How to Reset the Maintenance Light on a Chery Car?

[VanSimon]

To reset the maintenance light on a Chery car, follow these steps: 1. With the engine off, press and hold the short-distance counter reset button located below the tachometer. 2. Turn the ignition to the ON position, then release the short-distance counter reset button. The display will show the "service" indicator. 3. Pull out the minute button on the clock and turn it to the right. The mileage will appear on the display. 4. Turn off the engine to reset the reminder message. 5. Turn the ignition to the ON position again, and the maintenance light will disappear. Chery's models include the Tiggo 8, Tiggo 5x, Tiggo 3x, Tiggo 3, and Arrizo 5e, among others.

[Vanessa]

I remember the maintenance light on the Chery Arrizo 5 was quite annoying, as it required manual reset. Typically, after turning off the engine, you sit in the driver's seat, press and hold the Trip reset button on the dashboard, then turn the key to the ON position without starting the engine, and hold for about ten seconds until the maintenance light turns off. If that doesn’t work, try pressing the ODO button along with other dashboard buttons for a few seconds—different models have different button layouts. The maintenance light doesn’t affect driving, but its constant blinking reminder for service might lead to neglecting regular maintenance over time. It’s best to check around every 5,000 km to avoid engine oil sludge or wear. I recommend checking the owner’s manual first—it has the most accurate steps. If you can’t find it, visit a 4S shop and let the technician reset it for free. Never randomly pull fuses.

[MacColeman]

I've been driving this Chery Tiggo 8 for several years and reset the maintenance light myself every time it comes on. The operation is quite simple: After turning off the engine, hold down the small button next to the odometer, turn the key to the power-on position without starting the engine, and wait for it to flash a few times to reset. Don't press too hard to avoid damaging the button. If the light remains on, it might be because the last maintenance wasn't reset or there's a minor circuit issue. It's recommended to record maintenance dates in advance and glance at the dashboard before driving. If you can't clear it, check the manual or contact the 4S store via WeChat—they can provide remote guidance. Remember not to perform this operation on the highway; safety comes first. Regular maintenance can save fuel and extend the vehicle's lifespan.

[BrynleeFitz]

Common methods to reset the Chery maintenance light include turning off the ignition, holding down the Trip reset button, and turning on the power without starting the engine. Hold for about 10 seconds until the light goes off. If unsuccessful, check the instrument panel button combinations—sometimes the ODO or menu button is required. After resetting, confirm the next maintenance interval is correct. This reminds owners to change oil by mileage; long-term neglect may cause mechanical damage. The manual is the authoritative guide, as procedures vary greatly between models like Arrizo and Tiggo. Consult a service center if issues persist.

[NadiaAnn]

The maintenance light stays on to remind you it's time for service. To reset it on a Chery car, simply turn off the engine, press and hold the dashboard reset button, turn the key to the ON position without starting, and hold for about 15 seconds until the light goes off. If unsuccessful, try other button combinations or check the fuse. Always reset before long trips to ensure effective reminders and avoid increased engine wear and higher fuel consumption. It's best to follow the manual as models like Tiggo7 may have slightly adjusted steps. From a safety perspective, driving with the light on won't affect operation, but regular maintenance is crucial.

[Ria]

As a long-time Chery owner, I know the maintenance light can be reset DIY. Turn off the engine, hold the Trip button on the dashboard, turn on the power and wait for the light to flash for reset. Steps vary by model - for example, Arrizo uses a button combination. After resetting, check that the system is normal. Not resetting the maintenance light promptly may cause part wear and affect vehicle lifespan. It's recommended to follow the manual's steps every 5,000 km. If confused, visit Chery's official forum or drive directly to an authorized service center for free technician guidance.