How to reset the maintenance reminder on an old Polo?

[AlexisLynn]

The method to reset the maintenance reminder on an old Polo is as follows: Turn off the ignition switch, then press and hold the odometer hour reset button while turning the ignition switch back on. After ignition, the reminder message will still be displayed. Within 30 seconds, press and hold the odometer hour reset button for approximately 3 seconds, and the reminder message will be completely cleared. Additional information: 1. Automotive maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain components of a vehicle, also known as vehicle upkeep. Maintenance primarily includes the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, and other related components. 2. The purpose of automotive maintenance is to keep the vehicle clean and tidy, maintain normal technical conditions, eliminate potential hazards, prevent failures, slow down the deterioration process, and extend the service life.

[DiJune]

I've been repairing Volkswagen cars for many years, and clearing the maintenance reminder on the old Polo is quite simple. First, insert the car key but don't start the ignition. Then, press and hold the small button on the right side of the dashboard without releasing it. At this point, turn the key to the power-on position, and you'll see a countdown icon appear on the dashboard. Wait for the countdown to finish, which takes about 10 seconds, then release the button and turn off the power. Restart the car, and you'll notice the reminder is gone. You might need to try this operation a few times, as sometimes it doesn't work if the button isn't held long enough or the steps are out of sequence. If it still doesn't work, you should check if there's poor contact in the dashboard wiring—older cars often have minor issues with electronic components. Remember to keep the battery voltage stable during the operation to avoid power interruptions affecting the reset effect.

[DiMaya]

My old Polo has been running for almost ten years, and I've always handled the maintenance reminder myself. The procedure is simple: First, sit in the car without starting the engine, then press and hold the small black button at the bottom right of the instrument panel. Next, turn the key to the position where the dashboard lights up. You'll see the screen flash and start a countdown. Count silently to 10 seconds before releasing the button and turning off the key. After restarting the car, the annoying reminder will disappear. The key is to keep your finger steady while pressing the button – if you loosen your grip even slightly, you'll have to start over. Last time, my wife tried it and had to repeat the process twice because she released the button too quickly. If the button is broken, you'll have to visit the shop to get a new one.

[OLiam]

As a long-time Polo owner, I'm very familiar with resetting the maintenance reminder. First, insert the key without starting the engine, and hold down the button next to the odometer all the way. With your other hand, turn the key to the ignition position while keeping an eye on the dashboard changes. When you see the countdown appear, don't panic - steadily count to 10 seconds before releasing the button and turning off the ignition. Finally, restart the engine. Be careful not to press any other buttons during the operation, as debris in the car might accidentally trigger switches. Remember to check if the actual mileage displays correctly after resetting. This method should definitely clear the reminder for most older Polos - if it doesn't work, consider whether the data wasn't completely cleared during the last maintenance.