How to Remove the Rear Seats of the Lavida?
2 Answers
The steps to remove the rear seats of the Lavida are: 1. Press below the headrest and pull it upwards; 2. Pull the strap in the middle of the seat and flip it upwards to remove the rear seat; 3. Remove the left and right hooks under the rear seat; 4. Pull the backrest and press the switch near the door to fold down the backrest; 5. Remove the seatbelt, and the seat can then be taken out. The Lavida's body dimensions are: length 4670mm, width 1806mm, height 1474mm, wheelbase 2688mm, fuel tank capacity 51L, body structure 4-door 5-seater sedan, equipped with a 1.5L naturally aspirated engine with a maximum horsepower of 113PS.
As a DIY enthusiast who frequently works on my car, I recently removed the rear seats of my Lavida primarily to clean the dust beneath the seat covers. The disassembly process was quite straightforward: First, handle the backrest cushion section by locating the small hidden pull cord or loop underneath the seat base (usually at the edge of the seat cushion), gently pull it upward, and the entire seat cushion can be lifted. Then move on to the backrest—remove the headrest by pressing the buckle on the support rod to release it, followed by locating a plastic switch or handle at the bottom of the backrest. A simple flip unlocks the hooks, allowing you to slowly push the backrest forward until it separates. Throughout the process, be careful not to use excessive force to avoid tearing the upholstery fabric. If it gets stuck, it might be due to the carpet obstructing—clear it before trying again. After removal, you can place a child safety seat or large boxes, which is really practical. However, remember to regularly lubricate the buckle components to prevent rust and aging, ensuring smoother disassembly next time.
