How to reset the maintenance light on the Great Wall H6?
4 Answers
The method to reset the maintenance light on the Great Wall H6: 1. Turn on the ignition switch to power the car, keeping the engine off; 2. Press the reset button once, and the display will show the reset system; 3. Each press of the reset button will switch to the next reset system; 4. Select the maintenance reset system and hold the reset button for about 3 seconds; 5. When the relevant icon appears on the instrument display, it indicates that the maintenance reset was successful. The Great Wall H6 is a model under the Haval brand. The dimensions of this car are 4640mm in length, 1825mm in width, and 1690mm in height, with a wheelbase of 2680mm. The Haval H6 uses two engines: one is a 1.5-liter turbocharged engine, and the other is a 2.0-liter turbocharged engine. These engines are paired with either a 6-speed manual transmission or a 7-speed dual-clutch transmission.
Last month I just managed to reset the maintenance light on my Great Wall H6 by myself, and it felt really good. After turning off the car, I sat in the driver's seat, fiddled with the TRIP button on the dashboard, held it down, then turned the key to the ON position without starting the engine. After waiting about seven or eight seconds, the light went off. If there's no response, just try a few more times. I guess this design is meant to remind us to service the car every 5,000 kilometers or six months. The maintenance items are quite crucial, like checking the engine oil, brake pads, and even the cabin air filter, to prevent small issues from becoming big problems. I'm usually pretty busy, so learning this saved me a trip to the 4S shop and some money too, since a single maintenance service can cost several hundred yuan. Resetting the light promptly after maintenance gives a clear picture of the car's condition and offers peace of mind. In short, paying attention to these little tricks makes driving much more reassuring.
Resetting the maintenance light on the Great Wall H6 is not difficult, as I've done it step by step several times. First, turn off the vehicle and locate the TRIP button on the instrument panel, pressing and holding it with your finger. Then, rotate the ignition switch to the ON position without starting the engine, and wait for 5 to 10 seconds until the maintenance indicator light goes off. If it fails the first time, check if the button is firmly pressed and try again. This method is derived from the vehicle's system design, aiming to reset the maintenance counter. Regular maintenance is crucial, involving oil changes, filter replacements, etc., to enhance engine lifespan and fuel efficiency. Neglecting the reset may not affect driving safety but could lead to misunderstandings about the maintenance cycle, increasing future repair costs. I recommend checking the owner's manual before and after the operation to confirm details and avoid mistakes.
The way I reset the maintenance light on my Great Wall H6 is to hold down the TRIP button after turning off the engine, turn the key to the ON position without starting it, wait a few seconds until the light goes out, and that's it. It's very simple and doesn't require any tools. The purpose of the maintenance light is to remind you to service the car on time, usually checking the oil, brakes, etc., every 5,000 kilometers. Doing this yourself doesn't cost anything, whereas going to a shop means waiting for someone else to handle it. Resetting it promptly helps keep track of the car's condition and prevents potential issues.
