How do I properly install the VYNCO INSV0137 2S1IP 2S2IP Standard Switches 250V?

[LaWeston]

To ensure correct installation of your VYNCO INSV0137 2S1IP 2S2IP Standard Switches 250V, follow these steps as outlined in the instruction manual:

1. Mounting Orientation: These switches must be mounted vertically. Horizontal mounting is not advised.
2. Surface Preparation: The wall surface must be smooth and flat. The hole cut should not exceed the switch sub-plate seal perimeter.
3. Remove Cap Bungs: Use side cutters to remove the cap bungs from the sub-plate seal. Save these for later use.
4. Wiring: Wire the switch according to the AS/NZS 3000 Wiring Rules. Adhere to proper wiring procedures for safety and functionality.
5. Securing the Switch: Secure the switch to the wall, applying a torque of 1.3Nm to each screw. This applies to both flush box and solid wall mounting. Piercing the seal flange is acceptable and recommended for solid wall installations.
6. Seal Bung and Cover Plate Installation: Insert the seal bungs into the flush box holes, and then securely fit the cover plate. By following these steps, you can safely and effectively install your VYNCO INSV0137 2S1IP 2S2IP Standard Switches 250V.