How do I set the address for my STRI-M Addressable Interface Module?

[DeBentley]

To program the address for your STRI-M Addressable Interface Module, follow these steps: First, identify the red and black FDLC loop circuit wires on the STRI-M, as shown in the diagrams. Next, connect the Addressable Loop Driver circuit wires of the STRI-M to the Model SDPU Programmer/Tester. Use the cable and the alligator clip to banana plug adapters that came with the Programmer/Tester. Before connecting, make sure all field wiring is disconnected from the red and black FDLC loop circuit wires of the STRI-M to protect the SDPU. It's important to note that the connection between the SDPU and the STRI-M isn't polarity-sensitive. Refer to the diagrams for proper connections to the control panel and use the instructions in the SDPU Programmer/Tester Manual (P/N 315-033260C) to program the desired address into the STRI-M. Be sure to record the device address on the label located on the STRI-M. Once the address is set, you can install the STRI-M and wire it to the system for operation. This process ensures the STRI-M Addressable Interface Module correctly integrates with your FS-250C System, enabling effective monitoring and reporting.