···
Log in / Register

Does the New Santana have fog light wiring pre-installed?

3Answers
Lulu
07/29/2025, 10:25:34 PM

New Santana does not have fog light wiring pre-installed, additional wiring is required. Below is relevant information about fog lights: 1. Purpose: Fog lights are designed to make the vehicle visible to others during foggy or rainy conditions when visibility is significantly affected by weather. Therefore, fog light sources need to have strong penetration. Most vehicles use halogen fog lights, while more advanced models may use xenon fog lights. 2. Classification: Fog lights are divided into front fog lights and rear fog lights. Front fog lights are typically bright yellow, while rear fog lights are red. The symbols for rear fog lights differ slightly from front fog lights—the light lines on the front fog light symbol point downward, whereas those on the rear fog light symbol are parallel, usually located on the vehicle's dashboard control panel.

Was this review help?
115
Share
Chiron
08/15/2025, 04:33:11 AM

Previously running a repair shop, I came across many new Santanas. The base models mostly had pre-installed fog light wiring, a clever move by Volkswagen to make it easier for owners to install them later. If you remove the front bumper, you can see the wiring harness connector, usually with gray and black wires, tucked behind the bumper frame inside a corrugated tube. However, be aware that some post-2015 models have simplified wiring. It's best to first test the connector with the parking lights on to see if there's power. If there's no wiring, you'll have to run exposed wires, connecting a signal wire from the BCM computer and adding a relay to prevent overload, which will add about 200 yuan to the labor cost.

Was this review help?
7
Share
Expand All
Duane
10/21/2025, 02:08:57 AM

My 2018 Santana Fashion Edition didn't come with front fog lights, but I bought a pair of fog light assemblies on Taobao myself. When I removed the bumper, I was surprised to find there were actually pre-installed connectors! The wiring was ready-made with yellow and brown twin wires - just plug and play. Remember to test the voltage before installation to prevent fuse burnout later. This design is quite user-friendly, saving the trouble of cutting and splicing wires. Rear fog lights are standard across all trims, but front fog lights are only available on higher-end models. When installing yourself, pay attention to the bracket positioning - some car enthusiasts installed them crookedly, causing light scattering that affects oncoming traffic.

Was this review help?
18
Share
Expand All
More Q&A

How to Replace a Brake Light Bulb?

Brake light bulb replacement method mainly includes: 1. First, use a cross-head screwdriver or socket to remove the bolts and pull the lamp assembly out from the rear pillar. 2. Turn the socket counterclockwise to remove the old bulb and insert the new bulb. 3. Slide the lamp assembly into the guide groove on the vehicle body. 4. Finally, align the pins with the body gasket and push them in until they fit completely. Extended content: 1. After lighting, halogen bulbs will become very hot. Oil, sweat stains, or scratches on the glass surface of the bulb can cause the bulb to overheat and break. 2. When replacing the bulb, hold the plastic base of the bulb to prevent the glass surface from coming into contact with skin or hard objects. If the glass surface of the bulb has been touched, clean it with a clean cloth dipped in industrial alcohol.
118
Share

How to Calculate the Annual Inspection Date?

Vehicle annual inspection time is determined based on the date of new vehicle registration. Below are relevant details regarding the calculation of vehicle annual inspection dates: 1. According to Article 16 of the "Regulations for the Implementation of the Road Traffic Safety Law": Motor vehicles shall undergo safety technical inspections according to the following intervals from the date of registration: Passenger vehicles for operational use must be inspected once per year within 5 years; if exceeding 5 years, once every 6 months; Trucks and large/medium-sized non-operational passenger vehicles must be inspected once per year within 10 years; if exceeding 10 years, once every 6 months. 2. Small and mini non-operational passenger vehicles (9 seats or fewer) must be inspected once every 2 years within 6 years without on-site testing; if exceeding 6 years but less than 10 years, on-site inspection once every 2 years; if exceeding 10 years, once per year; if exceeding 15 years, once every 6 months. 3. Vehicles can undergo annual inspection within 3 months before the expiration date. The expiration date for annual inspection can be found on the supplementary page of the vehicle license, which states the valid inspection period until a specific year and month.
119
Share

What is the function of ETC?

