···
Log in / Register

How to Remove the Cabin Air Filter of Baojun 560?

6Answers
DelSamuel
07/29/2025, 06:45:48 PM

Baojun 560 cabin air filter removal steps: First, remove all heavy objects from the storage compartment. Then, apply force to pull the storage compartment downward from the top on both sides. After that, you will see rubber pads on the left and right sides. Finally, use force to pull the lower connecting parts upward on both sides to detach it. Below are some relevant details about the Baojun 560: 1. The front design of the Baojun 560 continues the Baojun family style. The LED daytime running lights are located below the fog lights, and the headlights are equipped with LED position lights. It features a 10-inch large touchscreen entertainment system, and the control area adopts two knobs. 2. In terms of power, the Baojun 560 is equipped with a 1.8L naturally aspirated engine producing 101kW and 186Nm, paired with a 5-speed manual transmission and an AMT transmission.

Was this review help?
116
Share
LeilaniAnn
08/15/2025, 08:07:04 PM

As a new owner of a Baojun 560, I felt quite accomplished when I changed the cabin air filter for the first time last month. The whole process was actually quite simple and didn't require any professional tools. First, sit in the passenger seat and open the glove box, clearing out any items inside if necessary. Then comes the key part: there are usually plastic clips on both sides of the glove box—mine has clip-type fasteners—just gently press them inward with your fingers, and you can pull the glove box down. Once removed, you'll see a small square cover panel behind it, which is where the filter housing is located. Lightly lift the cover panel to reveal the old filter, then carefully pull it out to avoid breaking the clips. When buying a new filter, pay attention to the arrow mark indicating the airflow direction; it should match the orientation of the old filter, usually pointing downward or inward when inserted. After placing the new filter, close the cover, reinstall the glove box, and snap it back into place—job done! The whole process took less than 10 minutes. After changing it, the air inside the car felt much fresher, and I saved money by not going to a repair shop. It's recommended to replace it every six months.

Was this review help?
2
Share
Expand All
Jocelyn
10/18/2025, 12:46:09 AM

I've changed the air conditioning filter of the Baojun 560 three times now, and practice makes perfect. The steps aren't complicated: Open the glove compartment on the passenger side, empty its contents, and locate the plastic clips or small screws on both sides—most models use clips, which can be gently pinched to remove the glove box. Then you'll see the filter housing cover; lift it to pull out the old filter. When inserting the new filter, pay attention to the airflow direction arrow to avoid installing it backward, which would reduce efficiency. Reassemble all parts and check if they're securely fastened. A tip: Wearing gloves during the operation can protect against dirt and dust, and using a flashlight makes it easier to see the details. Changing the filter yourself is cost-effective and only needs to be done once a year to maintain air quality.

Was this review help?
14
Share
Expand All
LeKaden
12/01/2025, 12:25:35 AM

As a frequent driver of the Baojun 560 with my family, changing the cabin air filter is for my child's health, and it's done in just a few simple steps. Open the glove compartment on the passenger side, clear out any clutter, feel for the small clips on both sides, press them and pull down the compartment; open the filter box cover behind it, pull out the old filter, and replace it if it's dirty; make sure the arrow on the new filter is facing the correct direction, usually pointing inward; close the cover and secure the glove compartment. It takes just five minutes, and the air is much cleaner.

Was this review help?
3
Share
Expand All
SanLondyn
01/21/2026, 01:49:20 AM

As a proud owner of the Baojun 560, being young and fond of DIY, I replaced the cabin air filter effortlessly and quickly. Just lift the glove compartment on the passenger side, press the side clips to remove it; open the filter cover, pull out the old filter and insert the new one, making sure the arrow isn't upside down; then reinstall all the parts—done in less than ten minutes. Learned that online tutorials are handy, next time I'll buy the filter in advance to save money and have fun.

Was this review help?
20
Share
Expand All
CharlesMarie
04/17/2026, 02:08:51 AM

Experienced driver of Baojun 560 sharing safe AC filter replacement tips. Operate gently: Sit properly and open the glove box on the passenger side without excessive force; gently squeeze and release the clips on both sides to remove the box; lift the filter cover with fingers to take out the old filter; insert the new filter with the arrow pointing in the correct direction; reassemble and secure each part. Wearing gloves is recommended to prevent dust, and referring to the vehicle manual ensures safety.

