···
Log in / Register

How many meters is the straight-line driving in Subject 3?

6Answers
MacAlexander
09/01/2025, 12:32:44 AM

There is no fixed distance for straight-line driving, approximately around 100 meters, with the specific distance controlled by the on-site examiner. Below is relevant information about straight-line driving: Introduction to straight-line driving: Straight-line driving refers to novice drivers starting the vehicle, gradually accelerating to shift gears from the lowest to the highest, reaching high speed. Do not deliberately slow down: During driving, many learners intentionally slow down due to concerns about not driving in a straight line. This approach is not advisable as it increases the likelihood of the vehicle deviating from its path. Therefore, maintain a reasonable and steady speed, and do not slow down just to ensure straight-line driving.

Was this review help?
112
Share
LeSerenity
09/13/2025, 03:18:03 AM

During my last driving test for Subject 3, the straight-line driving section was set at about 100 meters. It doesn’t sound long, but the pressure during the actual operation was intense. The test required maintaining a speed of 30 to 40 km/h, with only slight adjustments allowed on the steering wheel. If the vehicle deviated more than 30 centimeters, it was an automatic fail. During my initial practice, I often felt like the car was weaving. Later, my instructor advised me to look far ahead instead of focusing on the hood, relax my arms as if holding a coffee cup, and gently guide the steering wheel. I practiced using a stopwatch to time the 100-meter distance, aiming to complete it in about 10 seconds. Repeated practice on straight roads with marked distances helped me get familiar with the rhythm and reduce nervousness. After passing, I realized how crucial this precise control is for actual driving safety—good habits are key to preventing rear-end collisions. Sticking with it was definitely worth it.

Was this review help?
8
Share
Expand All
Gavin
10/27/2025, 04:05:13 AM

During the driving test process, the straight-line driving section of Subject 3 is set at approximately 100 meters, with the key being speed and direction control. I recommend maintaining a steady speed of 30-35 km/h and keeping steering wheel adjustments under 5 degrees to avoid wobbling. During the exam, continuous deviation of the vehicle body will result in point deductions or failure, and environmental pressure can easily cause shaky hands. An effective practice method is to find an open road section, mark a 100-meter line, and drive back and forth while focusing on a distant reference point to ensure the vehicle stays centered in the lane, occasionally checking the rearview mirror for minor adjustments. Although 100 meters is short, it tests fundamental skills. Combined with other tasks like turn signal usage, preparation is essential. Passing becomes manageable after multiple simulations, and this stability skill benefits daily driving as well. Forming the habit is challenging but necessary.

Was this review help?
15
Share
Expand All
DiHarrison
12/10/2025, 03:21:15 AM

The standard for straight-line driving in Subject 3 is 100 meters, requiring the vehicle to maintain a straight path without deviation throughout the test. A speed above 30 km/h is recommended, with only minor steering wheel adjustments allowed. Exceeding the deviation limit results in immediate failure. During practice, find a 100-meter straight road and repeatedly drive it, focusing on a distant target ahead and avoiding unnecessary glances at the dashboard. This distance setting is reasonable for testing control ability; with some practice to master the rhythm, you can pass the test with fewer mistakes. The key is maintaining steady speed and light steering.

Was this review help?
7
Share
Expand All
Vernon
01/30/2026, 09:40:22 PM

The straight-line driving section of the driving test (Subject 3) is typically 100 meters long, requiring stable driving without deviation within the specified distance. During my driving lessons, the instructor emphasized maintaining a speed between 30-40 kilometers per hour, making slight adjustments to the steering wheel to avoid excessive turning that could cause the car to tilt. Within the 100 meters, it's essential to focus on a distant reference point and handle the steering wheel as gently as holding a pencil to write. Common issues during the test include nervous, large movements and unstable speed. It's recommended to practice simulating the route with lane-changing exercises. More practice boosts confidence, which is beneficial for other test items. This section may seem simple, but the foundational skills should not be taken lightly.

Was this review help?
14
Share
Expand All
EllaAnn
04/25/2026, 03:29:27 PM

Practicing the 100-meter straight-line driving segment in Subject 3 left a deep impression on me. Despite the short distance, it demands extremely high precision. The test requires maintaining a steady speed of 30-40 km/h, with even a slight steering wheel deviation leading to failure. Within 100 meters, the vehicle must stay straight, with an offset limit of about 30 cm, or you'll fail. During daily practice, marking reference points and repeatedly driving the route helps develop a sense of direction and reduce mistakes. The practical significance lies in reinforcing safe driving habits to prevent lane swaying accidents on highways. The 100-meter setup is practical and concise, allowing quick mastery through repeated simulations. Mastering these fundamentals brings lifelong benefits.

Was this review help?
16
Share
Expand All
More Q&A

What should the driver do when the vehicle is about to exit the tunnel?

