Programming your Automatic Technology FHCRX-1 Multi-Frequency Receiver for your garage door involves a few straightforward steps. Here's a guide:
-
Setting Transmitter Type: You must first set the memory location for either ATA TrioCodeTM or BND Tri-TranTM transmitters, determining which type the receiver will accept.
-
Storing Transmitter Codes:
- On the receiver board, press and hold either SW1 (for Relay 1) or SW2 (for Relay 2). The LED will begin to flash.
- Press the button on your transmitter that you wish to use for two seconds. The LED will flash more rapidly.
- Release the transmitter button, pause for two seconds, and then press the same button again for two seconds. The LED will stay on for a second before turning off.
- Release the SW button.
- Test the operation by pressing the transmitter button; the garage door should now respond.
-
Deleting a Single Transmitter's Code:
- Press and hold SW1 or SW2 on the receiver board. The LED will flash.
- Press the transmitter button you want to remove for two seconds. The LED will flash faster.
- Release the transmitter button, wait two seconds, and press it again for two seconds. The LED will slowly flash twice.
- Release the SW button.
- Confirm the deletion by pressing the transmitter button; the garage door should not respond.
-
Deleting All Stored Transmitter Codes:
- Disconnect the power to the receiver.
- Press and hold the SW1 button.
- While holding SW1, restore power to the receiver. After 15 seconds, the Coding LED will illuminate, indicating the memory has been cleared.
- Release SW1. All codes are now deleted. Verify by pressing the transmitters previously used.
