How do I pair my REELY 2632377 GY4 remote controller with its receiver?

[DeAsher]

Pairing your REELY 2632377 GY4 2.4GHz 4 Channel Pistol Grip remote controller with its receiver can be achieved by following these steps:

1. Prepare for Pairing:

   • Ensure the Electronic Parameter Adjustment (EPA) setting for the drive function is at its maximum for both forward and reverse.
   • Turn the “TH-D/R” and the “GYRO LV / ST-D/R” fully clockwise.

2. Initiate Pairing:

   • Disconnect the receiver from the power source, and turn off your model vehicle.
   • Turn off the transmitter.
   • Position the receiver horizontally and secure it.
   • Press and hold the “BIND” button on the transmitter, then turn the transmitter on. The LEDs will display a running light sequence. Release the “BIND” button.

3. Complete Pairing:

   • Reconnect the receiver to the power source.
   • The receiver LED will flash several times and then illuminate steadily after a few seconds, indicating calibration mode.
   • Calibrate extreme throttle and steering positions:
     • Move the throttle to full forward, then return to neutral.
     • Move the throttle to full reverse, then return to neutral.
     • Turn the steering wheel fully left, then return to center.
     • Turn the steering wheel fully right, then return to center.
   • The transmitter LED will flash three times, then stay on constantly.
   • Test vehicle functions to confirm responsiveness to transmitter commands.
   • Enable or disable the gyro function as required.
   • Disconnect the receiver from the power source and switch off your model vehicle.
   • Turn off the transmitter.
   • Replace the receiver in the vehicle, ensuring it's horizontal.
   • Turn on the transmitter and operate the vehicle.

Following these steps will guide you through the process of successfully pairing your REELY 2632377 GY4 remote controller with its receiver.