···
Log in / Register

Can I Bring a Turned-Off Phone During the Subject 3 Driving Test?

1Answers
Isla
07/29/2025, 07:20:34 PM

Subject 3 Driving Test allows you to bring a turned-off phone with you. Here are the details: 1. Subject 3 Driving Techniques: Starting Details: Walk around the vehicle counterclockwise from the driver's door, return to the driver's door, enter the car, adjust the seat and fasten the seat belt, lightly press the accelerator to check if the dashboard is normal, and apply for the Subject 3 test; turn on the left signal light and observe the road conditions behind; shift to 1st gear, slowly release the clutch to start the vehicle, lightly press the accelerator to increase speed, and shift gears according to road conditions to ensure the vehicle saves time without affecting other vehicles; Braking Techniques: To control speed, remember to release the accelerator and lightly press the brake to solve the problem. First, get familiar with the vehicle and build confidence, then develop knowledge and ability to handle road conditions. Stay calm and handle situations properly; Smooth Driving Techniques: During gear shifting, to ensure smooth driving, press the accelerator to increase speed, then only use the right foot on the accelerator, press the clutch, and shift gears sequentially without skipping gears. 2. Situations Leading to Failure in Subject 3: Not fastening the seat belt; Starting with insufficient air pressure; Starting without closing the door properly; The vehicle rolls more than 30 cm when starting; Unstable control of the vehicle's direction, etc.

Was this review help?
103
Share
More Q&A

Is it okay for Wuling Hongguang to run at 4000 RPM on the highway?

It is advisable not to take a new car on the highway immediately. Wait until the mileage exceeds at least 1000-1500 kilometers before driving on the highway. You can then moderately push the engine at a reasonable speed below 120 km/h, preferably keeping the engine RPM under 3000. Avoid exceeding 100 km/h whenever possible, and refrain from sudden acceleration or hard braking. Additionally, before embarking on a long highway trip, it's best to have a thorough inspection of all vehicle components at a local 4S shop. Here are the details: 1. RPM Range: Generally, car RPM fluctuates between 1500-3000 RPM, with idle RPM being lower, around 800-1500 RPM. However, if you observe the car's tachometer, you'll notice it is divided into several zones. The white scale indicates the safe RPM range, while the red scale marks the dangerous RPM range. 4000 RPM does not fall within the dangerous range, so it is not considered aggressive driving. 2. Protective Measures: Moreover, with advancements in automotive technology, engine protection mechanisms are now quite robust. If the engine operates under extreme conditions, fuel cutoff protection measures are usually activated. Therefore, even if the engine frequently runs at 4000 RPM, it may not necessarily harm the engine.
107
Share

Is the BYD Tang DM-i Super Hybrid 4WD?

The BYD Tang DM-i Super Hybrid is not 4WD. 4WD refers to a vehicle that maintains a four-wheel drive form throughout the driving process, with the engine's output torque distributed to the front and rear wheels at a fixed ratio. This driving mode can provide better off-road and handling performance. Below is an introduction to 4WD vehicles: 1. Part-time 4WD: Part-time 4WD is a system where the driver can manually switch between two-wheel drive and four-wheel drive. The driver can achieve the purpose of two-wheel drive or four-wheel drive by cutting off or connecting the transfer case according to driving needs. This is also a very common four-wheel drive system for off-road vehicles or SUVs equipped with 4WD functions. 2. On-demand 4WD: On-demand 4WD is a system that only engages four-wheel drive under appropriate conditions, remaining in two-wheel drive under normal circumstances. Its emergence not only reduces the cost of 4WD vehicles but also provides good fuel efficiency. 3. Full-time 4WD: Full-time 4WD is a system where the driver keeps all wheels independently moving in four-wheel drive.
114
Share

Is the Gap Between Baojun Cars and Joint Venture Cars Significant?