When exiting the tunnel, the driver should pay attention to height and speed limit signs; choose the lane indicated by the green arrow signal light; and turn on the headlights in advance. The following are precautions for driving through tunnels: 1. Slow down and turn on lights before entering the tunnel: Reduce speed about 100 meters before entering the tunnel, increase the following distance, and turn on the vehicle lights while driving slowly into the tunnel. Generally, the speed should not exceed 60 km/h, depending on the speed limit signs before the tunnel. 2. Do not use high beams: While driving in the tunnel, turn on the vehicle lights but avoid using high beams. The significant difference in light intensity inside and outside the tunnel already affects the driver's vision, and high beams can further increase the risk. 3. Maintain a safe following distance: Generally, the following distance in the tunnel should be kept at least 100 meters. If the tunnel is relatively long, maintain a safe distance as indicated. 4. Do not change lanes: Due to poor lighting and typically only two or three lanes, lane changes are strictly prohibited in tunnels. Always drive in your designated lane and avoid overtaking. 5. No speeding in the tunnel: Tunnels have strict speed limits, which are clearly marked before entering. Some tunnels also have speed limit reminders inside. Strictly adhere to the speed limits to ensure driving safety. 6. Avoid honking in the tunnel: The tunnel's acoustics amplify noise, making honking much louder and more irritating than outside. Drive patiently in the tunnel and avoid unnecessary honking unless in an emergency, to avoid disturbing yourself and others.
116
Share

What is the age limit for obtaining a driver's license?

Driver's license training age limits vary depending on the type of license. Below are the specific details: 1. Small vehicles: For small automatic transmission vehicles, small automatic transmission passenger vehicles for disabled individuals, and light motorcycles, the age requirement is between 18 and 70 years old. 2. Low-speed cargo vehicles: For three-wheeled vehicles, ordinary three-wheeled motorcycles, ordinary two-wheeled motorcycles, or wheeled self-propelled machinery, the age requirement is between 18 and 60 years old. 3. City buses: For large trucks, trolleybuses, or tram vehicles, the age requirement is between 20 and 50 years old.
106
Share

What is the difference between dual throttle cables and single throttle cables?

Here are the differences between dual throttle cables and single throttle cables: 1. The number of throttle cables differs: If it is a single cable, there is only one throttle cable under the right-hand throttle grip. In contrast, if it is a dual cable setup, there are two throttle cables under the right-hand throttle grip. 2. The precision of throttle control varies: Dual throttle cables offer more precise control compared to single cables. 3. The throttle return effect differs: Dual throttle cables provide better throttle return than single cables. 4. Their applications vary: Constant vacuum carburetors often use dual throttle cables, while slide carburetors typically use single throttle cables.
111
Share

What is the Difference Between Guide Lanes and Variable Guide Lanes?

Here are the differences between guide lanes and variable guide lanes: 1. Different in nature: (1) Guide lanes: These are lane markings that guide direction. They are used to indicate the direction vehicles should follow when entering an intersection. (2) Variable guide lanes: The direction after entering this lane must be determined according to the corresponding lane traffic light. 2. Different in use: (1) Guide lanes: Used to indicate the direction vehicles should follow at an intersection. (2) Variable guide lanes: Adjust traffic flow in different directions to reduce congestion. 3. Different route requirements: (1) Guide lanes: The driving direction is fixed, and vehicles must follow the lane markings. Special attention should be paid to left-turn lanes, where overtaking is not allowed. (2) Variable lanes: Multiple diagonal lines are drawn inside the lane.
109
Share

Can You Wear Contact Lenses for a Driver's License Test?

You can wear contact lenses for a driver's license test. Here are the relevant details: 1. Vision correction requirements: For drivers applying for large passenger vehicles, medium-sized passenger vehicles, tractors, city buses, large trucks, trolleybuses, or tram licenses, the naked or corrected vision of both eyes must reach 5.0 or above on the logarithmic visual acuity chart; for drivers applying for other license types, the naked or corrected vision of both eyes must reach 4.9 or above on the logarithmic visual acuity chart. 2. Examination room requirements: Contact lenses can be worn during the test in the examination room, but no electronic devices such as mobile phones or headphones are allowed. Additionally, according to the latest regulations, wearing slippers during the test is prohibited.
111
Share

What are the reasons for an automatic transmission being stuck in P gear and unable to move?

Possible reasons for an automatic transmission being stuck in P gear and unable to move include: a faulty gear limit switch or brake light switch, a damaged brake light fuse, or a malfunctioning P gear solenoid valve or wiring. Below is an introduction to the automatic transmission gears: 1. P-Parking, the parking gear, used when starting the vehicle. 2. R-Reverse, the reverse gear, used when backing up. 3. N-Neutral, the neutral gear, used for temporary stops (such as at a red light). 4. D-Drive, the forward gear, also known as the driving gear. 5. L-Low, the low-speed gear. 6. S-Sport, indicating sport mode; when engaged, gears can be freely switched, but the shifting timing is delayed. 7. OD-Overdrive, the overdrive gear, used for high-speed driving to save fuel.
115
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.