inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing.

13

3

Share

Is the Mercedes-Benz E-Class Considered a 'Big Benz'?

How often should the coolant in the Leiling be replaced?

How to Measure Cylinder Pressure?

How to Replace the Air Conditioning Filter in a Honda Vezel?

How to Replace the Rear Brake Pads on the Envision?

Where is the anti-theft screw of BMW X1?

What items are included in a major car maintenance service?

Is It Necessary to Install a Radiator Guard?

How to Shift an AT Transmission?

Will I Receive a Notification for Traffic Violations on My Car?

What is the fuel consumption of the BJ40 off-road vehicle?