···
Log in / Register

Can a Blue License Plate Vehicle Switch Back to Blue After Changing to Green?

6Answers
VonKaylee
08/31/2025, 11:08:41 PM

Once a blue license plate is replaced with a green one, it cannot be switched back to blue. Differences between blue and green license plates: Blue and green license plates correspond to different vehicle types: Blue plates are for conventional fuel-powered vehicles, while green plates are for new energy vehicles. Green plates are used for pure electric vehicles and plug-in hybrid vehicles. There are two types of green license plates: one is gradient green, and the other is yellow-green dual-color. Gradient green plates are used for new energy passenger cars, while yellow-green dual-color plates are used for buses. Green license plates indicate new energy vehicles, and the number of digits on green plates has increased from 5 to 6. Only two letters are used on these plates: D and F. D stands for pure electric vehicles, and F stands for hybrid vehicles. Green and blue license plates use different technologies: Green license plates incorporate anti-counterfeiting technologies such as QR codes and anti-counterfeiting watermark patterns, which enhance the plates' anti-counterfeiting performance to some extent. With the continuous development of automotive production technology, new energy vehicles are gradually entering the automotive market, and consumer demand for new energy vehicles is increasing. Green license plates are more common in many large cities with license plate restrictions, reflecting the development trend of new energy vehicles. New energy vehicle plates in different regions also enjoy various privileges, such as exemption from traffic restrictions based on license plate numbers.

Was this review help?
110
Share
DelCarson
09/13/2025, 02:01:47 AM

Once you switch to a green license plate, it's basically impossible to change back to a blue one. Policy regulations tie the license plate to the vehicle's classification—green plates represent new energy vehicles like pure electric or plug-in hybrids. Once converted to a green plate, the car is registered as a new energy vehicle. To revert, the vehicle must be fully restored to pure fuel-powered status and undergo re-inspection, but the process is extremely cumbersome, requiring multi-department approvals and possibly incurring fines. I've seen friends try to switch back in real life, but authorities don't allow easy changes to avoid management chaos. Switching to a green plate has benefits, like exemption from purchase tax or urban parking perks—just adapt instead of stressing over reverting. If you absolutely must, the only option is selling the old car and buying a blue-plate vehicle, but that's costlier than keeping the green plate.

Was this review help?
19
Share
Expand All
SanDawson
10/27/2025, 02:48:34 AM

After switching from a blue license plate to a green one last year, my car saves money on charging and is more environmentally friendly. Why would I want to switch back to a blue plate? Essentially, changing the license plate locks in the vehicle's nature. Switching to a green plate means it's no longer a fuel-powered vehicle unless you completely remove the battery power system and reinstall an engine, but the police will check for violations. In practice, the probability of switching back is extremely low because the registration system update is irreversible. I suggest accepting it—driving with a green plate is more comfortable and has lower daily maintenance costs. Don’t worry about policy changes; perhaps future systems will allow interchangeability, but for now, it’s safer not to risk modifications.

Was this review help?
17
Share
Expand All
VonAlejandro
12/10/2025, 02:04:24 AM

After switching to a green license plate, both the engine and battery have been changed, making it impossible to simply revert to a blue license plate. Policy requirements stipulate that license plates must match the vehicle type: blue plates for fuel-powered vehicles and green plates for new energy vehicles. If you forcibly revert after the switch, there are significant risks associated with altering the engine structure, and it could easily be illegal. The conventional solution is to purchase a new vehicle and register it for a blue plate, but the cost is high and not worth it. It's better to directly enjoy the benefits of the green plate—it's more stable.

Was this review help?
1
Share
Expand All
AbigailAnn
01/30/2026, 03:13:35 AM

I personally support the new energy concept, switching to green license plates reduces exhaust emissions, which is good for the air. Urban commuting is quiet, charging is cheap, and it basically doesn't require fuel. Wanting to switch back to blue plates is practically difficult to operate because the license plate system is designed for one-way conversion, encouraging green development with no turning back. If you're determined to try, you must submit an application to the DMV proving the vehicle has been restored to its old state, but this is time-consuming, labor-intensive, and has a low success rate—why go through the hassle for just a plate? Focus on the present and drive your green-plated car; it's the modern trend, saving money and offering convenience.

Was this review help?
1
Share
Expand All
CoraDella
04/25/2026, 02:16:25 PM

After switching our car to a green license plate, driving has become smoother, parking is more convenient, and we've saved a lot on fuel costs—basically, we've adapted well. Switching back to a blue plate would theoretically require redoing the vehicle registration process, but it's complicated, involving re-inspection to prove compliance with fuel standards. In most cases, it's not feasible because the system locks the nature of the vehicle. In daily use, the green plate is great—quiet and easy to maintain. If you really want to switch, you'd have to buy a used blue-plate car, but it's better to stick with the current setup and enjoy the environmental benefits.

Was this review help?
3
Share
Expand All
More Q&A

What details should be paid attention to in the Subject 3 driving test?

