To connect your Champion 102007 Automatic Transfer Switch with Axis Controller Module to Wi-Fi for remote monitoring and control, follow these steps. First, use a Wi-Fi-enabled device, like a laptop, smartphone, or tablet, near the ATS. Then, search for and connect to the network named "Champion XXXX," where "XXXX" matches the last four digits of your ATS's serial number, found on the control board. The Wi-Fi password is on a decal on the dead front of the ATS. After connecting, open a web browser on your device. The Champion Axis Controller Home Standby Generator Settings Page should load automatically. If it doesn't, refresh the browser or try entering any web address, such as anything.com. The ATS's Wi-Fi module should redirect your browser to the settings page. Next, set the date and time using the dropdown boxes or by clicking the "USE THIS DEVICE'S DATE & TIME" button and save the settings. After that, set your Home Standby Generator's exercise frequency and schedule, then confirm and save those settings. You typically do not need to adjust the wireless network settings; the default values should work. Finally, once you have set up the time, date, and exercise information, you can close your browser and disconnect from the Wi-Fi network. If your web browser fails to load the Champion Axis Controller Home Standby Generator Settings Page and stays connected to the internet, turn off mobile data on your device, if applicable, and make sure you're not connected to any other networks. Wait a couple of minutes and then try connecting with the web browser again. Following these steps should help you successfully connect the Wi-Fi on your Champion 102007 Automatic Transfer Switch with Axis Controller Module for remote monitoring and control.
