Installing the Intelligent KB300 Surface-Mounted Baby Changing Station is straightforward. Here's a step-by-step guide:
- Inspect the unit upon arrival for any shipping damage. If you find any, contact customer service immediately.
- Choose the ideal installation location, keeping in mind accessibility and clearance when the unit is open. Make sure to have enough space on both sides of the unit and from the wall.
- Prepare for installation by removing the changing bed and chassis from the box. Open the main unit to remove the plastic liner dispenser.
- For Wood Stud Walls:
- Measure and mark the wall at 16-inch stud centers for mounting holes.
- Drill pilot holes suitable for keyhole mounting.
- If studs aren't on 16-inch centers, use toggles.
- For Masonry or Tile over Stud Walls:
- Use a masonry drill bit for pilot holes until you reach the stud. Then switch to a regular drill bit.
- For Metal Stud or Concrete Block Walls:
- Secure one side of the unit with toggles.
- Mount the Bed and Chassis:
- Insert the mounting screws into the pilot holes, leaving approximately 1/4 inch exposed.
- Position the chassis over the screws, securing it using the keyhole slots.
- Verify the unit is level and tighten the screws.
- Complete the installation by marking and drilling pilot holes for the lower screws. Then, use the remaining screws and washers to fully secure the unit.
- Install the Liner Dispenser. Ensure the dispenser is undamaged. Align the mounting holes on the chassis and secure with the provided screws. Close and lock the dispenser door.
- Final Checks. Clean up the work area and ensure the Intelligent KB300 changing station opens and closes smoothly.
For detailed diagrams and extra information, always refer to the complete instruction manual provided with your Koala Kare Products Intelligent KB300 Surface-Mounted Baby Changing Station.