Details to note in the Subject 3 driving test: During the Subject 3 test, candidates need to pay attention to the lighting assessment. Students must master the requirements for light usage, familiarize themselves with the test route in advance, avoid exceeding the specified speed limit, and ensure proper parking. Below are additional details: 1. Content of the Subject 3 driving test: The test includes road driving skills and safe civilized driving knowledge. Candidates can study the Subject 3 test content using simulation software on mobile or computer devices. During the test, no less than 20% of candidates will be selected for night driving tests. Even if not selected for the night test, candidates must undergo a simulated nighttime lighting test. Subject 3 is a crucial part of the motor vehicle driver's license examination, commonly known as the road driving test, and the content varies depending on the license level. 2. Important notes: Special attention must be paid when using turn signals. After activating the turn signal, candidates must wait for three seconds before making the turn. Forgetting to use turn signals during U-turns, turns, or lane changes will result in point deductions or immediate disqualification.
105
Share

Can Secondary Ignition After Water Immersion Be Detected?

Secondary ignition after a car has been submerged in water can be detected. Below is an introduction to how vehicle water immersion is inspected: 1. Secondary ignition: After a car is submerged in water, the starter motor will only reactivate if the engine stalls. At this point, if the starter motor does not respond, it is considered a secondary ignition. Secondary ignition refers to the situation where the car stalls underwater and the driver attempts to turn the key to ignite the engine again underwater. If the car has water immersion insurance, whether the claim can be made depends on whether secondary ignition was attempted—no ignition allows for a claim, while secondary ignition does not. 2. Damage extent: Typically, if a vehicle stalls in water, there is a 50% chance of engine damage. However, if the engine is restarted after stalling, the engine will almost certainly be "ruined." Therefore, whether driving or parked in a residential area, underground garage, or street, drivers must never attempt to restart the engine after stalling in water. 3. Insurance exclusions: Some insurance companies include secondary ignition after stalling in water as an exclusion clause in water immersion insurance. This means that if the car is submerged and the driver attempts to restart the engine, any resulting engine damage will not be covered by the insurance, even if water immersion insurance is in place.
103
Share

What is the range of the Junfeng e17?

The range of the Junfeng e17 is 310 kilometers. The Junfeng e17 is a pure electric vehicle. Taking the 2018 Junfeng e17 as an example, it belongs to the compact car category, with body dimensions of 4680mm in length, 1720mm in width, and 1545mm in height, and a wheelbase of 2700mm. The curb weight is 1500kg. The 2018 Junfeng e17 features a MacPherson strut front suspension and a torsion beam rear suspension. It is equipped with a permanent magnet motor, delivering a maximum power of 100kW and a maximum torque of 260Nm, paired with a single-speed fixed gear ratio transmission.
103
Share

Is Buying a Car at a Direct-Operated Store Reliable?

Purchasing a car at a direct-operated store also entitles you to the three guarantees and free first maintenance, with nationwide warranty coverage and all necessary documentation complete. However, vehicles at direct-operated stores may be sourced from other locations, offering price advantages compared to 4S stores. Below is an introduction to considerations when buying a car: 1. Choosing a Brand: For most people, selecting the right brand is crucial. Some may prefer Japanese cars, others German cars, domestic brands, or even less common Korean or French models. Each car series has its unique highlights, so it's important to find the brand that suits your preferences best. 2. Selecting a Model: Car models can be categorized into sedans, SUVs, MPVs, crossovers, hatchbacks, etc. Choose the model that best fits your personal needs and preferences. For instance, a compact and agile hatchback might be ideal for individual commuting, while families might opt for spacious SUVs, and families with two children could consider MPVs, often referred to as dad cars. 3. Setting a Budget: As cars are consumable goods, it's essential to select a model within your financial means. Additionally, purchasing a car involves expenses such as purchase tax, vehicle and vessel tax, insurance, and licensing fees. Therefore, it's crucial to consider the total on-road price of the vehicle to avoid budget shortfalls.
114
Share

How to Activate the Leiling Active Braking System?

Leiling's active braking system is automatically enabled by default. It can be accessed via the multifunction buttons on the left side of the steering wheel. The active braking has certain conditions—it must be directly in front of the vehicle, and sudden lane-cutting by other vehicles may not trigger it. However, in practical use, it is highly effective in preventing accidents caused by driver distraction on highways. The working principle of the active braking system is as follows: 1. Accident Prevention: The system uses an optical radar system mounted on the front windshield to monitor the road ahead, particularly within six meters. Upon detecting obstacles, it initiates steering adjustments or braking to prevent accidents. However, current technology is not yet fully mature, and numerous test cases indicate that it may not always succeed in bringing the vehicle to a complete stop under certain conditions. Nevertheless, as an auxiliary system, it effectively alerts drivers to pay attention to road conditions ahead. 2. Autonomous Driving Function: The new Leiling achieves Level 2 autonomous driving capabilities through the integration of DRCC, PCS, and LTA systems, making driving safer and more relaxed. The PCS pre-collision system can accurately identify vehicles, pedestrians, and cyclists moving at speeds exceeding 10 km/h during daytime. In emergencies such as sudden pedestrian intrusion, unexpected road hazards on highways, or situations where braking is delayed, the system will sound an alarm and automatically bring the vehicle to a stable stop, minimizing the risk of collisions.
109
Share

What is the method for repairing small dents?

The method for repairing small dents is: 1. Rinse the dented area clean with water; 2. Wet the paint repair sponge with water and wipe away any residue left by collisions on the car body; 3. Use a suction cup hook to attach to the center of the dent and pull outward with moderate force; 4. Continuously change the position of the suction cup on the dent until the dent returns to normal. Causes of small dents on cars: 1. Impact from small stones, objects, or falling objects from heights; 2. Opening the car door and hitting external objects; 3. Friction with other vehicles or roadside objects during driving; 4. Accidents involving the vehicle.
104
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.