···
Log in / Register

Is it a traffic violation for the passenger to put their feet on the dashboard?

5Answers
Roberto
07/28/2025, 04:03:46 PM

It is not a traffic violation, but it is best to practice civilized riding and driving; if you feel tired during the journey, reclining the seat back is more elegant and comfortable than placing your feet on the windshield. Below is relevant information: The passenger-side airbag is installed in front of the front passenger seat, usually above the glove compartment on the dashboard. Normally, care should be taken to ensure there are no obstacles in this space to prevent the airbag from failing to deploy. If someone is sitting in the front passenger seat, they must wear a seatbelt. According to the Road Traffic Safety Law, when a motor vehicle is in motion, passengers in the front seat must also use seatbelts. The requirement for front passengers to wear seatbelts was clearly stipulated in the old traffic regulations. Any passenger in the front seat not wearing a seatbelt can be fined 20 yuan by the traffic police on duty.

Was this review help?
105
Share
MacOlive
08/11/2025, 07:49:07 PM

I think putting feet on the dashboard from the passenger seat is both dangerous and potentially against regulations. From a safety perspective, this can obstruct the driver's view and interfere with operations while driving. In the event of a crash, the airbag deployment could crush the legs or even cause fractures, which is terrifying. I often see cases in traffic programs where people end up in the hospital due to this habit. Although the law doesn't specify it in detail, the Road Traffic Safety Law states that passengers must not engage in any behavior that affects driving safety. Police may issue warnings or fines if they observe such behavior, especially in busy urban areas. I believe both drivers and passengers should pay attention to safety details, avoid seeking temporary comfort, and develop proper sitting postures with seat belts fastened. It's advisable to regularly discuss these small matters with family and friends to prevent accidents.

Was this review help?
1
Share
Expand All
RuthLynn
09/30/2025, 02:37:04 AM

This is definitely not a good idea and is more likely to be considered a violation. I've studied traffic regulations, and according to the Road Traffic Safety Law, if the behavior of a passenger in the front seat interferes with safe driving, it can be deemed a traffic violation. At best, you might get a warning from the traffic police, and at worst, you could face a fine ranging from tens to hundreds of yuan. Don't underestimate this action—it not only increases the risk of accidents but could also cause the airbag to fail, leaving you unprotected in a critical moment. I believe everyone should have basic common sense: a car is a public space, and maintaining cleanliness and discipline is important. When I drive, I never allow anyone to do this, and I always remind my family and passengers to sit properly. Safety is no small matter—think about the consequences and don't pay the price for a few minutes of relaxation.

Was this review help?
10
Share
Expand All
VanCali
11/13/2025, 03:28:47 AM

From my daily observations, putting feet on the dashboard is indeed dangerous. Whether it directly violates traffic rules depends on the situation, but it's absolutely not recommended. I had an experience: once a friend did this on the highway and almost fell due to sudden braking. Since then, I've never dared to do it again. Although the regulations are vague, this behavior can easily be treated by traffic police as obstructing safety, especially in the event of an accident. It exposes the feet to the path of the airbag, and the legs can be broken upon impact. It's advisable to develop good habits, sit properly as soon as you get in the car, to protect yourself and respect others. Don't take chances, as small things can lead to big troubles.

Was this review help?
3
Share
Expand All
OElaina
01/03/2026, 10:21:43 PM

I think this behavior by the passenger is terrible, potentially violating regulations and harmful to health. In terms of safety, dashboard design and airbag systems may fail due to foot obstruction, and in the event of a collision, severe leg injuries could lead to terrifying consequences. Legally, it may not be explicitly considered a violation, but any action that hinders driving could result in penalties—I've seen news reports of similar cases receiving warnings. I advise everyone to pay attention to their posture and educate children or friends not to prioritize comfort over safety. Forming good habits isn't easy, but reminding yourself to sit properly every time you get in the car can reduce accidents. Learning more about driving knowledge helps us collectively maintain traffic order.

Was this review help?
2
Share
Expand All
More Q&A

What is the issue with P2188 Cylinder Bank 1 System Too Rich at Idle?