Baojun cars and joint venture cars do not have a significant gap. Baojun's engine is a domestically developed engine by SAIC. Baojun's engine is researched and developed by SAIC and produced in Liuzhou, Guangxi. This engine is praised by consumers for its mature technology, durability, and reliability. It also features multi-point electronic fuel injection technology. There are two versions of this engine: a 1.5L naturally aspirated engine and a 1.5T turbocharged engine. Below is some relevant information about Baojun's engines: 1. 1.5L naturally aspirated engine: Maximum power is 77 kilowatts, maximum torque is 135 Newton-meters, peak power is achieved at 5600 RPM, and peak torque is produced between 3600 to 5200 RPM. It features an aluminum cylinder head and a cast iron cylinder block. 2. 1.5T turbocharged engine: This engine has a maximum power of 108 kilowatts, maximum torque of 250 Newton-meters, peak power is achieved at 5200 RPM, and peak torque is produced between 2200 to 3400 RPM. It also features an aluminum cylinder head and a cast iron cylinder block.
115
Share

What is the fuel consumption of the Passat Lingyu 2.0?

The fuel consumption of the Passat Lingyu 2.0 model is approximately 10L. The actual fuel consumption of a car depends on its usage conditions, and different road conditions can result in varying fuel consumption. Impact of driving habits on fuel consumption: Poor driving habits lead to higher fuel consumption. Habits such as prolonged idling, sudden acceleration and braking, shifting at excessively high or low RPMs, frequent speeding or crawling at very low speeds are major contributors to increased fuel consumption. When idling, the engine consumes significantly more fuel than during normal driving. Therefore, it is best to turn off the engine when the vehicle is not in use for extended periods, such as during long waits while parked. A smooth and steady driving style is the most fuel-efficient. Avoid stomping on the accelerator at startup; gentle acceleration and maintaining a constant speed are the most economical. Impact of low-quality gasoline on fuel consumption: Using low-quality gasoline directly affects fuel consumption. Inferior gasoline tends to produce more impurities compared to standard-quality fuel, which can clog the fuel system more easily. This leads to incorrect air-fuel ratios, overly rich mixtures, and incomplete combustion, resulting in increased fuel consumption. Therefore, whenever possible, it is advisable to refuel at reputable gas stations.
112
Share

How to Turn on the Cold Air in Roewe Air Conditioning?

Method to turn on the cold air in Roewe air conditioning: The air conditioning switch is the AC button. Pressing the AC button turns on the air conditioning, and turning the temperature control knob to the blue position activates the cold air. The car air conditioning system is designed to cool, heat, ventilate, and purify the air inside the cabin, providing passengers with a comfortable environment, reducing driver fatigue, and enhancing driving safety. Roewe offers models such as the Roewe RX3, Roewe RX5, and Roewe i5. Among them, the Roewe i5 is a high-performance internet-connected compact car under the Roewe brand, with body dimensions of 4601mm in length, 1818mm in width, and 1489mm in height, and a wheelbase of 2680mm. In terms of exterior design, the Roewe i5 Linghao version features the Roewe family's rhythmic floating wing grille design, paired with rectangular headlight clusters, and a trapezoidal air intake below. The side profile adopts a dual waistline design, while the rear features a ducktail spoiler. The entire series comes with a limited-time free upgrade to LED headlights.
120
Share

What Causes the Ticking Sound in the Baojun 530 Engine at Idle?

Baojun 530 engine ticking sound at idle can be attributed to the following reasons: Valve Noise: After starting the engine, a "ticking" sound is heard, which is the sound of the valves. Especially when the engine is cold, this noise occurs because the oil pressure has not yet built up, and the valves are not properly lubricated. The sound should diminish after a short period. Insufficient Lubrication: Generally, during a cold start, the engine sound is slightly louder than when the engine is warm, as long as the sound is uniform and smooth, not harsh. This noise is caused by the gap between the cylinder wall and the piston not yet reaching the optimal size during cold conditions, along with insufficient lubrication from the engine oil. Typically, when the engine block temperature reaches around 95 degrees, the sound will return to normal. Engine Oil Issues: Poor-quality engine oil, prolonged intervals without oil changes, or low oil levels can all lead to increased friction between the valves and guides, as well as hydraulic lifters, resulting in louder engine noises.
103
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.