How to Replace the Air Filter for the 8th Generation Accord?

[CharlesLynn]

Steps to replace the air filter for the 8th Generation Accord: 1. The air filter is located behind the glove box on the passenger side. Open the glove box cover. 2. Locate the fixing clip on the right side of the glove box and pull it outward with force. Then remove the fixing clip of the glove box cover to detach it. 3. Squeeze both sides of the glove box towards the center with both hands, and the glove box can be removed. 4. After removing the glove box, you will see the air filter cover. Press the fixing clips on both sides of the cover with force, and the cover can be removed. 5. Pull out the old air filter to the outside, install the new air filter, and restore it to its original position in the reverse order of disassembly. The dimensions of the 8th Generation Accord are 4930mm in length, 1845mm in width, 1470mm in height, and it has a wheelbase of 2775mm.

[EmmaRose]

Last time I helped my neighbor uncle change the air filter for his 8th-gen Accord, it was super easy. First, empty the glove compartment on the passenger side, then squeeze both sides inward with force to remove it. See that black plastic cover at the back? Gently pry open the clips and you'll see the filter. Remember to take a photo with your phone before removing it – the arrow should point toward the rear of the car for correct installation. When buying a new filter at the auto parts market, it's best to bring the old one to compare sizes. Last time I bought a cheap one and found the edges didn't seal tightly, allowing dust to leak in. When reinstalling, make sure the glove box damper rod aligns with the slot – you'll hear a click and it's done. The whole process takes less than ten minutes. Changing it monthly ensures fresh air in the car.

[AlexanderMarie]

As a veteran driver who has been driving an 8th-generation Accord for five years, I always replace the cabin air filter myself. After opening the glove compartment on the passenger side, you need to firmly press the limiters on both sides to fully lower the compartment. The gray filter housing at the back has two clips (top and bottom) - carefully pry them open with a flathead screwdriver. The filter has front/back orientation - I once installed it backwards which reduced airflow. I recommend choosing a dual-function activated carbon filter; it's more expensive but can filter PM2.5. When installing the new filter, press it flat by hand to prevent operational noise. The most critical thing during this process is not to break the damping rod - plastic parts become brittle in winter.

[VanAxel]

Replacing the filter in the 8th-gen Accord is actually quite simple: Just remove the glove box to access the filter compartment. When opening the lid and pulling out the old filter, be careful not to get dust in your eyes—it's best to wear a mask. Insert the new filter in the same orientation, ensuring the arrow points downward. When reinstalling the glove box, first align the ball joint of the damper rod with the bracket hole. My first time took half an hour, but now I can do it in five minutes. It's recommended to replace it every six months, especially for those with rhinitis. OEM filters are a bit pricey, but compatible ones can be found on Taobao for around 50 yuan.

[PaigeLee]

Last week, I just replaced the cabin air filter for my Accord and want to share some tips: After fully opening the glove compartment on the passenger side, pull it downward firmly to remove it. Be careful not to break the limit strap on the right side. The filter compartment cover has three plastic clips that can be pried open with your fingernails. The old filter might be very dirty when removed, so prepare wet wipes to clean your hands in advance. Make sure to buy the model-specific filter - the dimensions differ between the 8th and 9th generations. During installation, ensure the edges are fully seated in the guide rails to prevent air leaks. When testing, turn the AC to maximum fan speed; if there's no strange odor, it means the installation is correct. Doing it yourself can save about 200 yuan in labor costs.

[VanAustin]

For 8th-generation Accord owners replacing the cabin air filter, prepare a Phillips screwdriver and vacuum cleaner. First remove two screws at the bottom of the glove box, then squeeze both sides to extract the entire compartment. Vacuum dust around the filter housing before opening the cover. The filter consists of upper and lower panels - incorrect installation causes clogging, which isn't mentioned in the manual. Recommend DENSO Japanese filters despite being ¥30 more expensive for superior filtration. During reassembly, ensure glove box rails align with tracks to prevent jamming. I replace mine quarterly, especially crucial before summer to prevent AC odors affecting children's respiratory health.