Was this review help?
13
Share
Expand All
More Q&A

What to do if the air conditioning cooling effect of Wuling Hongguang is not good?

It may be caused by a small amount of refrigerant leakage. This can be observed from the sight glass on the dryer tank, and adding refrigerant can solve the problem. If the compressor drive belt of the car air conditioner is too loose, it should be tightened. If it cannot be turned by hand, it means the drive belt is too tight and should be loosened slightly. If tightening is ineffective, or if the drive belt has cracks, aging, or other damage, a new drive belt should be replaced.
115
Share

What to Do When the Windshield Frosts Over in Summer?

If you notice frost on your car's windshield, you can start by turning on the engine and letting it warm up for a while. After the engine is running, turn on the fan and set it to hot air mode. Adjust the fan direction to blow toward the front windshield. In addition to the front windshield, also activate the rear windshield defroster button. The rear windshield has heating wires, so it will typically defrost within a short period of driving. If you're in a hurry, you can use a professional cleaning agent, but make sure to apply it with a cloth.
109
Share

How to Solve the Idle Vibration When the AC is On in a Civic?

Dirty throttle body or excessive carbon buildup in the fuel injectors. Clean the fuel system and check if the idle control valve has carbon deposits that need cleaning. Check the condition of the spark plugs, high-voltage wires, and ignition coils. Inspect if the spark plugs have excessive carbon buildup and replace them if necessary. It is recommended to visit a 4S shop to check the fuel supply pressure and whether the intake pressure sensor is functioning normally. Inspect the fuel pressure and replace components if needed. Car vibration can also be related to aging engine mounts. If there are issues with the engine mounts, they need to be replaced.
108
Share

What is the reason for the green light when charging the Chery Ant?

The reason for the green light when charging the Chery Ant is that the vehicle is fully charged. When the vehicle is charging, the charging indicator light is red. After the vehicle is fully charged, the charging indicator light will turn green. When charging the vehicle, it is necessary to calculate the time and cut off the power supply after the charging is completed, then the vehicle can be used normally. The Chery Ant is a small pure electric vehicle produced by Chery New Energy, built on the LFS pure electric platform. There are 10 models of the Chery Ant currently on sale, with dimensions of 3200 1670 1590mm and 3200 1670 1550mm, and a wheelbase of 2150mm. If the Chery Ant is a model with a range of 151km, the charging time with a dedicated charging pile is generally 6-7 hours, and the charging time with a portable emergency charging cable is 9-11 hours; if the vehicle is a model with a range of 251km, the charging time with a dedicated charging pile is generally 7-8 hours, and the charging time with a portable emergency charging cable is 12-14 hours; if the vehicle is a model with a range of 301km, the charging time with a dedicated charging pile is generally 7-8 hours, and the charging time with a portable emergency charging cable is 12-14 hours.
119
Share

How to Conduct Annual Inspection for a Four-Year-Old Private Car?

Fill out two forms: the Motor Vehicle License and Certificate Application Form and the Motor Vehicle Inspection Record Form; locate the annual inspection data entry window to review and input the materials. Find the traffic violation inquiry window. If there are any violations, pay the fines here. Undergo the vehicle's external inspection, which requires opening the front hood and verifying the chassis number. The inspector will provide a signed page indicating the inspection is passed. Then, proceed to the inspection fee payment window to collect the invoice. Locate the inspection login window and leave all materials there; wait in line for the inspection. After the inspection is completed, you will receive an inspection report. Submit the annual inspection materials to the staff. If the annual inspection is passed, the annual inspection sticker will be issued.
101
Share

What are the differences between the Audi A3 and the Golf?

The differences between the Audi A3 and the Golf are: 1. Different engine configurations: The Audi A3 is equipped with a 2.0T turbocharged engine; the Golf has a 1.2T turbocharged engine. 2. Different body dimensions: The Audi A3 measures 4312mm in length, 1785mm in width, and 1426mm in height; the Golf measures 4259mm in length, 1799mm in width, and 1452mm in height. 3. Different tire specifications: The Audi A3 has tire specifications of 225/45R17; the Golf has tire specifications of 205/55R16. 4. Different suspension systems: The Audi A3 features a multi-link independent suspension; the Golf uses a torsion beam non-independent suspension.
117
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.