ETC function: Through the on-board electronic tag installed on the vehicle's windshield, dedicated short-range communication is established with the microwave antenna in the ETC lane at the toll station. By utilizing computer networking technology for backend settlement processing with banks, the system enables vehicles to pass through highway or bridge toll stations without stopping while automatically paying the toll fees. Benefits of installing ETC: Time-saving: Eliminates the hassle of waiting in queues; Green and eco-friendly: Promotes low-carbon travel by reducing noise and exhaust emissions since vehicles don't need to stop at toll stations, thereby minimizing pollution; Cost and wear reduction: Saves expenses by decreasing the frequency of vehicle acceleration and braking, which lowers wear and fuel consumption. Users also enjoy a 5% discount on toll fees; Improved efficiency: The theoretical passing efficiency of ETC lanes can be increased by 2-3 times or more, making traditional ETC systems more updated, faster, and higher-tech. Compared to license plate payment, ETC technology is more mature and advantageous.
106
Share

What is the tire size of the Qashqai?

There are three types of tire models for the Qashqai, which are: 215/60-R17, 215/55R18, and 225/45-R19. Below is a detailed introduction about the tire models: 1. Most tire model markings are like: 215/70R15, and the meanings of these numbers are: 215 represents the tire section width, the unit is mm, generally the width of the tire is between 145—285mm, with intervals of 10mm; 70 is the aspect ratio, the ratio of the tire sidewall height to the tire section width, 70 represents 70%, generally the aspect ratio of tires is between 30%—80%. 2. Some tires have an arrow or OUTER-SIDE marked on the sidewall, indicating the rotation direction of the tire. If there is a small umbrella symbol on the sidewall, it indicates that this tire is suitable for driving in rainy or slippery road conditions. 3. Some tires also contain other letters or symbols, which have special meanings: 'X' indicates high-pressure tires; 'C' indicates reinforced tires; 'B' indicates bias tires; '-' indicates low-pressure tires. M and S are abbreviations for Mud and Snow in English, indicating that this tire is suitable for use on snowy, icy, and muddy roads.
119
Share

What is the correct way to use the auto start-stop function?

Here is an introduction on how to use the auto start-stop function: 1. Turn off start-stop in traffic jams. Stop-and-go traffic conditions are not suitable for auto start-stop. Not only does the engine shake upon restarting, but the fuel-saving effect is also negligible, as repeated starts and stops not only increase fuel consumption but also add to the engine's burden. 2. Turn off start-stop on slopes. When the engine stops and restarts on a slope, it takes a brief moment to restart, meaning it cannot immediately provide braking force. This can cause the vehicle to roll when the brake is released, increasing the risk of danger. 3. Turn off start-stop when using air conditioning. When the engine stops, the air conditioning also stops cooling to protect the battery, leaving only the fan running. 4. Turn off start-stop when wading through water. When driving through water at low speeds, stepping on the brake activates the auto start-stop, causing the engine to stop. This creates negative pressure in the exhaust pipe, potentially drawing water into it. Restarting the engine under these conditions can cause severe damage. 5. Turn off start-stop during low-speed parking. Although the start-stop function does not activate when the vehicle is in reverse, repeatedly adjusting the car's position—especially when parallel parking or maneuvering into a parking spot—can trigger the start-stop function with each adjustment, leading to frequent engine restarts.
113
Share

Can a Car Be Sold During the Loan Period?

A vehicle under loan cannot be traded or sold; all loans must be repaid, and the mortgage registration must be canceled before any transaction can occur. During the loan repayment period, the owner does not possess full ownership of the vehicle—the ownership temporarily belongs to the mortgage institution, and the borrower only has the right to use the vehicle. Below are legal methods to sell a mortgaged car: 1. First, contact a buyer and negotiate with them to advance the remaining loan amount. Then, retrieve the vehicle registration certificate, vehicle qualification certificate, and purchase contract from the bank, and proceed to the vehicle management office for the transfer with the vehicle. 2. Visit the bank with the buyer to complete a mortgage transfer agreement. This process requires providing the original and a copy of a valid ID, the vehicle mortgage contract, the vehicle license, followed by fingerprinting and signing. The vehicle's source must be legitimate, and its information can be verified at a 4S shop or through the traffic police vehicle system. The new owner can then use the vehicle license to purchase insurance from an insurance provider.
102
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.