How to Deactivate the Transport Mode on a Haval?

[MacOlivia]

The dashboard displays "Transport Mode Activated," preventing the vehicle from starting. To deactivate the transport mode, first turn off the key and close the doors, then turn the key back on. For smart keys, press and hold the start button until the dashboard message changes from "Transport Mode Activated" to "Transport Mode Deactivated." For key ignition, turn the key to start the engine but do not release it. Simultaneously, use your other hand to shift the gear into D (Drive) and hold for 15 seconds to deactivate the transport mode.

[Delilah]

Just helped a friend deal with the transport mode on a Haval Big Dog last week—the dealership forgot to disable it upon delivery. The most reliable method is to enter the driver's seat without pressing the brake, then hold the start button for 15 seconds until the dashboard fully lights up. Wait a few minutes for the vehicle's computer to reset automatically. If that doesn’t work, pop the hood, locate the battery negative terminal (the black clamp), loosen the nut, disconnect the cable, wait five minutes, and reconnect it—avoid touching any metal parts during the process. Note that the trunk won’t open during this, so take the key out beforehand. Afterward, power steering might be temporarily unavailable but should restore after driving a few hundred meters. If you're uncomfortable handling the wiring, just drive to the service center—they can fix it in seconds with a diagnostic tool, and it’s free of charge.

[CassidyRose]

My H6 was also affected by transport mode last year, where the throttle had to be pressed to 3000 RPM just to reach 40 km/h. Later, I discovered an insurance box hidden behind the glove compartment on the passenger side. I found the 15A fuse labeled 'ECU,' pulled it out, waited three minutes, and then plugged it back in, which immediately solved the issue. Simply put, it's like forcing a reboot for the car's system, much safer than disconnecting the battery. However, make sure to turn off the engine and power before pulling or inserting the fuse—this trick might not work on some newer models. If a small wrench icon appears on the dashboard, it's likely that the transport mode has locked the power output. In this state, fuel consumption can be ridiculously high, so address it quickly to avoid damaging the engine.

[EmersonLynn]

This trick works for both old and new Haval models. First, open the driver's door without starting the engine, pry open the plastic cover of the OBD port under the steering wheel, straighten a paperclip and insert it into the reset hole for 20 seconds. If you hear the relay clicking inside the dashboard, it means success. However, models after 2022 have removed this reset hole, so you'll need the old-fashioned method: loosen both the positive and negative terminals of the battery under the hood, use a wrench to let the two electrode wires touch to discharge static electricity, wait for ten minutes, and then reconnect them. After exiting transport mode, remember to reset the one-touch window function by holding the switch until you hear a click.

[EzraLee]

Saw a trick at the repair shop the other day: Turn the key to ACC position (dashboard lights on but engine off), then press both brake and accelerator pedals fully and hold for 30 seconds. Watch the tachometer needle rotate halfway by itself – this releases transport mode. This folk remedy works especially well on older H5/H9 models, but may trigger fault codes in China-6 compliant vehicles. There's also an official hidden operation: Press the lock button five times consecutively, then immediately press unlock three times after the hazard lights flash twice. A door 'click' sound means successful reset – saves two hours compared to visiting the dealership. With transport mode active, besides speed limitation, the AC also locks at minimum setting, which can literally cook you in summer.

[Alejandro]

Last week, I personally tested the transport mode deactivation for the Haval Shenshou: With the engine running, open the driver's side window (very important!), then turn off the engine and close all doors. Use the mechanical key to lock the driver's door, wait five seconds, then unlock and get in the car. Without pressing the brake, long-press the start button until the transmission self-check screen appears on the dashboard. If the battery voltage is too low, it might fail, so it's best to connect a power bank to the OBD port. New cars in transport mode may have half a tank of expired gasoline, so remember to refuel with fresh gas after deactivation to avoid clogging the fuel injectors. Also, a reminder: dealer stock cars are often locked in transport mode, so it's most convenient to have the salesperson deactivate it on the spot when picking up the car.