P2188 Cylinder Bank 1 System Too Rich at Idle refers to an excessive fuel delivery issue. The following are the potential causes of this fault: 1. Air leak in the intake pipe from the turbocharger to the throttle; 2. Faulty mass air flow sensor; 3. Faulty turbocharger pressure sensor; 4. Mechanical failure of the turbocharger; 5. Wiring fault in the mass air flow sensor or turbocharger pressure sensor; 6. Leak in the engine crankcase ventilation system; 7. Faulty carbon canister purge valve system; 8. Engine control unit failure; 9. Exhaust system faults such as a clogged catalytic converter.
108
Share

What is the tutorial for adjusting the height of high beams?

High beam height adjustment tutorial is as follows: 1. Adjust the light position: This is achieved by turning the corresponding adjustment knobs located at the back of the headlights. The specific parts to be adjusted and the tools required vary depending on the vehicle model. Before adjusting, aim the headlights at a wall and observe whether the light is misaligned, too high, or too low. 2. The adjustment wheel is marked with numerical gears: The numbers indicate the height of the headlights, with higher numbers corresponding to higher beam positions. For example, position 0 is the initial setting, typically for when the vehicle has only the driver or the driver plus one front passenger; position 1 is for a fully occupied vehicle with no cargo in the trunk; position 2 is for a fully occupied vehicle with evenly distributed cargo in the trunk; and position 3 is for the driver only with evenly distributed cargo in the trunk.
105
Share

How to Use Clutch and Brake When Going Downhill

There are two scenarios for using clutch and brake when going downhill: 1. Short and gentle slope: For small and short slopes, simply use the brake to control vehicle speed; 2. Steep and long slope: For steep and long slopes, shift to a lower gear in advance to utilize engine braking for speed control, while coordinating with brake application for deceleration. Precautions when going downhill: 1. Check braking performance: Always inspect braking effectiveness before descending to eliminate safety hazards. 2. Avoid coasting in neutral: Before descending, ensure the vehicle enters the downhill section at a controllable speed by selecting an appropriate low gear according to the slope gradient. Regardless of slope steepness, coasting in neutral is not recommended. Properly utilize engine braking to reduce vehicle inertia speed.
116
Share

What does KERS on a car mean?

KERS stands for the Kinetic Energy Recovery System. Its fundamental principle is to store the vehicle's braking energy through technical means and release it as auxiliary power during the car's acceleration process. The following are the constraint clauses in the new regulations: 1. Power requirements: The maximum output and input power of the KERS system must not exceed 60KW, and the total energy released per lap must not exceed 400KJ. 2. Racing requirements: During the refueling process in the pit, no additional energy storage can be added to the KERS system. The racing engine, gearbox, clutch, differential, KERS, and all related activation mechanisms must be controlled by the ECU provided by the FIA-designated ECU supplier (i.e., the standard ECU provided by McLaren).
116
Share

What does engine start-stop mean?

Engine start-stop is a very practical automotive energy-saving and emission-reduction technology. It automatically shuts off the engine when the vehicle comes to a temporary stop during driving (such as waiting at a red light). When it's time to move forward again, the system automatically restarts the engine. There are two main types: 1. Basic start-stop technology: The engine automatically turns off when the car encounters a red light or traffic jam, and promptly restarts when the driver releases the brake pedal or steps on the clutch (or accelerator pedal). 2. Advanced start-stop technology: Equipped with brake energy recovery function, it can convert part of the braking energy into electricity to charge the battery. In hybrid vehicles, the start-stop system is an important component of the powertrain.
112
Share

What's the matter with incorrect flow rate in the fuel tank venting system?

p0441 The reasons for incorrect flow rate in the fuel tank venting system: The activated charcoal canister is leaking or blocked. Here’s how to prevent vent hole blockage: 1. Regular inspection: Frequently check the vent holes to prevent potential issues. 2. Pay attention to airflow sounds: When refueling, listen for the sound of airflow when opening the fuel tank cap. One is the sound of air escaping, which is normal and common in summer; the other is the sound of air being sucked in. If you hear the latter, it indicates that the pressure inside the fuel tank is lower than the external pressure, which is likely due to a blocked vent hole. 3. Cover the vent hole with a screen: The vent hole is made of metal, so it's best to wrap it with a screen. For plastic hose vent holes, point the opening downward to avoid blockage.
117
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.