
Park the car in a safe and level place, turn on the hazard lights, and place a warning triangle to alert other drivers to the situation and to take caution. Retrieve the spare tire, wrench, and jack (the most common location for the spare tire is at the bottom of the trunk). Begin removing the tire. Loosen all the lug nuts on the tire that needs to be changed in a diagonal pattern, but do not remove them completely. After removing the tire, install the spare tire. Once the spare tire is in place, tighten the lug nuts, also using a diagonal pattern, but only to the point where the spare tire is securely fixed. After lowering the car, fully tighten the lug nuts with maximum hand strength to ensure the tire does not come off while driving. The spare tire installation is now complete.

Last time I had a flat tire while driving my Lavida, I immediately pulled over to a flat area, engaged the handbrake, and turned on the hazard lights to warn vehicles behind me. Opening the trunk, I found the spare tire secured in the storage compartment, along with a jack, wrench, and anti-slip pad. I located the jacking point on the chassis (illustrated in the car manual) and slowly raised the car without rushing to prevent slipping. I loosened the lug nuts of the faulty tire in a diagonal pattern, then removed the tire and replaced it with the spare. I tightened the lug nuts in a crisscross manner to ensure stability and gradually lowered the jack. I double-checked all lug nuts for tightness and confirmed the spare tire's air pressure was within the normal range. Remember, the spare is for temporary use—drive under 80km/h and only for short distances to the repair shop. Don’t forget to wear gloves for hand protection, and be extra cautious about slipping in rainy conditions. Regularly checking your tires can help prevent such incidents.

Two years ago when I was a newbie driving my Lavida, I had a tire blowout and nervously pulled over, turning on the hazard lights and engaging the handbrake to calm down. I lifted the trunk mat to find the spare tire and tool kit there. After checking the manual to locate the jacking points (on the side beams near the wheel arches), I positioned the jack and slowly raised the car. Then I loosened the lug nuts counterclockwise with a wrench and removed the wheel, setting it aside. I fitted the spare tire onto the studs, hand-tightened the lug nuts in a crisscross pattern initially, and then secured them firmly with the lever. After lowering the jack, I gave the lug nuts a few more tightening turns. I drove a few meters to test and straighten the wheel, ensuring there were no unusual noises. Remember not to exceed 100km/h on a spare tire as prolonged high-speed driving can damage the tire system. Since that incident, I've learned that wearing a reflective vest is safer.

I drive a Lavida for daily commuting and know the basic steps for changing a spare tire: park at a safe spot, engage the handbrake, and turn on the hazard lights. Retrieve the spare tire and jack from the trunk and place them securely. Locate the lifting point mark on the chassis and jack up the car, but not too high. Loosen the lug nuts, remove the old tire, and install the spare tire, tightening the lug nuts in a crisscross pattern. Lower the car and re-tighten the lug nuts for a final check. Remember, the spare tire is only for emergency use—drive slowly and get the original tire repaired promptly to ensure safe driving.

As a car enthusiast, I'm passionate about the details of the Lavida. When changing a spare tire: park steadily, engage the handbrake, turn on hazard lights, and retrieve the spare tire tools from the trunk. The jacking points are marked on the chassis; lift the jack slowly to prevent shaking. Loosen the lug nuts diagonally, remove the wheel, and replace it with the spare. Tighten the lug nuts in a crisscross pattern and lower the car. The spare is a temporary T-type tire - drive below 80 km/h for short distances to avoid suspension damage. After replacement, check the tire pressure as it's a space-saver spare.

After decades of driving, I always follow a simple yet safe procedure when changing the spare tire on my Lavida: Park on level ground, engage the handbrake, and turn on hazard lights for safety first. Retrieve the spare from the trunk and position the jack correctly to lift the car. Loosen the lug nuts in order, remove the wheel, and install the spare, tightening the lug nuts diagonally for security. Lower the car and re-tighten for reinforcement. Remember, the spare is for temporary use only—drive at low speeds and repair the original tire promptly to protect the suspension system. Finally, clean up and store tools properly to prevent loss.


