
Installing your Right Weigh PP-003-0061 Onboard Load Scale is straightforward. While the comprehensive instructions reside within the user manual, here's a general overview to get you started: First, install the strain sensors according to the installation kit manual's guidelines. Next, choose a mounting location for the scale that is accessible and protected from potential damage, avoiding direct chassis or main beam mounting unless approved. Then, install the connection harness using the instructions in the manual. Once the gauge is powered, it will display "bAr -". Use the UP arrow button to set the gauge to the number of strain sensors connected. Your vehicle configuration dictates the operating mode; consult the manual's tables and set the gauge accordingly. After installation, check and adjust sensor values as needed, accessing the diagnostics menu via the manual's steps. Calibration is crucial; calibrate the load scale both empty and loaded for each axle group, following the manual's instructions. Optionally, you can set a PIN. Finally, use the manual's steps to properly weigh your vehicle. For detailed instructions, always refer to the complete user manual that accompanies your Right Weigh PP-003-0061 Onboard Load Scale.


