How to Set Up One-Touch Window Control in Haval M6?

[LaLily]

Haval M6 one-touch window control can be set up as follows: 1. Locate the corresponding control button below the window, which has 5 positions; 2. Push the button to the topmost position to enable one-touch window lifting. The Haval M6 is a compact SUV with the following dimensions: length 4664mm, width 1830mm, height 1729mm, wheelbase 2680mm, front and rear track width 1565mm, minimum ground clearance 180mm, and fuel tank capacity 55L. It is powered by a 1.5T turbocharged engine with a maximum output of 150PS, peak power of 110kW, and maximum torque of 210Nm, paired with a 6-speed manual transmission.

[DanielaAnn]

I just helped my neighbor with this a couple of days ago. The Haval M6 one-touch window actually requires manual initialization. First, power on the car, locate the window button on the driver's side door panel, press and hold a window button to completely lower it without releasing, wait for 3 seconds, then immediately pull it up to the top and hold for 5 seconds. A click sound indicates success. Each window needs to be set separately, and remember to perform the operation continuously without releasing the button. If it still doesn't work after setup, it might be a blown fuse or a stuck motor, requiring the door panel to be removed to check the wiring. Now, pressing the button once automatically raises or lowers the window, which is indeed much more convenient than holding it down all the time.

[GabriellaAnn]

I know this well, I went through the same thing when I first bought my M6. Get in the car, press the brake pedal, and press the start button to power on (but don't start the engine). Hold down the window control button on the door to lower the window all the way down and don't release it. Watch as the glass fully lowers, then immediately pull it all the way up and hold it steadily for 5 seconds. You'll hear a click when it's done. Repeat this process for all four windows. Be careful not to perform this operation on a slope to prevent excessive load on the motor. If the setup fails, try disconnecting the negative terminal of the battery for a few minutes to reset the car's computer.

[McRachel]

Here are the simple steps: First, power on the vehicle, then press the window button you want to set all the way down for 3 seconds, followed by pulling it all the way up and holding for 5 seconds. Each window should be operated separately. The key point is to perform the actions continuously without pauses, as moving too slowly may cause failure. After completing the steps, test by briefly pressing the button to see if the window automatically rolls up and down—this indicates success. If it doesn’t work, repeat the process. For some older cars, you may also need to enable the one-touch window control option in the central control screen.

[StephenFitz]

There's a little trick to setting this up. You need to hold the button down to lower the window all the way while the power is on, keep your finger pressed until the glass stops, then immediately pull it up to the top and continue holding for 5 seconds. I've found it's easier to succeed on sunny days than rainy ones, probably due to track resistance issues. Once set up, a short press of the button will automatically open or close the window, while a long press cancels the auto function. If it stops working one day, it's usually because the initialization was lost, and you just need to do it again.

[CadenDella]

The operation is quite simple: Turn on the power without starting the engine, select a window, press and hold the down button all the way for 3 seconds, then pull up the up button to the top and hold for 5 seconds. Each window is set independently—don’t mix up the sequence. I recommend starting with the driver’s side window for easier testing. You’ll hear a "click" sound from the motor to confirm success; if there’s no sound, you’ll need to repeat the process. This function requires stable power, so cars with nearly dead batteries may struggle. Also, avoid letting windows get stuck by ice, as it can burn out the motor.