How to Use Cruise Control in the Trumpchi GS3?
3 Answers
Trumpchi GS3 cruise control is adjusted via the buttons on the right side of the steering wheel. Below are the instructions for using cruise control: 1. Instructions: Activate Cruise Control: Briefly press the cruise control button to enter cruise control mode, then release the accelerator pedal. Deactivate Cruise Control: Press the brake pedal, shift the gear lever to "N" (neutral), or briefly press the cruise control button. Resume Cruise Control: When the speed is above 40 km/h, briefly press the resume/accelerate button. Increase Cruise Speed: Briefly press the resume/accelerate button; each press increases the speed by 1.6 km/h. Decrease Cruise Speed: Briefly press the set/decelerate button; each press reduces the speed by 1.6 km/h. Hold down the set/decelerate button to continuously decrease speed. Release the set/decelerate button to maintain the lower speed. Function: Once the driver sets the desired speed, the vehicle automatically maintains that speed without needing to press the accelerator pedal, ensuring consistent driving. This reduces driver fatigue, minimizes unnecessary speed changes, and saves fuel.
As a driver who frequently takes the GAC Trumpchi GS3 on the highway, I find the cruise control operation quite straightforward. First, ensure your speed is above 40 km/h on a straight and clear road. On the right side of the steering wheel, there's a cruise control area: the ON/OFF switch is in the middle—just press it lightly to activate the system. Once you reach your desired speed, say 80 km/h, simply press the SET button to lock it in, and the car will maintain that speed automatically. To accelerate or decelerate, use the + or - buttons, adjusting by about 5 km/h each time. To cancel, lightly tap the brake or use the CANCEL button on the steering wheel. If you want to resume your previous speed later, just press the RESUME button for an instant return. I often use it on long trips to save leg effort, but never in urban areas or on curves—safety first! Regularly check the braking system to avoid accidents. Remember, keep your hands on the wheel even with cruise control on, and turn it off in heavy traffic to stay alert.
The cruise control on the Trumpchi GS3 is quite standard in configuration and easy to operate. There's a small label on the steering control lever marked CRUISE: switch to the ON position to activate, then accelerate to your desired speed and press SET to maintain it. The speed adjustment buttons allow for fine-tuning, and the system deactivates immediately when you hit the brakes. Press RES to resume the original speed. With years of driving experience, I find this feature incredibly useful on highways—it reduces fatigue, but you must stay alert to road conditions. Avoid using it in slippery conditions like rain or snow. Ensure your vehicle settings are correct, tire pressure is normal, and the system is free of faults. It significantly enhances comfort on long trips, but make it a habit to regularly maintain the cruise circuit to prevent rust. Beginners should practice a few times on open roads to familiarize themselves with button locations and response times, avoiding panic in emergencies.
