How can I pair a transmitter with the receiver in my EMX WEL-200 Wireless Edge Link system?

[VanHazel]

Pairing a transmitter with the receiver in your EMX WEL-200 Wireless Edge Link system is straightforward. Here's a step-by-step guide:

1. Mounting the Transmitter: Securely install the transmitter close to your edge sensor using the provided mounting hardware. Ensure the sealing nut is positioned downwards to prevent water damage.
2. Connecting the Edge Sensor Wires: Connect the wires from your resistor-equipped edge sensor to the transmitter's terminal block. Verify that the edge sensor has a resistance within the range of 4K to 12K ohms.
3. Installing Batteries: Insert two AA lithium batteries into the transmitter. The LED on the transmitter should blink twice rapidly every two seconds, indicating it's powered on.
4. Initiating the Pairing Process: Press and hold the connection button on the transmitter for 1-2 seconds, until the LED stops flashing quickly. A successful connection is indicated by the LED flashing once every four seconds. If the transmitter fails to connect, the LED will blink twice rapidly every two seconds; in this case, repeat the pairing process.
5. Testing the Connection: Without activating the edge sensor, check the channel LEDs on the receiver. They should be off for any channel linked to a transmitter. Now, activate the edge sensor you are testing. The corresponding channel LED on the receiver should illuminate, and the LED on the transmitter should flash twice per second while the edge sensor is active.
6. Pairing Additional Transmitters: To add more transmitters, simply repeat steps 1-5 for each additional unit. Remember, it's crucial to connect only one edge sensor to a single transmitter.

If you experience any difficulties during the pairing process, consult the troubleshooting section in your manual or contact EMX Industries, Inc.'s technical support for further assistance.