Installing the Siemens VersiCharge 95 Inch Post and Integrated Retraction Systems involves several steps, and safety should always be your top priority. Here’s a general guide; always consult the official Siemens VersiCharge installation manual for detailed instructions and local electrical code compliance.
-
Site Preparation:
- Verify you have the necessary permits for EV charger installation.
- Prepare a concrete or composite base with a centered conduit stub-up.
- Consider adding protective measures like bollards to safeguard the charger.
-
Pedestal Mounting:
- Position the pedestal assembly on the concrete base.
- Mark and drill the mounting holes.
- Clean the holes and install drop-in anchors.
- Route the power and communication wires through the pedestal's raceway.
-
Wiring and Connections:
- Run power and communication wires in separate conduits to avoid interference.
- Attach conduit connectors and feed wires through the raceway.
- Connect the power wires (L1, L2, and GND) and communication wires to the VersiCharge charger(s) according to the wiring diagrams.
-
Charger Installation:
- Mount the charger(s) onto the provided plastic bracket(s).
- Connect the power and communication wires to the charger(s) as shown in the diagrams.
- Secure the charger(s) with the Security-Torx bolt provided.
-
Cable Management:
- Secure the charging cable using the provided cable clamp.
- Install the lower cable holder or holster.
- For dual cable systems, repeat the cable management steps on the opposite side.
-
Final Steps:
- Install the front cover plate for dual post installations.
- Turn on the power to the charging station(s) and perform testing, as directed by the VersiCharge installation manual.
For any challenges during the installation process, or to ensure complete understanding of the steps involved, please refer to the official Siemens VersiCharge documentation. If further assistance is needed, Siemens Customer Service is available to help.
