How to Replace the Brake Pads of an Electronic Parking Brake?

Why Does the Crankcase Need Ventilation?

If the crankcase is not ventilated, it will cause excessive pressure inside the crankcase, which can affect the downward movement of the pistons and compromise the sealing performance of the crankcase. Therefore, crankcase ventilation is necessary. More details about the crankcase are as follows: 1. The car's engine has a power stroke, during which some of the high-pressure gases in the combustion chamber enter the crankcase through the piston rings. 2. If the exhaust gases in the crankcase are directly released into the atmosphere, it would pollute the air. Hence, the engine is equipped with a dedicated crankcase ventilation system. This system directs the exhaust gases from the crankcase into the intake manifold, allowing them to re-enter the combustion chamber for further combustion. 3. Another important component in the forced crankcase ventilation system of a car engine is the oil separator. The oil separator's function is to separate oil vapors. If the oil vapors are not separated, they will also enter the combustion chamber and participate in combustion, leading to severe carbon buildup in the engine and causing the engine to burn oil.

10

0

Share

Where is the drain hole location on the Sylphy's door?

The drain holes on the Sylphy's doors are concealed behind the lower door seals for aesthetic reasons, making them not immediately visible. You'll need to slightly lift the seal to locate them. If these drain holes become clogged, rainwater can accumulate inside the door, potentially causing serious malfunctions. Relevant information about the Sylphy: 1. Positioning: The Sylphy is a mid-size sedan under Dongfeng Motor Co., Ltd., and is one of China's most representative mainstream family cars. 2. Powertrain: The Sylphy is equipped with a 1.6L naturally aspirated engine compliant with China's National VI emission standards, delivering a maximum power of 99kW (135 horsepower) and peak torque of 159Nm, paired with a CVT transmission system.

15

3

Share

Can the vehicle body cross the line during a right-angle turn?

During a right-angle turn, the vehicle body can cross the line, but the wheels must not press on the line. Below are some precautions regarding vehicle turns: Urban road turns: Slow down and yield. Urban areas have heavy traffic and many pedestrians. Before turning, activate the turn signal to indicate your intention. Follow the principle of 'slow down, look, and then proceed,' and always pay attention to the inside of the curve to avoid hitting pedestrians. Turns in rainy or foggy weather: Poor visibility in such conditions requires extra caution. When approaching a curve, sound the horn in advance. Keep the parking lights and fog lights on during the drive to make your vehicle's status and position visible to others, and reduce speed when meeting oncoming traffic. Intersection turns: Observe both sides. When turning at an intersection, check all directions to avoid collisions. For left turns, pay attention to traffic signs, activate the turn signal in advance, and try to minimize the turning radius.

13

3

Share

What are the penalties for illegal U-turns by small cars?

Penalties for illegal U-turns by small cars are as follows: 1. Making a U-turn at a left-turn intersection: This constitutes the traffic violation of not driving in the designated lane, with a fine of 200 yuan and 2 demerit points. 2. Making a U-turn at a straight-driving intersection: This also constitutes the traffic violation of not driving in the designated lane, with a fine of 200 yuan and 2 demerit points. 3. Making a U-turn on a road section with a solid center line: This constitutes the traffic violation of violating prohibited markings, with a fine of 100 yuan and 3 demerit points. 4. Making a U-turn at locations such as crosswalks or bridges: This constitutes the traffic violation of making a U-turn at a prohibited location, with a fine of 100 yuan. 5. Making a U-turn on a highway: This constitutes the traffic violation of a motor vehicle crossing the central isolation facilities on a highway to make a U-turn against regulations, with a fine of 200 yuan and 12 demerit points.

13

2

Share

Analysis of the New Generation Hongqi CA4GC20TD

The new generation Hongqi CA4GC20TD is a third-generation turbocharged direct-injection gasoline engine independently developed by FAW Group. Power of CA4GC20TD: The CA4GC20TD meets the China VIb emission standards, with a combustion thermal efficiency of up to 39%. The high-power version has a rated power of 185kW and a maximum torque of 380Nm, while the low-power version has a rated power of 165kW and a maximum torque of 340Nm. It not only delivers powerful performance but also maintains excellent fuel economy, making it a leading and trustworthy engine. Technologies of CA4GC20TD: The CA4GC20TD incorporates ten industry-leading technologies: high-compression-ratio Miller cycle combustion technology, 350bar precise fuel injection technology, full-MAP intelligent thermal management technology, all-aluminum lightweight engine technology, two-stage variable displacement oil pump, electronically controlled high-response twin-scroll turbocharger, ultra-low friction energy-saving technology, integrated dual-balance shaft system, efficient 48V mild hybrid system, and small-pitch silent chain.

16

5

Share

How to reset the maintenance light on SAIC Maxus V80?

The method to reset the maintenance light on SAIC Maxus V80 is as follows: 1. Turn off the ignition switch. 2. While turning on the ignition switch, press and hold the odometer hour reset button. 3. Within 30 seconds, press and hold the odometer hour reset button for about 3 seconds. The prompt message will completely disappear, indicating that the maintenance light has been reset. Below is more information about the SAIC Maxus V80: 1. The Maxus V80 is a commercial MPV meticulously developed by SAIC Maxus Automobile Co., Ltd. in accordance with European automotive design standards and cutting-edge energy-saving and environmental protection concepts. It is suitable for mobile business, commuting, and tourism, while also serving urban logistics and special industry purposes. 2. The Maxus V80 is equipped with a 2.5T turbocharged high-pressure common rail diesel engine, with a maximum power of 100kW and a peak torque of 330Nm, paired with a 6-speed manual or 6-speed AMT transmission.

6

0

Share

How to Replace the Brake Pads of an Electronic Parking Brake?

Why Does the Crankcase Need Ventilation?

Where is the drain hole location on the Sylphy's door?

Can the vehicle body cross the line during a right-angle turn?

What are the penalties for illegal U-turns by small cars?

Analysis of the New Generation Hongqi CA4GC20TD

How to reset the maintenance light on SAIC Maxus V80?

How to Reverse a Manual Transmission Car?

How to Fold Down the Rear Seats of the Geely Emgrand GS?

How to Solve the Noise Issue in BMW X3's Panoramic Sunroof?

Is parallel parking or reverse parking more difficult in reality?