Has the Nissan GTR been discontinued?

1 Answers
EdenFitz
07/30/25 7:17am
Nissan GTR has been discontinued. The Nissan GTR is a sports car under the Nissan brand, often referred to by many car enthusiasts as the people's sports car. The Nissan GTR is equipped with a 3.8-liter twin-turbocharged V6 engine, with the engine code VR38DETT. In its factory state, this engine delivers a maximum power of 357 kW and a maximum torque of 588 Nm. The Nissan GTR's maximum power is achieved at 6,400 rpm, and the maximum torque is available between 3,200 to 5,200 rpm. The engine is paired with a 6-speed dual-clutch transmission. The car features a double-wishbone suspension at the front and a multi-link independent suspension at the rear, with a front-engine, rear-wheel-drive layout.
Was this review help?
2
5
Share
More Forum Discussions

How is the wading capability of new energy vehicles?

Theoretically, electric vehicles have better wading capability than traditional fuel-powered vehicles. The entire power battery and motor can operate normally even when submerged in water, eliminating concerns about engine damage due to water ingress. Below are specific details about new energy vehicles: 1. Definition: New energy vehicles refer to automobiles that utilize unconventional vehicle fuels as power sources, integrating advanced technologies in vehicle power control and driving systems to form vehicles with advanced technical principles, new technologies, and novel structures. 2. Types: New energy vehicles include pure electric vehicles, range-extended electric vehicles, hybrid electric vehicles, fuel cell electric vehicles, hydrogen engine vehicles, etc.
7
0
Share

What are the symptoms of using low-quality fuel?

Cars using low-quality fuel may exhibit the following symptoms: difficulty starting or even failure to start; engine shaking at idle after starting; noticeable body vibration; foul-smelling exhaust gases; noisy valves; poor acceleration with high fuel consumption; gear shifting with impact. The vehicle maintenance solutions after using low-quality gasoline are as follows: 1. If the vehicle can currently drive normally without symptoms, promptly go to the nearest 4S shop for the following treatments: completely drain the remaining fuel in the tank, refill with high-quality gasoline, clean the fuel injectors, clean the combustion chamber, and replace the fuel filter. 2. If the vehicle drives normally but the engine idles with slight shaking: promptly go to the nearest 4S shop for the following treatments: completely drain the remaining fuel in the tank, refill with high-quality gasoline, clean the throttle body, clean the fuel injectors, clean the combustion chamber, and replace the fuel filter and fuel pump. 3. Vehicles with starting difficulties, failure to start, engine shaking, poor acceleration, gear shifting impact, or noisy valves should be stopped immediately and request rescue from a 4S shop. Measure cylinder pressure; if the cylinder pressure is normal, disassemble the cylinder head for cleaning, completely drain the remaining fuel in the tank, refill with high-quality gasoline, clean the throttle body, clean the fuel injectors, clean the combustion chamber, and replace the fuel filter and fuel pump. 4. If the engine fails to start and there is no cylinder pressure, with severe piston impact marks, the engine requires major overhaul. Completely drain the remaining fuel in the tank, refill with high-quality gasoline, clean the throttle body, clean the fuel injectors, clean the combustion chamber, and replace the fuel filter and fuel pump.
11
2
Share

How to Set Up One-Touch Window Control in Haval M6?

Haval M6 one-touch window control can be set up as follows: 1. Locate the corresponding control button below the window, which has 5 positions; 2. Push the button to the topmost position to enable one-touch window lifting. The Haval M6 is a compact SUV with the following dimensions: length 4664mm, width 1830mm, height 1729mm, wheelbase 2680mm, front and rear track width 1565mm, minimum ground clearance 180mm, and fuel tank capacity 55L. It is powered by a 1.5T turbocharged engine with a maximum output of 150PS, peak power of 110kW, and maximum torque of 210Nm, paired with a 6-speed manual transmission.
15
3
Share

Can a swollen car battery still be used?

A swollen battery cannot be repaired and should be replaced immediately. Continuing to use a swollen battery may lead to the following consequences: 1. Polarity reversal: A swollen battery is prone to polarity reversal in later stages, where the positive terminal becomes negative and the negative terminal becomes positive. This can cause the charger to burn out and damage the controller. 2. Fire hazard: If the controller and charger lack comprehensive protection functions, it may also lead to vehicle fires. Additional information: Causes of battery swelling include: Battery swelling is one of the most common battery failures, often appearing as bulging on both sides. The main causes are excessive charging or discharging currents, which rapidly increase the battery's internal temperature. If the gas cannot be vented in time and the pressure builds up to a certain level, swelling or deformation occurs.
14
3
Share

How Many Chances Are There for the Subject 2 Test?

For the Subject 2 test, if you fail the first attempt, you are allowed one retake. If you do not attend the retake or fail the retake, the current test session ends, and the applicant must reschedule the test after ten days. Within the validity period of the driving skill test permit, the number of rescheduled attempts for Subject 2 and Subject 3 road driving skill tests cannot exceed five. If the fifth rescheduled test is still failed, the passing scores of other previously passed subjects will be invalidated. The full score for Subject 2 is 100 points, with evaluation criteria set for failing, deducting 20 points, deducting 10 points, and deducting 5 points. The test is considered passed if the following conditions are met: ① For applicants of large buses, trailers, city buses, medium buses, and large trucks, a score of 90 or above is required; ② For other vehicle types, a score of 80 or above is required. The test items for large vehicles (A1, A2, A3, B1, B2) include pole test, hill start, parallel parking, single-plank bridge, curve driving, right-angle turn, narrow gate passage, continuous obstacle course, bumpy road driving, narrow road U-turn, and simulations for highways, continuous sharp mountain turns, tunnels, rain (fog) conditions, slippery roads, and emergency handling. The test items for small vehicles (C1, C2) include reverse parking, parallel parking, hill start (canceled for C2), right-angle turn, and curve driving (commonly known as S-turn), which are the five mandatory items (some regions include a sixth item for highway toll card collection).
5
1
Share

Why does Geely car display an airbag malfunction?

The reasons for the airbag warning light to illuminate include: foreign objects, especially metal shavings, around the airbag sensor wiring harness causing a short circuit and triggering a false alarm; errors in the car's ECU sensor data; prolonged parking of the vehicle in a humid environment or moisture in the wiring connectors due to car washing; or a malfunction in the airbag itself, though most cases are caused by loose connectors. Below is a detailed introduction about airbags: 1. Brief Meaning: The airbag system is a passive safety (see vehicle safety performance) protection system that, when used in conjunction with seat belts, provides effective collision protection for occupants. In a car collision, airbags can reduce head injuries by 25% and facial injuries by about 80%. 2. Main Components: Primarily consists of airbag sensors, collision airbags, and electronic control devices. 3. Working Principle: When a collision occurs during driving, the airbag sensor first receives the impact signal. If the impact reaches the specified intensity, the sensor activates and sends a signal to the electronic controller. Upon receiving the signal, the electronic controller compares it with its stored data. If the conditions for airbag deployment are met, the drive circuit sends an activation signal to the gas generator in the airbag module. The gas generator, upon receiving the signal, ignites the gas-producing agent, generating a large amount of gas. After filtration and cooling, the gas enters the airbag, causing it to rapidly inflate through the padding in a very short time, forming an elastic cushion in front of the driver or passenger. The airbag then promptly deflates and contracts, absorbing the impact energy, thereby effectively protecting the head and chest from injury or reducing the severity of injuries.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.